Manfell Services Control 4 Camera Drivers
Transcript of Manfell Services Control 4 Camera Drivers
Manfell Services Control 4 Camera Drivers
• All Ways set up Camera first!!!
• Only add driver to composer after you have completed all settings on the Camera
Setting up Camera
Common Settings Not checked or Noted
❖Not Checking that all cameras are on line
❖Not configuring the sub stream and setting it H264
❖Not setting to correct resolution
❖Not checking upload speed (requires at least 12mb per second for you to see camera on navigator remotely)
❖Not setting the IP of Camera to Static
Setting up Stream on Camera
❖The main stream is preset
❖Substream should be set no higher than 1280 X 720
❖Set FPS to 15
❖Set Bitrate to 1024 kbps
❖See the next 2 slides
Setting up Network on Camera
❖Set the Camera IP to Static
❖Set DNS to 8.8.8.8 and 8.8.4.4
❖See the next 2 slides
❖Please note the IP address you have set
Check Ports on NVR
❖HTTP port is 80
❖RTSP port is 554
❖Please note if you change ports
Control 4 Driver Settings
Common Settings Missed
❖Forgetting to click on set button
❖Not putting in the correct port number for RTSP
❖Not clicking Authentication required
❖Not setting the correct login and password for NVR/DVR
❖Not setting Camera Channel Number
❖Not adding another copy of driver for each camera
Required information to entered in driver
Check with Control Control for Snapshot
Check with Control Control for H264