Metsä Wood WalkSure® Decking...METSÄ WOOD Askonkatu 9 E, FI-15100 Lahti Tel. +358 10 4650 499,...
Transcript of Metsä Wood WalkSure® Decking...METSÄ WOOD Askonkatu 9 E, FI-15100 Lahti Tel. +358 10 4650 499,...
WalkSure® is a professional grade, low-slip deck boardcombining a pressure-treated softwood with EPDMrubber. WalkSure® is an attractive and colourful alternativeto traditional timber decking but also a non-abrasive safeslip resistant surface in wet or dry conditions.
PRODUCT APPLICATIONS• Schools, outdoor leisure facilities, entertainment areas, hotels,
clubhouse grounds, outdoor smoking areas.
SLIP RATING• WalkSure is rated as providing ‘low potential for slip’ when
independently tested to BS 7976 part 2 to conform with UK SlipResistance Guidelines.
• Importantly WalkSure achieves the ‘low slip’ rating in each of thethree test procedures, across, diagonal to and along the boardlength.
CLEANING AND MAINTENANCE• Regular cleaning with a mild detergent, together with treatment
of exposed timber components will help to maintain WalkSuredecking. WalkSure can be cleaned using a jet washer at a pressureup to 1500 psi.
FIXING INSTRUCTIONS• Metsä Wood recommends that Walksure is face fixed with 2 x
63mm coated deckscrews at each joist. Screws should be drivendown below the surface of the rubber which hides the screwheadand provides maximum hold.
• Metsä Wood has approved the use of Deck-Tite 4.5x63mm Tri-lockGreen coated Deck screw.
• If deck boards are cut the sawn ends should be re-treated with asuitable timber preservative.
• Supports should be set at a maximum of 450mm centres. Aslight fall should be incorporated into the design to help improvedrainage.
• Please refer to our deck fixing guidelines brochure for more details
Metsä Wood WalkSure® Decking
GUARANTEE • WalkSure deck board carries a 15 year warranty against rot and
fungal decay.
METSÄ WOODAskonkatu 9 E, FI-15100 LahtiTel. +358 10 4650 499, fax +358 10 4650 490www.metsawood.com
This leaflet is provided for information purposes only and no liability or responsibility of any kind is accepted by Metsä Wood or their representatives, although Metsä Wood has used reasonable efforts to verify the accuracy of any advice, recommendation or information. Metsä Wood reserves the right to alteration of its products, product information and product range without any notice.
PEFC/02-31-03
COMPONENT INFORMATION - TIMBERPRODUCT INFORMATION
Dimensions 32 x 125mm nominal / 28 x 119mm finished
Species European Redwood
Botanical name Pinus Sylvestrus
Origin Nordic sources
Certification PEFC
Description Rebated on face to allow for EPDM rubber, smooth on reverse
Guarantee 15 year guarantee against rot and fungal decay
Treatment Copper based pressure impregnated wood preservative (tanalith E 8000)
DECK BOARD INFORMATION PRODUCT INFORMATION
Weight 2kg per lm
Weight (excluding substructure) 16kg per m²
Patent European patent pending EP091 64225.6.
AVAILABLE COLOURS• EPDM rubber is available in 7 colours• Charcoal / red is the standard colour. Other colours available are special order
Charcoal / red Sand / green*
Red / charcoal * Sand / brown*
Charcoal / green* Red / brown*
Sand / red*
* Available as special order items
COMPONENT INFORMATION - PRESSED EPDMPRODUCT INFORMATION
Wear ratio Tested to B.S 5696 Part 3 with a wear ratio of between 1.14 and 1.36
Density 800 kg/m³
Flammability B.S 4790 (Hot Metal Nut Test)Time from application of nut to extinction: 383-425 seconds.Greatest radius of affected area: 19-20mmClassification: Low radius of ignition
Tensile strength 1.4 N/MM² B.S 903/2A
Elongation at break 80% MIN B.S 903/2A
Thermal stability Thermal expansion from 20º to 50ºc is 0.5%
UV stability B.S 1006 light fast to 7(Lifespan dependent of type of surface wear / application and location)
Permeability Rubber compound is porous, flow rates are determined by the type of base substrate on which the material is laid (Nominal 50 LTS/M² at 0.2 Bar)
Sound damping Up to 30db reduction
Binder A low viscosity, solvent-free, single com-ponent, moisture-curing binder based on polyether polyols
FIRE FIGHTING MEASURES• Suitable extinguishing media: Polyvalent foam, carbon dioxide, sand / earth• Special exposure hazards: On burning or exposure to extreme heat: release of toxic and corrosive gases (including oxides of carbon and nitrogen, ethylene, propylene, copper and mono-ethanolamine)• Instructions: Dilute toxic gases with water spray, full protective clothing and self-contained breathing apparatus should be worn for fire fighting.
FURTHER INFORMATION• Please refer to our decking brochure and also our deck fixing guidelines brochure• www.metsawood.co.uk/products/decking
METSÄ WOOD
Telephone: 0800 00 44 44Email: [email protected]
06
02
15 A
S W
alkS
ure
deck
ing
data
shee
t