PML-WP Lifting magnets are waterproof up to 1.5m diving depth. The multi-sealed, super strong permanent magnet system is located in a fully nickel-plated magnetic body. Like all PML models with high safety factor and maximum ease of use.

PML-WP Permanent Lifting Magnet

Model Item-Nr. Max. rec. Load-capacity (kg) Max. Load-capacity from (mm)

Dimensions (mm) Weight(kg) L W H H with clevis

PML-WP 250 1001 0254 250 Ø 100-250 mm 125 12 225 70 76 140 6,2

PML-WP 500 1001 0504 500 Ø 150-350 mm 250 18 320 100 108 198 15

max. Operation-temperature 80°C

IP 68 • 1,5 bar

PML-C Lifting magnets have a circular multi-pole clamping surface and are therefore ideally suited to lift workpieces having an annular contact surface and bearing housings, flange plates and rings. Since annular workpieces often the contact surface is reduced to the magnet, the max. Be roughly calculated carrying capacity as follows : Contact surface in cm² x 4 = max . Load in kg. These notional value are still the reduction factors for alloy, hardness and temperature to be counted . Whether the required safety factor of 3 in series workpieces is achieved must be checked. In the non-magnetic center of the rake face is a M10 thread, onto which a centering disc or pin can be screwed.

PML-C Permanent Lifting Magnet

Model Item-Nr. Max. rec. Load-capacity (kg)

Max. Load-capacity from (mm)

Dimensions (mm) Pole Weight(kg)Ø H

PML-C 15 1001 0157 100 12 150 57 10 10

PML-C 20 1001 0207 200 15 200 57 12 15

PML-C 25 1001 0257 250 15 250 70 16 26

PML-C 30 1001 0307 300 15 300 73 16 38

max. Operation-temperature 80°C

Magnetisches HebenMagnetic Lifting

202020