OPERATING MANUAL FOR ELECTRONICDIGITAL BOARD

INSTALL BATTERY

1. Please slide the battery housing cover to the right to open.2. Load the battery (1.5V AA alkaline, 4 pcs)3. Close the battery housing cover.

HOW TO OPEN THE SAFE

Factory code: 1 2 31. Press (*), Red Light is ON2. Enter Factory Code ( 1 2 3 )3. Press ( # ), Blue Light is ON with melody4. Turn a Key (or pull down a Handle) within 3 seconds to open the door

Batterycover

Led Light

Key Lock

KSG: 4500:2006ISO 9001:2008

www.salvadosafe.com

HOW TO CHANGE THE SECURITY CODE (Available min 3 Digits max 15 Digits)

During enter New Security code; the door must be open until the code registered successfully.Find (M) button on the back of the door

1. Press (M) Button, the lock sound (BEEP) and (Blue Light is ON)

2. Within 3 seconds press a new security code ex: 1 2 3 4

3. Press (#), Melody rings and (Blue Light turn OFF)Then you have registered your code successfully.

• While keeping the Door open retype your code more than once to make sure that your New Security Code entered completely

Before closing the Safe Door

• Test your new security code (do not close the door)(*) new security code registered (#) ex: (*) 1234 (#)- If (Blue Light is ON), you changed a security code successfully.- If (Red Light is ON), you failed to change a security code. Please try to change it according to the above No. 1~3.

SLEEPING MODE

In case that wrong code entered, beep sound is ON If the wrong code tried over 3 times, Red Light Is ON the lock gets paralyzed and doesn’t work for three (3) minutes; RED Light will turn OFF, after 3 minutes if you press the correct security code it will operate well.

HOW TO CHANGE THE BATTERY

>> If the Blue Light is blinking with sound when you press (*)It is the time to replace the Battery.>> 1.5v X 4 pcs of alkaline battery

Thank You For Your Choice