Origin of “Drag” Folds Bordering Salt Diapirs
description
Transcript of Origin of “Drag” Folds Bordering Salt Diapirs
Origin of “Drag” FoldsOrigin of “Drag” FoldsBordering Salt DiapirsBordering Salt Diapirs
D. D. Schultz-ElaD. D. Schultz-ElaBureau of Economic GeologyBureau of Economic Geology
John A. and Katherine G. Jackson School of GeosciencesThe University of Texas at Austin
AGL - 2002AGL - 2002 QAd355
Applied Geodynamics Laboratory
Industrial Associates
Amerada Hess Corporation
Anadarko Petroleum Corporation
BHP Petroleum (Americas)
BP Amoco Production
Burlington Resources
Chevron USA Production
Conoco
ENI - AGIP
Enterprise Oil
Exxon Mobil
Marathon Oil Company
PanCanadian Petroleum
Petroleo Brasileiro
Phillips Petroleum Company
TotalFinaElf
Woodside
Bureau of Economic Geology
AGL - 2002AGL - 2002 QAd355
MOTIVATIONMOTIVATION
(after Davison et al., 2000)
Drag folds
Withdrawal folds
Contraction folds
Modeling of:
Not:
AGL - 2002AGL - 2002 QAd355
PREKINEMATIC MODEL
Model simulates cross section through an existing salt wall. Geometry and density contrast favor vigorous salt rise . Passive lines track displacements. Salt is eroded back to overburden elevation during rise.
Sym
met
ry li
ne
Symmetry line
AGL - 2002AGL - 2002 QAd355
STRONG OVERBURDENSTRONG OVERBURDEN
“Strong” overburden: no pore pressure, normal friction angle (31°), low cohesion (0.1 MPa). Relatively rigid subsidence and tilting. Deformation only at top corner; diapir spreads near surface. Dashed lines show original overburden position and restored salt surface.
Vertical displacement t = 266 kaMax: -173 m
Min: -275 m
Insignificantuplift
Current top saltrestored to t=0
Salt
Overburden
AGL - 2002AGL - 2002 QAd355
OVERPRESSURED OVERBURDENOVERPRESSURED OVERBURDEN
Pore pressure/Total pressure () = 0.9.
More drag deformation:
• Deformed zone wider and deeper.
• More spread of diapir top.
But only minor folding, even with extremely weak rock.
Vertical displacement
t = 132 ka
-100 m
-200 m
Minor localuplift
Overburden = 0.9
AGL - 2002AGL - 2002 QAd355
OVERPRESSURED OVERBURDEN, SALT LAYERSOVERPRESSURED OVERBURDEN, SALT LAYERS
Vertical displacementt = 170 ka
200 m
-350 m
Overburden = 0.9
Highly overpressured overburden (=0.9) alternating with salt layers.
Substantial folding.
Folding increases upward.
More lateral, not vertical, deformation near surface .
Highly overpressured overburden requires very weak interbeds to drag fold across wide zone.
Weaksaltlayers
AGL - 2002AGL - 2002 QAd355
Smooth-walled diapir for comparison.
IRREGULAR DIAPIR SHAPEIRREGULAR DIAPIR SHAPE
Vertical displacement
t = 245 ka200 m
Significant drag folding of overburden protrusions.
Most folding near top surface.
Uplift above regional.
-200 mIrregular initialsalt
contact
AGL - 2002AGL - 2002 QAd355
TILTED DIAPIR, OVERPRESSURED OVERBURDENTILTED DIAPIR, OVERPRESSURED OVERBURDEN
Vertical displacement
t = 283 ka
Diapir spreads near surface, shallow folding in very weakest overburden
Footwall uplift at base
Protrusions tend to fold, especially if shallow
? Folding increases upward, unlike observed “drag” folds
300 m
-350 m
15° diapir tilt
Hang
ingw
all
Foot
wal
l
Overburden = 0.9
AGL - 2002AGL - 2002 QAd355
2° slopeOverburden = 0
Overburden density increases following normal shale compaction curve. Strong rock, 60 25-m-thick layers (groups of 4 shown), 1 mm a-1 aggradation. Salt flow driven by overburden relief, slope break always located 3 km from left boundary
(vertical dashed line). Emergent salt eroded until layer 56. Thick source layer – no effects of limited salt supply.
Slopebreak
25-m-thick layer
First layer
Second layer2° slope DepositErode
1 km3 km
Salt
Salt
SYNKINEMATIC, INCREASING DENSITYSYNKINEMATIC, INCREASING DENSITY
AGL - 2002AGL - 2002 QAd355
SYNKINEMATIC, INCREASING DENSITYSYNKINEMATIC, INCREASING DENSITY
Older layers onlap far, create long, gently tapered wedges.
