!LTNZ Short Form Catalogue NZ-2016 - Lees TechLTNZ Short Form Catalogue NZ-2018… · LTX-2V 2...
Transcript of !LTNZ Short Form Catalogue NZ-2016 - Lees TechLTNZ Short Form Catalogue NZ-2018… · LTX-2V 2...
PRODUCT CATALOGUE
INDUSTRIAL AND COMMERCIAL
ACCESS CONTROLS
Supplied as standard with electric roller doors and grills unless otherwise specified
For MANUAL CONTROL only
OPERATION
Push to Run UP and DOWN (“Dead Man” or “Inching”)
FEATURES
• Housed in an IP65 plastic enclosure and comprising of UP/DOWN contactors and
terminals for supply/motor/limit switch
• Available in Single or 3 Phase
• Simple PUSH TO RUN operation using UP and DOWN pushbuttons
• Press and hold UP pushbutton to open
• Press and hold DOWN pushbutton to close. Operation will stop when the
pushbutton is released or when door reaches the pre-set limit
• Branded with your company logo at no extra charge
DC-1A Single phase Controller
DC-1A-C Single phase Controller – complete with Digital Counter
DC-3A 3 phase Controller
DC-3A-C 3 phase Controller – complete with Digital Counter
DC-VSD VSD Controller – Fitted with integral VSD for single phase supply and 400V 50Hz 3 phase motor
DC-1A
DC-3A
DC-1A-C
DC-3A-C DC-VSD
TYPE A CONTROLLERS
OPERATION Maintained UP (“Latching”)
STOP
Push to Run DOWN (“Dead Man” or “Inching”)
FEATURES
• Housed in an IP65 plastic enclosure and comprising of UP/DOWN contactors,
overload relay and terminals for supply/motor/limit switch
• Available in Single or 3 Phase
• Simple operation using UP/STOP/DOWN pushbuttons
• Press and release UP pushbutton to open. Door will open until it reaches the UP
limit or STOP button is pressed
• Press and hold DOWN pushbutton to close. Operation will stop when the pushbutton
is released or when door reaches the pre-set limit
• To stop door during open or close cycle press STOP pushbutton. Press UP or DOWN
pushbutton to resume operation
DC-1M
DC-1M-C
Single phase Controller
Single phase Controller – complete with Digital Counter
DC-3M
DC-3M-C
3 phase Controller
3 phase Controller – complete with Digital Counter
TYPE M CONTROLLERS
DC-1M
DC-3M
DC-1M-C
DC-3M-C
RI-1 RADIO REMOTE INTERFACE
Optional Radio Remote Interface for Retrofit or New Installation with Manual Controller,
Shutter Motor or Tube Motor
FEATURES
• Inputs for Receiver, key switch, safety beams, loop detector, keypad or card reader • Provides Maintained UP / DOWN (“Latching”) and lockout STOP functions • Available as a kit comprising of Controller, Receiver and Transmitter • Enables cost effective and simple remote control of door • Fitting of safety beams to prevent door closing on obstruction is recommended
• Available in Single or 3 Phase
RRI-1 Radio Remote Interface Controller
RRI-1-KIT Radio Remote Interface Controller
Complete with:
- 1 x RRI-1 Radio Remote Interface Controller
- 1 x LRX-1E Receiver
- 1 x LTX-1 Transmitter
Complete Stand Alone, Multi-Mode Automatic Controller
FEATURES
• Recommended for use in factories, warehouses, storage facilities, etc.
