Mold & algae problem solved

10
® Mold & algae formation due to condensation 1 st assessment - December 2015

Transcript of Mold & algae problem solved

Page 1: Mold & algae problem solved

®

Mold & algae formation due to condensation

1st assessment - December 2015

Page 2: Mold & algae problem solved

®

1st assessment - December 2015Water vapour from the air was also dripping due to condensation

Page 3: Mold & algae problem solved

®

2nd assessment - March 2016After a repainting job the mold is already reappearing on the wall

Page 4: Mold & algae problem solved

®

Removal of the existing vapour sealant coating

Retrofitting process

Page 5: Mold & algae problem solved

®

Mold & algae founded behind the skim coat and previous several paint layers

Retrofitting process

Page 6: Mold & algae problem solved

®

Application of the BES - CLIMASKIN 1st layer Retrofitting process

Page 7: Mold & algae problem solved

®

Application of the BES - CLIMASKIN 2nd layerRetrofitting process

Page 8: Mold & algae problem solved

®

Application of the BES - CLIMAFIN layerRetrofitting process

Page 9: Mold & algae problem solved

®

The hygrothermal meter device showing NO CONDENSATIOINCondensation problem solved

Page 10: Mold & algae problem solved

®

NOVEMBER 2016 - the wall with the BES is no longer affected

Mold & algae problem solved