Measurement and Detection of Ionizing Radiation
description
Transcript of Measurement and Detection of Ionizing Radiation
![Page 1: Measurement and Detection of Ionizing Radiation](https://reader034.fdocuments.net/reader034/viewer/2022042519/56814d4b550346895dba763e/html5/thumbnails/1.jpg)
1Measurement and Detection of Ionizing Radiation
• Ionizing radiation is invisible• Many methods are available for detection and
measurement, including– Ionization detectors– Scintillation detectors– Biological methods– Thermoluminescence– Chemical methods – free radicals produced– Measurement of heat- energy dissipated
![Page 2: Measurement and Detection of Ionizing Radiation](https://reader034.fdocuments.net/reader034/viewer/2022042519/56814d4b550346895dba763e/html5/thumbnails/2.jpg)
2Ionization
• Devices contain a gas that can be ionized• A voltage is applied to the gas• Specific instrumentation and types of
measurement depend on amount of voltage applied to the gas.
• Three types of instruments:– Ion chambers– Proportional counters – Geiger-Mueller counters
![Page 3: Measurement and Detection of Ionizing Radiation](https://reader034.fdocuments.net/reader034/viewer/2022042519/56814d4b550346895dba763e/html5/thumbnails/3.jpg)
3Log of electrical signal vs. voltage
![Page 4: Measurement and Detection of Ionizing Radiation](https://reader034.fdocuments.net/reader034/viewer/2022042519/56814d4b550346895dba763e/html5/thumbnails/4.jpg)
4
Radiation ionizes the gas. Ions move toward electrodes, creating current.
http://www.science.uwaterloo.ca/~cchieh/cact/nuctek/interactdetector.html
![Page 5: Measurement and Detection of Ionizing Radiation](https://reader034.fdocuments.net/reader034/viewer/2022042519/56814d4b550346895dba763e/html5/thumbnails/5.jpg)
5Ion chamber continued
• Voltage is high enough that ions reach the electrodes, produce current.
• Proportional to energy: the more energy, the more current.
• Generally requires some amplification of the signal.
• Example of use: pocket dosimeters
http://www.ludlums.com/images/dosimeter.jpg
![Page 6: Measurement and Detection of Ionizing Radiation](https://reader034.fdocuments.net/reader034/viewer/2022042519/56814d4b550346895dba763e/html5/thumbnails/6.jpg)
6Proportional counters
• Each ionization electron is accelerated by the voltage so that it ionizes more of the gas.– The higher the energy of
the radiation event, the greater the avalanche, the higher the current
– Each ionization event detected separately.
• Used for neutrons
-+
-+-+
-+-+-+-+
-+-+-+-+-+-+-+-+
-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
. . . . . . . . . . . . . . . . .. . . . . . . . . . . . . . . . .
![Page 7: Measurement and Detection of Ionizing Radiation](https://reader034.fdocuments.net/reader034/viewer/2022042519/56814d4b550346895dba763e/html5/thumbnails/7.jpg)
7Geiger Mueller counters
http://www.pchemlabs.com/images/eberline-rm20-geiger-counter-a.JPG
![Page 8: Measurement and Detection of Ionizing Radiation](https://reader034.fdocuments.net/reader034/viewer/2022042519/56814d4b550346895dba763e/html5/thumbnails/8.jpg)
8How Geiger counters work
• Voltage is high enough that every radiation event triggers a complete avalanche of ionized gas– Does not discriminate among different energy levels– Each event is registered
• A quenching agent stops the reaction, resets gas for next event
• Slow response time (comparatively) but simpler circuitry.
• Good for simple, sturdy, instruments• Best for gamma; low efficiency for alpha, beta.
![Page 9: Measurement and Detection of Ionizing Radiation](https://reader034.fdocuments.net/reader034/viewer/2022042519/56814d4b550346895dba763e/html5/thumbnails/9.jpg)
9More Geiger details
Higher voltage leads to constant avalanches; instrument “pegs”.
Improved efficiency with pancake probe: collects more radiation due to geometry.
![Page 10: Measurement and Detection of Ionizing Radiation](https://reader034.fdocuments.net/reader034/viewer/2022042519/56814d4b550346895dba763e/html5/thumbnails/10.jpg)
10Proper use of Geiger counters as “survey meters”
• http://orise.orau.gov/reacts/guide/index.htm• Units of radioactivity and radiation
– Radiation detection instruments and methods• First check battery and check source
– Enclosed radioactive material of known amount• Check level of background radiation• Survey area in question
– Move survey instrument slowly– Keep constant distance from object being surveyed;
do not make contact.
![Page 11: Measurement and Detection of Ionizing Radiation](https://reader034.fdocuments.net/reader034/viewer/2022042519/56814d4b550346895dba763e/html5/thumbnails/11.jpg)
11Solid scintillation counters• Crystal-based
– Radiation hits crystal which releases visible photons– Photons amplified by photomultiplier tube, converts
to electrical signal• Zinc sulfide
– Good detection of alpha particles, rapid response time
• Sodium iodide w/ thallium– Good for detection of gamma
• New ones showing up
![Page 12: Measurement and Detection of Ionizing Radiation](https://reader034.fdocuments.net/reader034/viewer/2022042519/56814d4b550346895dba763e/html5/thumbnails/12.jpg)
12
http://www.fnrf.science.cmu.ac.th/theory/radiation/Radiation%20and%20Radioactivity_files/image018.gif
![Page 13: Measurement and Detection of Ionizing Radiation](https://reader034.fdocuments.net/reader034/viewer/2022042519/56814d4b550346895dba763e/html5/thumbnails/13.jpg)
13Liquid Scintillation counters• Workhorse in biology labs for many years • Very useful for beta emitters, some alpha• Modern equipment:
– Computer driven
http://www.gmi-inc.com/Genlab/Wallac%201414%20LS.jpg
![Page 14: Measurement and Detection of Ionizing Radiation](https://reader034.fdocuments.net/reader034/viewer/2022042519/56814d4b550346895dba763e/html5/thumbnails/14.jpg)
14Basic principles• Radioactive sample is mixed with organic
solvents (cocktail)• Toluene replaced with biodegradable solvents• Detergents allow up to 5% aqueous samples
• Radiation hits solvent, energy is absorbed by solvent; Energy passed to one or more fluors
• Fluor emits visible light which is detected– By fluorescence– Amplified by photomultiplier, converted to electrical
signal.