• Inputs for Receiver, key switch, safety beams, loop detector, keypad and card reader
• Toggle (remote control), Auto Close or Security Close Mode functions
• Available as a kit comprising of Controller, Receiver and Transmitter
• Enables cost effective remote control of door
• Electronic overload relay fitted
• Fitting of Safety Beams to prevent the door closing on obstruction is recommended • Available in Single or 3 Phase
RR-3 Radio Remote Controller
RR-3-KIT Radio Remote Controller
Complete with:
- 1 x RR-3 Radio Remote Controller
- 1 x LRX-1E Receiver
- 1 x LTX-1 Transmitter
RRI-1 RADIO REMOTE INTERFACE
RR-3 RADIO REMOTE CONTROLLER
Complete Stand Alone, Full Featured, Multi-Mode Automatic Door Controller
Fully enabled for integration with Security or Building Management Systems
FEATURES
• Recommended for use in Carparks, Hospitals, Schools, Fire and Police stations, Courts, Prisons, Apartment and Office buildings and any site where logic control and interface with security or building management system is required
• Inputs for Receiver, key switch, safety beams, loop detector,
keypad and card reader • The AL2 Auto Logic Controller is FUTURE PROOF designed with the
ability to add functions at a later date as requirements change • System capable for access controls and security devices • Housed in IP65 plastic enclosure with pad-lockable isolating switch,
contactors, electronic overload relay, and multi-mode logic board with mode switch and adjustable timer (Auto Close)
• Toggle (remote control), Auto Close or Security Close Mode Functions
• Fitting of Safety Beams to prevent the door closing on obstruction
is recommended • Available in Single or 3 Phase • Also available with integral VSD for single phase supply and three
phase motor providing soft start/stop and variable speed control
• Digital Counter
• A timer can be added to open and close the door at pre-set times and days
AL-2 Auto Logic Controller
AL-VSD Auto Logic Controller
Fitted with integral VSD for single phase supply and 400V 50Hz 3 phase motor
AL-2 AUTO LOGIC CONTROLLER
Purpose designed for use in
Fire, Ambulance and Police Stations, and NZ Corrections Dept
FEATURES
• The AL-FS Auto Logic Controller is FUTURE PROOF designed with the ability to
add functions at a later date as requirements change
• Fully enabled for integration with Security or Building Management Systems if
required and system capable for access controls and security devices
• Inputs for Receiver, key switch, safety beams, loop detector, keypad and card
reader
• Housed in an IP65 plastic enclosure and comprising of UP/DOWN contactors,
electronic overload relay, 12-24V power supply, multi-mode logic board with
mode switch, digital counter and adjustable timers
• Fitting of safety beams is highly recommended to prevent door closing on
obstruction
• Available in Single or 3 Phase
• Also available with integral VSD for single phase supply and three phase motor providing soft start/stop and variable speed control
• Separate control pendant available with UP/DOWN and STOP push buttons for
mounting in areas with limited space
• Delay close for up to 24 hours
• Door can be stopped during open or close by the STOP pushbutton
• Fan pendant available for manual fan operation
• Pad-lockable isolating switch – mounted on controller or separately
• Auto/Manual key switch
• Digital counter
• Extra inputs for Security and Building Management Systems
• A timer can be added to open and close the door at pre-set times and days
AL-FS Auto Logic Fire Service Controller
AL-FS-VSD Auto Logic Fire Service Controller
Fitted with integral VSD for single phase supply and 400V 50Hz 3 phase motor
AL-FS AUTO LOGIC FIRE SERVICE CONTROLLER
R ROLLER SHUTTER OPERATORS Integrated Operators complete with Door Controller (optional), Limit Switch,
Pre-wired Control Pendant (6m cord) and Power Cord for PLUG AND PLAY Installation.
