Machine Design123
2
Machine Design 5 Questions I By Enriv Q.1) For shafting, alloy steel is for high strength requirements, what material to be used for commercial purposes. A . Stainless steel B . Mild steel C . Carbon steel (Your Answer) D . Nickel steel Incorrect Q.2 ) A hollow shaft must carry a torque of 3,400,000 N-mm at a shearing stress of 55 Mpa. The inside diameter is to be 0.65Do. Find the outside diameter? A.82 mm B.75 mm (Your Answer) C.76 mm D.73 mm (Correct Answer) Incorrect Q.3) The torsional deflection of SAE 1040 steel shaft is 0.8 deg. in a length of 500 mm. The shear stress is 69 Mpa. Compute the diameter of the shaft if the steel modulus of elasticity is 79,300 Mpa. A. 51
-
Upload
joeylacamiento-1 -
Category
Documents
-
view
222 -
download
6
description
Machine Design123
Transcript of Machine Design123
Machine Design5 Questions I By Enriv
Q.1) For shafting, alloy steel is for high strength requirements, what material to be used for commercial purposes.
A. Stainless steel
B.Mild steel
C.Carbon steel (Your Answer)
D.Nickel steel
Incorrect
Q.2) A hollow shaft must carry a torque of 3,400,000 N-mm at a shearing stress of 55
Mpa. The inside diameter is to be 0.65Do. Find the outside diameter? A. 82 mm B. 75 mm (Your Answer)
C. 76 mm D. 73 mm (Correct Answer)
Incorrect
Q.3) The torsional deflection of SAE 1040 steel shaft is 0.8 deg. in a length of 500 mm. The shear stress is 69 Mpa. Compute the diameter of the shaft if the steel modulus of elasticity is 79,300 Mpa.
A. 51
B. 75 (Your Answer)
C. 62 (Correct Answer)
D. 50
Correct
Q.4) A vertical load of 400N acts at the end of a horizontal rectangular cantilever beam
2-m long and 25-m. If the allowable bending stress is 130,000 kPa, find the depth of the beam?
A. 34.83 mm B. 40.4 mm C. 38.43 mm (Your Answer)
D. 39.44 mmCorrect
Q.5) What kind of stress experienced by a pressurized vessel. A. Shear stress B. Tensile stress (Your Answer)
C. Bending stress D. Compressive stress
