Offseting Between Vendor and Customer Balance via F110

8/11/2019 Offseting Between Vendor and Customer Balance via F110

1/7

Generated by Jive on 2014-08-25+02:00

1

Offseting between vendor and customerbalance via F110

Purpose

If a vendor is also a customer, from the perspective of making vendor payment, it is possible to offset the

outgoing payment amount from the existing amount owed to the customer when running the F110 - Automatic

Payment Run.

Prerequisite settings in vendor/customer master

Vendor Master

1 Input Customer Information in Vendor Master

1. The customer number is used by the payment and dunning programs for clearing open items. For line

item display, the link to the customer line items is established using this number.

If you require clearing between the customer and vendor, the following requirements must be met:

- The customer number must have been entered in the corresponding vendor master record. - The vendor number must have been entered in the corresponding customer master record which we will

do in the next step.

- The fields "Clrg with vend." or "Clrg with cust." must have been selected in both master records.

2. For clearing with customer setting, the screen is as shown below. As for clearing with vendor setting will

cover in next step.


2/7

Offseting between vendor and customer balance via F110


2

When you try to activate the Clrg with cust. Indicator, SAP displays the follow message where

the clearing account 10201734 is the customer number.

Customer master

2 Input Vendor Information in Customer Master

1. Specifies an alphanumeric key that uniquely identifies the vendor or creditor in the SAP system.

2. Then turn on the Clearing with vendor indicator in order to complete the settings in

respective master in order to allow clearing with customer during

automatic payment process.
http://scn.sap.com/servlet/JiveServlet/showImage/102-56485-1-493236/pastedImage_35.png


3/7



3

Clearing between vendor and customer via F110

1 Analyse Vendor and Customer Balance

1. Analyse the open item balance for vendor, that the total amount outstanding on vendor side mustbe greater than the balance outstanding on customer side. This is required in order for clearing withcustomer to work.

Vendor Open item


4/7



4

Please take note, the item with debit balance where the document number is 620004610 as shown above,

should be excluded from automatic payment in the parameter set up (shown in next step) as SAP throws out

error during payment run.

2. Check the outstanding balance on the customer side where the amount is 2,200 very much less than the

vendor outstanding amount.

Customer Open Item


5/7



5

3. Together with the settings both in vendor and customer master we discussed previously being fulfilled

then we can proceed to next step for payment settlement between the vendor and customer.

2 Automatic Payment Settings and Payment Run

1. In the F110 (Automatic Outgoing Payment) parameter settings as shown below, both vendor and

customer must be input in order to do offsetting payment between a vendor and customer. Both vendor

and customer numbers must be entered besides other settings.

2. The result of payment proposal list shows the amount details of all open items from vendor and

corresponding customer highlighted in red colour box.


6/7



6

3. Display payment proposal job log

4. Display payment job log


7/7



7

5. Actual document posted

Offseting Between Vendor and Customer Balance via F110

Documents

Transcript of Offseting Between Vendor and Customer Balance via F110