Mazda Wiring
-
Upload
doctorhowdy -
Category
Documents
-
view
23 -
download
2
description
Transcript of Mazda Wiring
All Information, Including Photos And Illustrations, In These Pages Is Believed To Be Correct And Reliable. The Information Contained In These Pages Is Given As General Information For The Installation Of Audio, Video, Security, Communications,And Other Accessory Products Into Mobile And/Or Vehicle Applications. The Install Doctor, Any Subsidiaries Or Divisions Thereof, Or Any Member Of These Companies Shall Not Be Held Liable For Any Damages And/Or Injuries Resulting From
The Use Of Information Contained In These Pages. All Information Contained In These Pages Should Be Checked And Verified With Appropriate Test Equipment To Assure The Safety And Proper Operation Of Equipment Installed And The VehicleItself. Careful Attention Should Be Given To All Electronic/Electric Circuits. High Voltages And Currents Can Cause Bodily Injury, Skin Damage, And Even Death. Installs Are Taken At The Risk Of Each Installer, And/Or Individual.
Publication, Duplication, or Retransmission Of This Document Not Expressly Authorized In Writing By The Install Doctor Is Prohi bited. Protected By U.S. Copyright Laws. © 1997,1998,1999,2000.
www.installdr.com
1992 And Newer
Mazda Radio Wire Harnesses
Note: using an optional snap on wire harness adapter will simplify the wiring. Most snap on wire harness adapters have already converted and color codedthe wires from the auto makers in dash wire harness to match typical aftermarket radio wire colors.
** The wire colors listed in the chart above are typical for these vehicles during these years but may not be the exact colors for this vehicle. This is anotherreason to use a snap on wire harness adapter. **
AS VIEWED FROM MATING END OF CONNECTOR
D E F G H K L
A B C I J
O P Q R T
M N S
Typical Mazda Radio Typical New RadioPin What It Is In Dash Wire Color Equivalent Wire Color
A +12 Volt Ignition Wire Blue w/ Black Stripe RedB +12 Volt Battery Wire Blue w/ Red Stripe YellowC Do Not UseD Do Not UseE Power Antenna Turn On not available BlueF Do Not UseG Do Not UseH Do Not UseI Left Front Speaker (+) Purple WhiteJ Right Front Speaker (+) Orange GrayK Left Front Speaker (-) Blue w/ Orange Stripe White w/ Black StripeL Right Front Speaker (-) White Gray w/ Black StripeM Left Rear Speaker (+) White w/ Blue Stripe GreenN Do Not UseO Left Rear Speaker (-) Black w/ Blue Stripe Green w/ Black StripePQ Right Rear Speaker (+) Blue w/ White Stripe PurpleR Right Rear Speaker (-) Blue Purple w/ Black StripeS Do Not UseT Do Not Use
Crimp a male tab spade to the new radiosground wire. Slide it into the brown femaletab spade connector that originally snappedinto the tab on the rear of the factory radio.
TIP:
All Information, Including Photos And Illustrations, In These Pages Is Believed To Be Correct And Reliable. The Information Contained In These Pages Is Given As General Information For The Installation Of Audio, Video, Security, Communications,And Other Accessory Products Into Mobile And/Or Vehicle Applications. The Install Doctor, Any Subsidiaries Or Divisions Thereof, Or Any Member Of These Companies Shall Not Be Held Liable For Any Damages And/Or Injuries Resulting From
The Use Of Information Contained In These Pages. All Information Contained In These Pages Should Be Checked And Verified With Appropriate Test Equipment To Assure The Safety And Proper Operation Of Equipment Installed And The VehicleItself. Careful Attention Should Be Given To All Electronic/Electric Circuits. High Voltages And Currents Can Cause Bodily Injury, Skin Damage, And Even Death. Installs Are Taken At The Risk Of Each Installer, And/Or Individual.
Publication, Duplication, or Retransmission Of This Document Not Expressly Authorized In Writing By The Install Doctor Is Prohi bited. Protected By U.S. Copyright Laws. © 1997,1998,1999,2000.
www.installdr.com
AS VIEWED FROM MATING END OF CONNECTOR
A C
B D
Whi te Blue
E G
F H J K
L
M
1983 to 1992
Mazda Radio Wire Harnesses
Note: using an optional snap on wire harness adapter will simplify the wiring. Most snap on wire harness adapters have already converted and color codedthe wires from the auto makers in dash wire harness to match typical aftermarket radio wire colors.
** The wire colors listed in the chart above are typical for these vehicles during these years but may not be the exact colors for this vehicle. This is anotherreason to use a snap on wire harness adapter. **
For Pin M: (+) 12 Volt Battery WireCrimp a male tab spade connector onto the(+) 12 Volt Memory or Battery wire from yournew radio and slide it into Pin M.
TIP:
Power Antenna Wire from thenew replacement radio
Negative or Groundconnection
Negative or Ground wire connection
No wire connectedto this contact
Convert A (+) Positive Voltage Wire To A (-) Negative Voltage Or Ground Wire
Application: To convert Mazda power antennas up to 1992 to work with new replacement radiosUnderstand: A (+)12 Volt wire connected to the inductor coil (85 or 86) will switch the relay to connect a (-) negative wire to the output contact (from87 to 30)
86
85
87 87a
30
Output Wire going toMazda power antenna
When the radio turns on, the (+) 12 Volt power antenna wire will turn on the relay, moving the contact arm from pin 87a to the (-) negative ground wireattached to pin 87 which is also in contact with pin 30 which is connected to the Mazda power antenna.
Relay Contact Connections
30: (-) Output from relay to Mazda power antenna87: (-) Negative or ground wire
connected to relay86: Power antenna wire from new replacement
radio85: (-) Negative or ground wire
For best results and quicker installation, use thesame (-) negative or ground wire for both 85 and 87
INSTALLATION NOTE:For vehicles with power antennas
Every auto manufacturer uses a (+) positive electricsignal from the radio to the power antenna, EXCEPTMazda up to 1992. Mazda, instead, used a (-)negative electric signal to trigger the power antenna.When the radio turned on, the radio would send a (-)negative electric signal to the power antenna and thepower antenna would raise. When the radio or thevehicle was turned off, the electric signal would stopand the power antenna would lower. In order for anew replacement radio to activate a Mazda powerantenna up to 1992, a SPDT relay must be used. Seediagram below.
Typical Mazda Radio Typical New RadioPin What It Is In Dash Wire Color Equivalent Wire Color
A Left Front Speaker (+) WhiteB Left Front Speaker (-) White w/ Black StripeC Right Front Speaker (+) GrayD Right Front Speaker (-) Gray w/ Black StripeE Left Rear Speaker (+) GreenF Left Rear Speaker (-) Green w/ Black StripeG Right Rear Speaker (+) PurpleH Right Rear Speaker (-) Purple w/ Black StripeJ Dash Light Illumination Typically Not Used OrangeK (+) 12 Volt Ignition Wire RedL Power Antenna Wire Blue or Blue w/ Wht StripeM (+) Volt Battery Wire See Tip Below Yellow