LED events use for noisy channels detection

14
1 SB LED events use for noisy channels detection Try on HCAL LED stability run 24432, 10K events

description

LED events use for noisy channels detection. Try on HCAL LED stability run 24432, 10K events. Idea : use LED containing events to check Pedestals : , sigma LED : sigma/ Errors, e.g. -256 ; -999 entries etc - PowerPoint PPT Presentation

Transcript of LED events use for noisy channels detection

Page 1: LED events use for noisy channels detection

1SB

LED events use for noisy channels detection

Try on HCAL LED stability run 24432, 10K events

Page 2: LED events use for noisy channels detection

2SB

Idea : use LED containing events to check Pedestals : <>, sigma LED : sigma/<> Errors, e.g. -256 ; -999 entries etc Noise classified, positive or negative, big (i.e. direct danger to L0) or small (under certain conditions could degrade L0 rate, resolutions etc) amplitude : rate Logic for each channel : Fit pedestal and LED, extract <>, sigma for each of them Classify and count everything which

outside <ped> \pm 10 x sigma_ped &&

outside <led> \pm 10 x sigma_led NB1 : fit failure could signify a problem NB2 : to escape Xtalk, remove event from Pedestal treatment, if one of three channels, coupled to the same ADC, shows big signal

<p>±10

σp

<l>±10σle

d0 32 bigsmallneg

Store warnings and (problematic/all ?) histograms in log-file

Page 3: LED events use for noisy channels detection

3SB

(Close to) Ideal world :  impossible to study noise rate, if pedestal and/or led cannot be fit properly,

i.e. not more than one problem at a time we assume routine running on the debugged hcal  1. Error values : -256 ; -999 ; etc.  2. Pedestal warning if :

meanped > 1.  or meanped   < 0. or σped > 2.

 3. Led warning if :

multiple peaks or σped/meanped  >  5% 

4. Exclude from noise rate counting regions

meanped ± 10 x σped and meanled ± 10 x σled

5. “Big” (L0 dangerous) noise starts from 32 ADC channel

6. Dangerous rate for “big” amplitude noise : 1% , “small” noise : 10%.

Approximation “zero” constants

Page 4: LED events use for noisy channels detection

4SB

Good channel example

Page 5: LED events use for noisy channels detection

5SB

Warning : <ped> = 1.1 sigma = 2.1

Pedestal warning

Page 6: LED events use for noisy channels detection

6SB

Warning : <ped> = 1.2 sigma = 2.1

Pedestal warning

Page 7: LED events use for noisy channels detection

7SB

Warning : Fit failure

Warning : Fit failure

C-side, wrong settings

Page 8: LED events use for noisy channels detection

8SB

Warning : LED chi2

C-side, wrong settings

Page 9: LED events use for noisy channels detection

9SB

Warning : LED : sigma/<led>

C-side, wrong settings

Page 10: LED events use for noisy channels detection

10SB

X-talk ?

Warning : “small” noise

Page 11: LED events use for noisy channels detection

11SB

X-ta

lk ?

Page 12: LED events use for noisy channels detection

12SB

... Checking Pedestal mean and sigma values ...board=386, channel=31, pedChi2=148, pedMean=1.030888, pedSigma=2.185785board=399, channel=24, pedChi2=163, pedMean=1.204062, pedSigma=2.036628board=411, channel=28, pedChi2=1037

... Checking Led sigma/mean values ...Problem LED chi2 : board=388, channel=24, LedChi2=1100Problem LED chi2 : board=388, channel=26, LedChi2=1166Problem LED chi2 : board=389, channel=19, LedChi2=1068

... Checking for -999 ...

... Checking for -256 ...

... Checking for negatives ...Negatives rate (per cent) : board=403, channel=16, Nneg=10.780000Negatives rate (per cent) : board=406, channel=16, Nneg=12.500000Negatives rate (per cent) : board=406, channel=17, Nneg=12.500000Negatives rate (per cent) : board=406, channel=18, Nneg=12.500000Negatives rate (per cent) : board=406, channel=19, Nneg=12.…

Log.dat : example

Page 13: LED events use for noisy channels detection

13SB

Log.dat : example

Negatives rate (per cent) : board=413, channel=22, Nneg=12.500000Negatives rate (per cent) : board=413, channel=23, Nneg=12.500000

... Checking for small positives ...Small positives rate (per cent) : board=411, channel=5, Nsmall=12.470000Small positives rate (per cent) : board=411, channel=6, Nsmall=12.500000Small positives rate (per cent) : board=412, channel=6, Nsmall=11.910000Small positives rate (per cent) : board=412, channel=7, Nsmall=12.490000

... Checking for big positives ...Big positives rate (per cent) : board=388, channel=17, Nbig=11.590000Big positives rate (per cent) : board=388, channel=18, Nbig=10.910000Big positives rate (per cent) : board=388, channel=24, Nbig=8.970000Big positives rate (per cent) : board=388, channel=25, Nbig=11.690000Big positives rate (per cent) : board=388, channel=26, Nbig=11.760000Big positives rate (per cent) : board=388, channel=27, Nbig=8.280000Big positives rate (per cent) : board=388, channel=29, Nbig=6.210000Big positives rate (per cent) : board=389, channel=2, Nbig=11.150000Big positives rate (per cent) : board=389, channel=3, Nbig=11.510000Big positives rate (per cent) : board=389, channel=10, Nbig=11.310000Big positives rate (per cent) : board=389, channel=19, Nbig=11.570000Big positives rate (per cent) : board=389, channel=20, Nbig=9.520000Big positives rate (per cent) : board=389, channel=29, Nbig=9.360000Big positives rate (per cent) : board=390, channel=0, Nbig=8.400000Big positives rate (per cent) : board=390, channel=1, Nbig=11.050000Big positives rate (per cent) : board=390, channel=2, Nbig=11.990000Big positives rate (per cent) : board=390, channel=8, Nbig=5.190000Big positives rate (per cent) : board=390, channel=11, Nbig=11.710000

Page 14: LED events use for noisy channels detection

14SB