My Internship at Saudi Aramco Company416264756c6c616820… · My Internship at Saudi Aramco Company...
Transcript of My Internship at Saudi Aramco Company416264756c6c616820… · My Internship at Saudi Aramco Company...
My Internship at Saudi Aramco Company
Department of Mechanical Engineering
Period
[16/06/2012 - 10/08/2012]
Submitted by:
Abdullah Yousef Al Rajeh
200700734
Dr. Omar Ouda
Outline
• Introduction
• About Saudi Aramco
• Activities and responsibilities
• The Heat Exchanger
• The Centrifugal Pump
• Steam turbine
• Conclusion
Introduction
• I am an employee in the company with 10 years of experience.
• My internship involves a rotation assignment that starts with work for the maintenance group in Abqaiq plant, then, for the Test and Inspection unit, after that, to work in maintenance shop in AL Qurryah.
• I gain in each place a unique experience and skills.
About Saudi Aramco
• Aramco (Arabian American Oil Company) began in 1930
• After 5 years of exploration, oil was discovered in Dhahran area “Dammam Well # 7”
• A world leader in exploration, production, refining, distribution, shipping and marketing
• the world’s largest proven crude oil reserves of 260.1 billion barrels
• the world’s fourth-largest gas reserves, with 279 trillion cubic feet.
Activities and responsibilities
Week Work PerformedSupervisor's Signature and
Comment
1 Safety Orientation Done
2
Take heat exchanger out and
send it to service company to
check it
In progress
SAFETY ORIENTATION
• All personnel, new hires, contractors and visitors must read the following safety information and understand their responsibility to demonstrate safe working habits in all job assignments.
• EMERGENCY PROCEDURES: (Exits and escape plans, Fire extinguishers …)
• PHYSICAL DEMANDS: (Lifting, carrying, and bending, Protection from falls, Sitting or standing for long periods …)
• ELECTRICAL SAFETY
• OFFICE HAZARDS
The Heat Exchanger
Week Work PerformedSupervisor's Signature and
Comment
3
Received heat exchanger and
test it then return it to its tube
channel
Done
4Take impeller out of the
Centrifugal pump case and sealIn progress
The Centrifugal Pump
Week Work PerformedSupervisor's Signature
and Comment
5
Change the seal and make
new pen then return it to its
case
Done
6
take turbine out of the case
then send it to maintenance
shop
In progress
7Change the blades and test
itIn progress
8 Return the turbine to its
case
Done
Steam turbine
Conclusion
• New knowledge or skill as a result of this
internship:
– Improve my communicating skills.
– Implement the theoretical part into practical.
– Have a better knowledge regarding Aramco
standers.
• The period needs to be extended. But overall
it is very successful and helpful for the
graduate students.
Questions