KYLIN 250 - HeliPal.comimage.helipal.com/helipal-storm-kylin-250-manual-v1.pdfMicrosoft Word -...

1 Copyright@2015 HeliPal.com. All Rights Reserved

KYLIN 250 Storm Edition

USER MANUAL V1


DISCLAIMER Please read this disclaimer carefully before using this product. This product is a hobby with motors but not a toy which is not suitable for people under the age of 18. By using this product, you hereby agree to this disclaimer and signify that you have read them fully. You agreed that you are responsible for your own conduct and content while using this product, and for any consequences thereof. Before you fly the drone 1) Make sure all connections are good, and keep children and animals away

during flying, firmware update, system calibration and parameter setup. 2) Always fly the drone away from unsafe conditions, such as obstacles, crowds,

high-voltage lines, etc. 3) Do not use in bad weathers such as rainy day, snow, windy (more than

moderate breeze), hail, lighting, tornadoes, hurricanes etc. 4) Check whether the propellers and the motors are installed correctly and firmly

before flight. Make sure the rotation direction of each propeller is correct. 5) Check whether all parts of the drone are in good condition before flight. Do not

fly with aging or broken parts. 6) Never overcharge LiPo batteries. Do not charge above 4.2V per cell. When the

battery is fully charged, disconnect it from the charger. Never leave the battery charger unattended during charging.

7) Never discharge batteries to below 3.3V per cell 8) Remove batteries when not using the drone.


Package includes: 1. Fully Assembled Kylin 250 Storm Edition w/ FPV System (Camera and

Transmitter) 2. RadioLink AT9 Radio System 3. Fully Assembled Kylin 250 Storm Edition w/ FPV System (Camera and

Transmitter) 4. 6pcs 5040 Clockwise Dual-Blade Propeller 5. 6pcs 5040 Anti-Clockwise Dual-Blade Propeller 6. SKYRC E4 Battery Charger 7. 1.5 mm Hex Wrench (for column screws) 8. 2.0 mm Hex Wrench (for motor screws) 9. 10mm Hex Nut Driver Driver (for motor cap) 10. 5.5mm Hex Nut Cross Wrench (for airframe locknut) 11. Extra Canopy X 1 12. 6040 Propellers and Longer Arms for 3S Power (NOT Used) 13. Original Kylin 5040 Propellers (NOT Used) 14. Action Cam Mount (During Promotion Period) 15. Storm custom designed Decal X 1 (During Promotion Period)


Quick Start


How to control


Circuit Diagram


FPV System Our video transmitter has up to 32 different video channels available to avoid interference with other channels.

If two or more drones are flying at the same time, try to select different video frequency to avoid video interference. The bigger different in video frequency between drones, the less interference generated. Always check the supported channels of you FPV reception devices such as monitor, goggle

Frequency Table Frequency Frequency/Channel Frequency Frequency/Channel

5865MHz A1 5704MHz E1

5845MHz A2 5685MHz E2

5825MHz A3 5665MHz E3

5805MHz A4 5645MHz E4

5785MHz A5 5885MHz E5

5765MHz A6 5905MHz E6

5745MHz A7 5925MHz E7

5725MHz A8 5945MHz E8

5733MHz B1 5740MHz F1

5752MHz B2 5760MHz F2

5771MHz B3 5780MHz F3

5790MHz B4 5800MHz F4

5809MHz B5 5820MHz F5

5828MHz B6 5840MHz F6

5847MHz B7 5860MHz F7

5866MHz B8 5880MHz F8

LONG Press for Changing Frequency SHORT Press for Changing Channel

10

FAQ Lost conIf you’re thradio contrbelow:

Press contro

Use the smaPurple, Switcbind process Radio CoIf you rese

1) Press an“PUSH”) Button to g

nnection we drone canroller and re

the switch insl mode to D B

ll screwdriversch on the radi complete and

ontroller Pet your radio

d Hold the cto unlock the

go into basic m

with radionnot responeceiver may

side the receivBus Mode. (Sk

s to press ando controller, itd the radio con

Parameterso controller

controller whee manual. Pre

menu page

o controlnse to the ray lost and yo

ver twice withkip this step if i

d hold the switt will start searntroller will the

s (AT9) settin

eel (With worss and Hold

ller adio controlou can try to

small screwdrit is default in

ch inside the rrching for avaie signal streng

ng, you can

rdings Mode

2) [[

Copyright@

ller stick trao re-bind th

rivers to makePurple light)

receiver until iilable receivergth on the scre

apply the s

[STK-MODE][LockScreen] =

@2015 HeliPa

avel, the conhem by follo

e LED indicato

it is flashing wr. Receiver wileen

setting below

= 2 (Stick Mod= 30s (Time to

al.com. All Rig

nnection bewing the pr

or turns PURP

with light in Blull stop flashing

w:

de) lock screen)

ghts Reserved

tween rocedure

PLE to set the

ue and g while the

d


3) [TYPE] = AIRCRAFT

4) [SELECT] = 01 [NAME] = SRD-CC3D (Any name you want)

5) Go to [AUX-CH] -> ATTITUDE, apply the setting below:

[CH] = CH5 [SW3] = SwG [SW2] = SwD [STABL.] = 0% [STABL.] = 25% [STABL.] = 35% [ARCO] = 50% [ARCO] = 75% [ARCO] = 100%

6) [CH5] = ------- [CH6] = VrA [CH7] = VrB

[CH8] = SwE [CH9] = SwF [CH10] = SwC

7) [1] [TIME] = 10:00 [1] [MODE] = UP [1] [ON][1] = ST-THK (Using Throttle Stick to start the timer) [1][ON] [2] = 15% ( Move the indicator over the value, set throttle stick to around 15%, Press and hold “Push” button to recognize the throttle value and move the wheel to change the arrow sign) [1][RESET] [1] = SwH (Using Switch H to responsible for the reset timer action) [1][RESET] [2] = DOWN (Using Switch H’s down action to reset the timer)

8) [1] [AILE] = NOR [2] [ELEV] = NOR [3] [THRO] = NOR [4] [RUDD] = NOR [5] [ATTI] = NOR [6] [AUX1] = NOR [7] [AUX2] = NOR [8] [AUX3] = REV

KYLIN 250 - HeliPal.comimage.helipal.com/helipal-storm-kylin-250-manual-v1.pdfMicrosoft Word -...

Documents

Transcript of KYLIN 250 - HeliPal.comimage.helipal.com/helipal-storm-kylin-250-manual-v1.pdfMicrosoft Word -...