• Easily folded by salt rise, “drape” folds. Younger layers onlap steeper salt contact, create short thick wedges.
• Narrower folds, older folds static. Strength proportional to thickness, so older layers form broad, high-amplitude folds.
500 m
1000 m
Long onlap onto rising salt crest
Decreasing onlap;onto preceding layer
AGL - 2002AGL - 2002 QAd355
SYNKINEMATIC, INCREASING DENSITYSYNKINEMATIC, INCREASING DENSITY
Salt contact steepens to vertical, then is overturned.
Width of folded zone narrows.
Diapir would spread next; no onlapping flap to fold.
Most folding ends.
Diapir crest rolls upward against sediment, stretches even as crest narrows.
Crest would stretch and disaggregate any cover, slumping of steep parts.
1500 mNarrow and shallowzone of folding
AGL - 2002AGL - 2002 QAd355
SYNKINEMATIC, PULSED DEPOSITIONSYNKINEMATIC, PULSED DEPOSITIONSheath < 2 m, eroded
50-m every sixth layer starting at layer 41; same average aggradation rate (twice the thickness, twice the rise time).
First thick layer (green) stretches upward into sheath, blocks onlap of later layers.
Sediment pulses create long thin flaps easily carried upward with salt.
AGL - 2002AGL - 2002 QAd355
SYNKINEMATIC, THICK LAYERSSYNKINEMATIC, THICK LAYERS
Strong rock, 18 100-m-thick layers, 1-mm a-1 aggradation.
Thicker layers onlapped farther; oldest layers had long thin tapers.
Slope break at 5 km, longer model.
No salt erosion less onlap, steeper diapir walls.
Horizontal2° slopeSlopebreak
Overburden = 0
AGL - 2002AGL - 2002 QAd355
SYNKINEMATIC, THICK LAYERSSYNKINEMATIC, THICK LAYERS
Bulge in early wedge forms crane’s head, blocks later progradation. Latest layers contract horizontally as diapir spreads. Shortened layers adjacent to greatly thinned and stretched uplifted layers.
Stretched and thinned older layersContracted youngest layers
AGL - 2002AGL - 2002 QAd355
Very weak overburden Strong overburden
SYNKINEMATIC, VERY WEAK LAYERSSYNKINEMATIC, VERY WEAK LAYERS
Very weak overburden develops patterns similar to model having strong overburden, except:
• Wider folded zone.
• More horizontal stretching of overburden as salt flows toward diapir: more tectonic thinning of wedge, early layers carried higher.
AGL - 2002AGL - 2002 QAd355
SYNKINEMATIC SEDIMENTATIONSYNKINEMATIC SEDIMENTATION
(after Johnson & Bredeson, 1971)
Maximum drag folding where sediment onlapped farthest across salt:
• salt rise aggradation rate
• sediment pulse (sand prone?)
• beneath depositional hiatus (more rise)
AGL - 2002AGL - 2002 QAd355
True drag folding of prekinematic overburden into wide drag zones only possible in highly overpressured, anisotropic sedimentary rock.
CONCLUSIONSCONCLUSIONS
Zones of increased folding onlaps over or protrusions into salt.
Maximum folding near free top surface —overburden rotates upward and outward as diapir spreads.
AGL - 2002AGL - 2002 QAd355
CONCLUSIONSCONCLUSIONS
Synkinematic sedimentation onlapping a narrowing diapir continually adds new shallow layers greatest potential for folding.
“Drag” folding most likely by synkinematic sedimentation during downbuilding; shear from salt drag has much less effect. Flap folds possible even in strong rock.
AGL - 2002AGL - 2002 QAd355
Flap folds decrease in width and amplitude upward as diapir steepens.
CONCLUSIONSCONCLUSIONS
Drag folds in prekinematic strata increase in width and amplitude upward.
AGL - 2002AGL - 2002 QAd355
Increased net aggradation rate: onlap , salt rise , burial.
Decreased net aggradation rate: onlap , salt rise , spread.
Equal rates: thick layers onlap farther and have more uplift time.
Vigorous salt rise may decrease folding potential.
Folding most likely for episodic or variable deposition rates.
Depositional hiatus increases time for folding of underlying layers.
CONCLUSIONSCONCLUSIONS
AGL - 2002AGL - 2002 QAd355
CONCLUSIONSCONCLUSIONS
Models may show just one instance of a commonly cyclical process.
Cyclical variations in rates of salt rise and sediment deposition could form a series of stacked flap folds separated by salt flanges or slumps that record times of salt spreading and possible overturning of underlying slumped and stretched flaps.
• Unconformity-bounded packages, called halokinetic sequences by Giles and Lawton (2002), observed in La Popa Basin diapirs, Mexico
?