© September 2015| Green Energy Management (GEM) | All Rights Reserved |City & Guilds Qualified|W :gemlightingandelectrical.com

|E:info@gemlightingandelectrical.com

Microwave Occupancy Sensors

Microwave sensors - The latest generation of presence control and energy saving lighting.

Controlling lighting with a presence detector can save up to 60% of lighting energy costs dependant

on occupancy behaviour and the amount of natural light available, and even more savings if you

went LED. Ideal for installing in stairways, corridors and communal areas. Can either be installed into

original fittings (Retro refit) or as a new fitting (LED fitting).

I. Retro Refit Microwave occupancy sensor

More efficient than time lag switching, every time a switch is used the lamp uses more energy to

strike up, where as these microwave sensors run constantly at 5% dependant of ambient Lux levels,

when the sensor picks up movement the light will then go to 100% then dim back down when no

movement is detected. Installing these in your original light fittings will save you money on your

energy bills and could also raise the EPC (Energy Performance Certificate) of the building. As from

April 2018 it will be against the law to rent out a premise with an EPC lower than grade E.

Retrofit sensor mounts inside existing fitting saving cabling and redecoration costs

High sensitive microwave technology

Switches all types of lighting including low energy

Can be used with maintained emergency lighting

1 year guarantee

II. LED 16W Bulkhead with microwave occupancy sensor

Maintenance free LED lighting with microwave occupancy sensor already installed into the fitting,

very efficient running at 16 watts. This bulkhead would normally be replaced for the very similar 28

watt bulkhead.

Polycarbonate base and diffuser

IP65 ingress protection

Microwave sensor

Maintained LED emergency fittings available

3 year guarantee