![Page 15: Measurement and Detection of Ionizing Radiation](https://reader034.fdocuments.net/reader034/viewer/2022042519/56814d4b550346895dba763e/html5/thumbnails/15.jpg)
15
![Page 16: Measurement and Detection of Ionizing Radiation](https://reader034.fdocuments.net/reader034/viewer/2022042519/56814d4b550346895dba763e/html5/thumbnails/16.jpg)
16Coincidence circuitry
• Photomultipliers very sensitive– Inside of instrument completely dark– Tubes give off “thermal electrons”
• Result would be very high background counts• Coincidence circuitry compares results from 2
photomultipliers– Event not detected by both: thermal electron
• Ignored– Event detected by both is affect of beta particle
• Counted.
![Page 17: Measurement and Detection of Ionizing Radiation](https://reader034.fdocuments.net/reader034/viewer/2022042519/56814d4b550346895dba763e/html5/thumbnails/17.jpg)
17Counts and energy discrimination
• As radiation travels through solvent, it gives up energy– The more energy it has, the more fluor molecules
get excited and release photons– Thus, the higher the energy, the brighter the flash
• The higher the electrical pulse sent from the PMs• Instruments can be electronically adjusted
– Discriminators set for different “pulse height”– Able to count betas from H-3 vs. C-14 vs. P-32
![Page 18: Measurement and Detection of Ionizing Radiation](https://reader034.fdocuments.net/reader034/viewer/2022042519/56814d4b550346895dba763e/html5/thumbnails/18.jpg)
18
Beta energy spectracpm
Pulse height
![Page 19: Measurement and Detection of Ionizing Radiation](https://reader034.fdocuments.net/reader034/viewer/2022042519/56814d4b550346895dba763e/html5/thumbnails/19.jpg)
19Summary of capabilities
• Pulse height– From brightness of flash; the more energetic the
radiation, the brighter the flash.– Discriminators (“gain”) in the instrument can be set
so you determine what energy you want counted.• Number of pulses
– Corresponds to how many flashes, that is how many radiation events (decays): the amount of radioactivity.
![Page 20: Measurement and Detection of Ionizing Radiation](https://reader034.fdocuments.net/reader034/viewer/2022042519/56814d4b550346895dba763e/html5/thumbnails/20.jpg)
20Difficulties with LSC1. Static electricity: causes spurious high counts,
esp. when humidity is low; 1. don’t wipe outside of vials!
2. Chemiluminescence: chemical reactions in sample, from overhead lights, glass.
1. Suspiciously high counts can be redone; chemi-induced high counts subside over time.
3. Quench1. Anything that interferes with counting efficiency.
1. Measured: counts per minute (cpm)2. Desired: decompositions per minute (dpm)
![Page 21: Measurement and Detection of Ionizing Radiation](https://reader034.fdocuments.net/reader034/viewer/2022042519/56814d4b550346895dba763e/html5/thumbnails/21.jpg)
21Counting efficiency
• Because samples are usually dispersed in clear containers, geometry is favorable for energy transfer in all directions and good light emission
• Not all decay events will get registered, however, because no system is 100% efficient
• We seek to know the # of decompositions per minute (dpm) but measure the counts per minute (cpm).
• Using standards helps determine efficiency.
![Page 22: Measurement and Detection of Ionizing Radiation](https://reader034.fdocuments.net/reader034/viewer/2022042519/56814d4b550346895dba763e/html5/thumbnails/22.jpg)
22Effect of Quench
![Page 23: Measurement and Detection of Ionizing Radiation](https://reader034.fdocuments.net/reader034/viewer/2022042519/56814d4b550346895dba763e/html5/thumbnails/23.jpg)
23All about quench• Chemical quench
– Acids, bases, high salt, any chemical that interferes with transfer of energy from the solvent to the fluor.
– Result: fewer activated fluor molecules, less intense flash, interpreted as a lower energy event.
• Color quench– Colored material absorbs visible light from fluor– Less intense flash, appears as lower energy event
![Page 24: Measurement and Detection of Ionizing Radiation](https://reader034.fdocuments.net/reader034/viewer/2022042519/56814d4b550346895dba763e/html5/thumbnails/24.jpg)
24About quench -2• Self absorption
– If particulate matter not well suspended, energy not absorbed by fluor, not detected as well. Both lowering of cpm and forcing into lower energy range.
![Page 25: Measurement and Detection of Ionizing Radiation](https://reader034.fdocuments.net/reader034/viewer/2022042519/56814d4b550346895dba763e/html5/thumbnails/25.jpg)
25Counting statistics• Radioactive decay is a random event
– To be sure results are reliable, a minimum number of decay events must be recorded.
– Reliability depends on total number of counts!• Example
– Statistical significance is the same in these two cases;• 10 minute count yielding 500 cpm• 1 minute count yielding 5000 cpm.
– Both have total of 5000 counts– Instruments have settings for stopping count when
a certain statistical threshold is reached.