Ornament Demo
description
Transcript of Ornament Demo
Ornament DemoBy Janice Levi and Bill Berry
Gulf Coast Woodturners Association
November 2011
Finial Procedure Overview
By Janice Levi
Ball Procedure OverviewBy Bill Berry
4 3/4”
Part In
Part Off
Make small indention with Skew
1 – 3/8”
1 -5/8”
Drill ¼” Hole 1” Deep
Hollow with 1” Round
Nose Scraper
Measure Inside With
“Template”
Instructions for making Template
(2) Wooden Tongue Depressors (Hobby Lobby)(1) Steel Washer 1-3/8” ODHot Glue Gun
1- 3/8” OD Steel Washer
Hot Glue Steel Washer to
Tongue Depressor
Layout 8 holes with
awl on outside line
Nice Work Bill, Now drill
them…
Drill 8 holes ½” deep with 3/32”
drill bit
Repeat the procedure on the other half.
Then glue halves together.
Align Grain and Glue Halves
Together.
1-3/8”
ID
Turn ball round maintaining consistent wall thickness
Rough Shape and Part Off
Use ¼” Tenon to Friction drive ball
Rotate ball between centers to Finalize Shape
1 / 4” to 3/8”
Turn grooves in ball with skew or three point tool.
Darken Grooves