Supplies

1 Tribuckle (94-6181-18)1 Labyrinth Charm (94-2326-18) 1 Open Heart Charm (94-2095-18) 1 Key Charm (94-2270-18)

7 Rivet Sets (01-0060-18)3 Round Jumprings (01-0020-08)20” 10mm Flat Leather

Required Tools

Compression rivet setter, bench block, hammer, chain or flat nose pliers (2), leather punch, scissors, ruler, pencil

Finished Size

Makes one double wrap adjustable bracelet

Meditation BraceletQuality in the Making

®

Quality in the Making

Lead Free PewterEU Nickel CompliantMade in the USAOriginal Designs

TCI624www.tierracast.com

Skill Level

Easy Peasy1

Meditation BraceletA Double Wrap Bracelet Sure to Charm

DESIGN BY Tracy Gonzales (for TierraCast®)

Instructions

TIP: See our video Technique: Setting Compression Rivets

http://tinyurl.com/c82n279

1. Thread one end of the leather through the small opening of the Tribuckle (ridge side up).

2. Fold end over about 1” and use leather punch to make 2.5mm holes through both layers about 5/8” from the fold.

3. Place a rivet post through the holes from the back. On the top side cover post with rivet cap. Squeeze together to engage.

4. Place bottom of post onto bench block. Place concave end of rivet setter onto cap and strike with hammer until set.

5. Use ruler and pencil to measure and mark placements for decorative rivets 2” apart, leaving last 3” of leather blank.

6. Use leather punch to make 2.5mm holes at each mark.

7. Repeat Steps 3-4 to attach a rivet at each hole.

8. Use pliers to open all jump rings.

9. Attach one jump ring to the Labyrinth Charm.

10. Before closing attach jump ring to Tribuckle.

11. Use pliers to close jump ring.

12. Repeat Steps 9-11 to attach Heart Charms next to the Labyrinth Charm.

13. Adjust bracelet to fit and trim end of leather as desired, allowing for an approximately 1½” tail.

14. Congratulations – you have completed your own double wrap Meditation Bracelet! Customize by choosing personal charms and/or embellishing with rhinestones or additional rivets.

TCI624www.tierracast.com