Pfaff 3568 1 12 2 12 - SEMSI
240
Pfaff 3568 1 12 Pfaff 3568 2 12
Transcript of Pfaff 3568 1 12 2 12 - SEMSI
Pfaff 3568 1 12Pfaff 3568 2 12
default
Puller complete for a 3568-2/12is 95-730 821-71/835. Additional parts required are (1) 95-745 598--bearing pin (1) 95-645 599--bracket (1) 95-745 597--plate (4) 11-225 902--screws (2) 11-130 287--screws
default
Cover screw 11-210 078-15 is a M3 x 5 MM. countersunk slotted screw
default
X1 plug numbers 71-160 001-93 plug box mounted on the machine. 71-160 003-78 connector inside the box 71-160 001-55 plug box mounted on the folder 71-160 003-79 connector inside the box 91-093 860-91 cable complete with connector on the folder side. YSL-J21x0.34 (length 3700 mm)
default
For repair of the transfer motor, call Keith Thompson @ Blue Ridge Electric Service 1604 S. Loudoun Street Winchester, VA 22601 Phone (540) 662-8463 Toll free (877) 662-8463
default
X1 plug numbers 71-160 001-93 plug box mounted on the machine. 71-160 003-78 connector inside the box 71-160 001-55 plug box mounted on the folder 71-160 003-79 connector inside the box 91-093 860-91 cable complete with connector on the folder side. YSL-J21x0.34 (length 3700 mm)
default
Wire harness to connect the operator panel to the A3 board (91-094 127-71
default
Part number 91-167 160-91 is for a needle bar stroke of 37mmm. The measurement from center to center is 18.5 mm. 95-629 710-91 is for a needle bar stroke of 33mm. The measurement from center to center is 16.5 mm
default
See note to the right