Rated for High Cycle Duty
FEATURES
• Industrial Motor Rated For High Duty Cycle
Totally enclosed, die cast aluminium frame with cooling fins and fan for low temperature rise and long life • Heavy Duty Gear box
Cast aluminium in sealed oil bath (no leakage and can be mounted in any position) • Mechanical Limit Switch
On board limit switch for accurate and reliable door travel • Double output shaft for universal mounting
Pre-wired with: Or:
Type A Controller Naked
Type M Controller (i.e. no pre-wired controller)
RR-3 Radio Remote Controller For connection to wall mounted controller
INDUSTRIAL HIGH CYCLE MOTORS LEES TECH Heavy Duty Roller Shutter Motors are specially designed for the requirements of the Door and Grill industry
FEATURES
• Rated for High Cycle application • High starting torque • Housed in IP55 enclosure • Totally enclosed die cast aluminium frame with cooling fins and fan for low temperature rise and long life • Both single and 3 phase supply • B34 foot and pad mounting • Compatible with the full range of LEES TECH Controllers and Accessories • 3 Phase can be connected in either star or delta - allowing both direct on line starting and VSD soft start and stop control
SINGLE PHASE (230V 50Hz)
ML7124
ML8024
0.37kW 0.5hp D71 B34 frame foot and pad mounting
0.75kW 1hp D80 B34 frame foot and pad mounting
3 PHASE (400V 50Hz)
RMS7124 0.37kW 0.5hp D71 B34 frame foot and pad mounting
RMS8024
RMS8034
0.75kW 1.0hp D80 B34 frame foot and pad mounting
1.1kW 1.5hp D90 B34 frame foot and pad mounting
3 PHASE BRAKE (400V 50Hz)
MSEJ7124 0.37kW 0.5hp D71 B34 frame foot and pad mounting BRAKE motor
MSEJ8024 0.75kW 1.0hp D80 B34 frame foot and pad mounting BRAKE motor
MSEJ8034 1.1kW 1.5hp D90 B34 frame foot and pad mounting BRAKE motor
INDUSTRIAL GEAR BOXES
High Quality Heavy Duty Worm Gear Reducer
Compatible with all LEES TECH Electric Motors
FEATURES
• High quality aluminium alloy die cast gear box
• High accuracy worm gear and worm shaft
• Less noise and lower temperature increase
• Simple mounting and linking to motor
• High efficiency
• In sealed oil bath (no leakage and can be mounted in any position)
• Double output shaft for universal mounting
• Double input shaft
NMRV-050-40 0.37kW 0.5hp #50 40:1 ratio D71 Gear box – Suitable for ML7124/RMS7124/MSEJ724
NMRV-063-50 0.75kW 1.0hp #63 50:1 ratio D80 Gear box – Suitable for ML8024/RMS8024/MSEJ8024
NMRV-075-40 1.1kW 1.5hp #75 40:1 ratio D90 Gear box – Suitable for RMS8034/MSEJ8034
ACCESSORIES
SB-3 Safety Beam through beam type 10m range 12-24V AC/DC, IP65
LRX-1E Radio remote receiver Universal type with antenna 12-24V AC/DC
LTX-1 1 Button keychain transmitter 300MHz
LTX-2 2 Button keychain transmitter 300MHz
LTX-1V 1 Button visor transmitter 300MHz
LTX-2V 2 Button visor transmitter 300MHz
LTX-3V 3 Button visor transmitter 300MHz
LRX-C5 Coax Antenna Kit 5m
DSP-7 Loop Detector “Plug-and-Play” 10-30V AC/DC
DSP-10 Loop Detector “Universal” 10-30V AC/DC
W3-A Hard Wired Keypad IP65 outdoor/indoor with card reader 12-24V AC/DC
LKP-1 Wireless Keypad Weather Resistant 9V Battery – Compatible w/ LRX-1E Receiver
UPS BATTERY BACKUPS For 230V Single Phase Supply (for 3 phase motor use DC-VSD or AL-VSD Controller)
N1K 0.37kW 1kVA 700W
N2K
N3K
0.75kW 2kVA 1400W
1.1kW 3kVA 2100W
KEY SWITCHES
KS-HDF Flush Mounted Key Switch
Heavy duty stainless steel faceplate
UP-DOWN Operation
6 pin Lockwood 5 profile with random key
Can be fitted with most types of security cylinder and master keyed
KS-HD Heavy Duty Enclosed Key Switch
Heavy duty stainless steel faceplate and enclosure
UP-DOWN Operation
6 pin Lockwood 5 profile with random key
Can be fitted with most types of security cylinder and master keyed
KS-LD Light Duty Enclosed Key Switch
House in IP65 plastic enclosure
UP-DOWN Operation
Keyed alike, cannot be changed