Questions about DRAW WORK Question 1: How many clutches in the draw work? – 4 (Low, high, sand reel/ spline,

transmission clutch) Question 2: Where is high clutch? - Right side Question 3: Where is low clutch? - Left side Question 4: What type of oil is used in Draw work? – HP140 Question 5: What type of pump is used in draw work? – Lubricant oil Pump Question 6: What is the clearance of the band type brake? Question 7: How much clearance in disk brake? Question 8: How many types hydraulic cylinders use in disk brake? Question 9: What is used for draw work and Elmagco brake cooling? water Question 10: What is the required PH value of the Elmagco cooling water? Question 11: What is inertia brake? Question 12: What is quick release valve? Question 13: How many gears in the draw work? Question 14: How gear shift? Question 15: You can use high and low clutch both together? no Question 16: If there is no air, you can use clutch? no Question 17: Can you increase or decrease the clutch air? Question 18: How many stuffing boxes in draw work? Question 19: What is the use of the stuffing box? Question 20: What is crown-o-matic (crown block saver)? Question 21: How crown-o-matic works? Question 22: What is the oil pressure range?Questions about MUD PUMP Question 23: What is the power end? Question 24: What is the fluid end? Question 26: What is the cross heads? Question 27: What is the clearance limit of the cross heads? Question 28: What is the oil pressure safety valve is set at? Question 29: What is the normal back lash value of the main and pinion gear? Question 30: How you can check the back lash?