Lincoln mk 8 coil spring conversion

INDUSTRIES

INDUSTRIES

www.SuncoreIndustries.com

For ALL Your Air Suspension Needs!!!

toll free: 1-888-259-1505 phone: 954-783-2272 fax: 954-783-2274

1993-1998

Lincoln Mark 8

50F-30-4

4-Wheel Conversion kit

All Parts are to be Installed by a Certied ASE Technician.

1631 South Dixie Hwy. Building B

Pompano Beach, Florida 33060

INDUSTRIES

INDUSTRIES




www.SuncoreIndustries.com 1.50F-30-4

Turn air suspension switch o.

Raise vehicle and remove the wheel.

Remove the Upper Control Arm by removing the pinch bolt and nut. Position the air

suspension height sensor out of the way.

Tap the wishbone control arm upward.

Twist air spring counter-clockwise, pull the air spring out.

Unbolt the brake line braket that is mounted to the frame.

Go to the engine compartment and remove the three shock tower nuts 13mm.

Pull air strut out and install the kit in reverse procedure.

Be sure to securly plug both airlines after removing solenoids.

( 2-wheel kits only)

See attached instructions to disarm suspension warning light.

If this DOES NOT turn out the suspension warning light, you can cut the ground wire to

the suspension compressor.

In the Trunk Turn main air ride switch on.

1

2

3

4

5

6

7

8

9

10

11

Front Conversion

WARNING:

BEFORE YOU BEGIN THE REMOVAL OR INSTALLATION, READ ALL INSTRUCTIONS THOROUGHLY!

THE WARRANTY WILL BE VOID IF INSTRUCTIONS ARE NOT FOLLOWED EXACTLY. DO NOT WORK

UNDER CAR UNDER A VEHICLE SUPPORTED BY A JACK. ALWAYS SUPPORT THE VEHICLE ON

SAFETY STANDS.



INDUSTRIES

INDUSTRIES





2019 18 17 16 15 14 13 12 11

29 28 2732 31 30

GRAY PLUG

MARK 8 DISARM SUSPENSION LIGHT

G R A Y P L U G

M O D U L E

YES NO

Front Conversion



Contact Suncore Industries For How To:

Disarming The “Suspension Warning Message”

INDUSTRIES

INDUSTRIES





Front Conversion



INDUSTRIES

INDUSTRIES





Turn air suspension switch off.

Raise vehicle and remove the wheel.

Release the air pressure by removing the air spring solenoid valve.

Release the plastic clips, push up on the air bag; then push down on the

metal tab.

Twist air spring counter-clockwise, pull the air spring out.

You will need to unbolt lour shock and stabilizer rod, so the rear axle

will lower itself to install the spring kit.

With the top plate provided, set the spring in the bucket.

Be sure to turn both of the springs in the same direction.

Use reverse procedure to complete the job.

Be sure to securely plug both airlines after removing solenoids

(2-wheel kits only.)

See attached instructions to disarm suspension warning light.

In the Trunk Turn main air ride switch on.

1

2

3

4

5

6

7

8

9

10

11

12

Rear Conversion



INDUSTRIES

INDUSTRIES





2019 18 17 16 15 14 13 12 11

29 28 2732 31 30

GRAY PLUG

MARK 8 DISARM SUSPENSION LIGHT

G R A Y P

L U G

M O D U L E

YES NO

INSTALL TOP PLATE HERE

REMOVE SHOCK BOLT

INSTALL SPRING

HERE IN BUCKET

Rear Conversion



Contact Suncore Industries For How To:

Disarming The “Suspension Warning Message”

Lincoln mk 8 coil spring conversion

Documents

Transcript of Lincoln mk 8 coil spring conversion