10100 Hedden Road Evansville, Indiana 47725 812-868-0808

Technical Data Sheet

The above listed nominal values were obtained from specimens molded and tested under carefully controlled laboratory conditions. This data is furnished so that the user will evaluate it through testing and determine the suitability of the product. Since the conditions of application and use of our product are beyond our control, no warranty or representation is expressed or implied regards results from the use of this data. Enviroplas, Inc. will not be liable for any injury or damage arising from the application of this information.

ENV14-A1514R-1000

PC – Polycarbonate Injection Molding Grade, Natural, Impact Modified for Excellent Toughness,

RoHS Compliant Properties Test Method Nominal Value Physical Specific Gravity ASTM D 792 1.20 Melt Flow Rate (300/1.2 kg) ASTM D 1238 15.0 g./10 min. Mold Shrinkage, Linear Flow ASTM D 955 0.005 – 0.007 in/in. Mechanical Tensile Strength @ Yield ASTM D 638 8,700 psi (60.0 MPa) Elongation @ Break ASTM D 638 130 % Flexural Strength ASTM D 790 12,000 psi (82.7 MPa) Flexural Modulus ASTM D 790 325,000 psi (2,241 MPa) Impact Notched Izod Strength @ 73 °F ASTM D 256 14.5 ft-lb/in. (773.6 J/m) Thermal Heat Deflection Temp. @ 264 psi ASTM D 648 255 °F (124 ˚C) Flammability Flame Rating UL 94 HB @ 0.125 in. Processing Recommendations Drying Conditions Minimum Recommend Time 3 to 4 hours @ 230 °F (110 °C) Processing Temperature Profile Cylinder Rear (Zone 1 Hopper) 500 – 535 °F Middle (Zone 2) 510 – 560 °F Front (Zone 3) 520 – 580 °F Nozzle (Zone 4 Nozzle) 510 – 575 °F Mold 155 – 200 °F Processing Parameters Injection Speed Moderate to Fast Back Pressure 70 – 150 psi Screw Speed 40 – 70 rpm