machining non-metals - usinagem de não metais (polímeros e madeira).CAMPOS, Vicente.
Machining of High Strength Metals by Use of Cryogenic Cutting
7
Page1 UNI-LJ Vienna, 2014 University of Ljubljana Faculty of Mechanical Engineering Laboratory for Machining Machining of Hi gh St ren gt h Metals by Use of Cryogenic Cutting F. Pušavec, J. Kopač University of Ljub ljana Slide 1/13 F. Pusavec, J. Kopac Environment and health benign technologies are becoming important for achieving cleaner, healthier and safer machining. Problem and motivation: Trend of HSM – higher temperatures affecting both cutting tool & part. Development of CLF (Cooling Lubrication Fluid) and the rmal management – inevitable and emerging R&D direction. UNSTUSTAINABILITY FACT – Industry is widely using conventional oil-based CLF to counter the extremely high levels of heat generated in the cutting zone, even they are environmentally unfriendly, health hazardous and relatively costly. Total machini ng cost s: 15 % – CLF, 4 % – tools. Dry machining – huge process gain from sustainability point of view, however…. Nowadays extremely hard-to-machine materials are frequently used, not allowing dry machining (high-temp alloys: Nickel alloys, titanium alloys, Co-Cr, etc.). Motivation for Sustainability in Machining Processes → Cryogenic machining
-
Upload
horaciogutierrez -
Category
Documents
-
view
5 -
download
0
description
Paper about steel manufacturing
Transcript of Machining of High Strength Metals by Use of Cryogenic Cutting
-
5/19/2018 | 502: Bad gateway
1/1
Error 502 Ray ID: 41d2085636e923c6 2018-05-18 23:16:37
UTC
Bad gateway
You
Browser
Working
Ashburn
Cloudflare
Working
Host
Error
What happened?
The web server reported a bad gateway error.
What can I do?
Please try again in a few minutes.
Cloudflare Ray ID: 41d2085636e923c6 Your IP: 54.39.18.118 Performance & security by Cloudflare
https://www.cloudflare.com/5xx-error-landing?utm_source=error_footer