BUILDING A PACEMAKER

In Second Life

PACEMAKER

1) In the Build menu on

the top navigation bar,

select Build or Ctrl + B.

2) On the pop-up

window, select Create.

3) Select the sphere prim

and click on the ground. Figure 3.1

PACEMAKER

4) Change the

properties of the sphere

shown in Figure 3.2.

Figure 3.2

PACEMAKER

5) Upload the texture shown in Figure 3.3 that can

be obtained from

http://community.seas.columbia.edu/cslp/resources/s

pring07/Brushed%20Metal.jpg

into your inventory on Second Life.

6) Click on the Texture box. Double-click My

Inventory>Textures and select metalpace.

7) Click the drop-down menu that says “Shininess”

and set it to low.

PACEMAKER

Figure 3.3

LEADS HOLDER

1) Press Ctrl + B and

select Hemisphere.

2) Set the values shown

in Figure 3.4 except for

its position.

Figure 3.4

LEADS HOLDER

3) Change the color to black and set the shininess to

high shown in Figure 3.5.

4) Click on the box above Texture and select

Buildings>MetalGrate shown in Figure 3.5.

LEADS HOLDER

Figure 3.5

LEADS HOLDER

5) Position the

hemisphere on top of

the pacemaker on the

left side.

6) Press the Shift key

and left click the two

pieces. Then, press Ctrl

+ L.Figure 3.6

LEADS

3) Press Ctrl + B and create a

torus.

4) Set its size as shown in

Figure 3.7.

Figure 3.7

LEADS

3) Click the drop-down menu that reads “Shininess” and set it to

low shown in Figure 3.8.

4) Upload the texture shown in Figure 3.3 that can be obtained

from

http://us.123rf.com/400wm/400/400/ssuaphoto/ssuaphoto0911/ssu

aphoto091100021/5881761-shining-metal-texture-figure-of-corrug

ated-glazed-background.jpg

into your inventory on Second Life.

5) Click the texture box and double-click My Inventory>Textures

and select the texture named “shinybluetexturemetal” shown in

Figure 3.8.

LEADS

Figure 3.86) On the selected lead, press Ctrl + D to make a copy.7) Drag the copied lead and place it next to the first lead.8) Press the Shift key and left click both leads. Rotate them into an upward position.

LEADS

9) Place the two leads on top of

the leads holder as shown in

Figure 3.9.

10) Press the Shift key and left

click the pieces. Press Ctrl + L.

Figure 3.9

LEADS

11) To make the curving, create a cylinder.

Refer back to Figure 3.7 for measurements.

12) Click on the Features tab and click

Flexible Path. Insert the values shown in

Figure 3.10.

13) Set the same texture as Figure 3.8.

14) Position the curvy leads close to the

leads.

15) Press the Shift key and click on the

pieces. Then, press Ctrl + L. Figure 3.10

LEADS

15) Rotate the entire figure as shown in Figure 3.11.

Figure 3.11