Making the Panda Mask Gather the following: Panda mask pattern (found on website and below), white foam, black foam or black “prestofelt”, dowel/stick or ribbon, glue, duct tape, pencil or sharpie, scissors and hole punch.

Carefully cut out the paper pattern and all black pieces. Using pencil or silver sharpie, transfer design pieces to appropriate colored foam and/ or felt. Cut the pieces from the foam and/or felt. With the felt you simply peel off the backing and position in on the white foam. With the black foam, use the foam glue to put the pieces on the white foam. After the foam glue has dried, turn the mask over and using duct tape add the dowel. If you would rather have a hands free mask, simply use a hole punch to make two holes in the mask and tie a ten inch piece of ribbon on each side.

Voila you are a panda!

Got any great panda mask photos? We would love to see them. Send to info@pandasinternational.org.