INTRODUCTION Available CLS Cas 3 floodlights Cas3 manual.pdf · 2010. 10. 6. · CLS ManualsCLS...
Transcript of INTRODUCTION Available CLS Cas 3 floodlights Cas3 manual.pdf · 2010. 10. 6. · CLS ManualsCLS...
-
CLS Manuals
CLS Atmosphere LED-panelCLS Manuals
CLS Cas 3 Luxeon III / K2
www.cls-led.com
version 2.0 June 2009
www.cls-led.com- 1 - - 2 -
CLS Cas 3 Luxeon III / K2
INTRODUCTIONThank you for choosing the CLS Cas 3 inground floodlight. The CLS Cas 3 floodlight is a compact but yet powerful inground floodlight for numerous applications. the unit can be used for lighting up all sorts offacades, objects and landscape lighting projects.
Included itemsThe CLS Cas 3 is shipped in one package containing the following items:• 1 x CLS Cas 3 inground floodlight• 1 x manual
Optional accessories• CLS mold set, straight 8-26mm (item nr. 871992)• CLS Cas 3 sleeve (item nr. 8721553)• CLS Cas 3 frosted frontglass (item nr. 8721556)
Note: It is important to read this manual before you install this product.
SAFETY INFORMATIONWarning! This product is for professional use only, not for domestic use.Read this manual before powering up or installing the CLS Cas 3. Follow the instructions listed below and observe all warnings in this manual.
Protection from electric shock• Disconnect the power supply from AC power before installing, dismounting or maintaining the unit.• Make sure all connectors are connected properly.• Use only a source of AC power that complies with local building and electrical codes and has both overload and ground-fault protection.• Refer all service to a qualified technician.
Available CLS Cas 3 floodlights• CLS Cas 3, 3 x Luxeon III royal blue, flood (45º) (item nr. 8721560)*• CLS Cas 3, 3 x Luxeon III cold white, flood (45º) (item nr. 8721563)*• CLS Cas 3, 3 x Luxeon III amber, flood (45º) (item nr. 8721565)*• CLS Cas 3, 3 x Luxeon III green, flood (45º) (item nr. 8721567)*• CLS Cas 3, 3 x Luxeon III red, flood (45º) (item nr. 8721569)*• CLS Cas 3, 3 x Luxeon K2 extra warm white, 3150K (WW3), flood (45º) (item nr. 8721571)*
*Available in Spot (15º) version, MOQ is 50 pcs
-
CLS Manuals
CLS Atmosphere LED-panel
www.cls-led.com- 3 - - 4 -
CLS Cas 3 Luxeon III / K2
INSTALLATIONThis section shows how to install the CLS Cas 3.
ATTENTION!TO prEvENT dAmAgE TO ThE CLS CAS 3, uSE ThE CLS CAS 3 SLEEvE. mAkE SurE drAINAgE CONdITIONS ArE AdEquATE.ThESE prECAuTIONS muST bE fOLLOwEd, OThErwISE ThE guArANTEE wILL bECOmE INvALId!
WAR
NING
DrainageTo minimize the risk of flooding or water logging, install the fixture in a location which is above the level of the surrounding area, and make sure drainage conditions are adequate. CLS recommends to use gravel for the best drainage conditions. The unit is not designed to withstand high pressure water jets.
Protection from burns and fire• Do not install the CLS Cas 3 near a heat source.• Do not install the CLS Cas 3 in a corrosive, flammable or explosive area.• Do not modify the CLS Cas 3, or install other than genuine parts.• Do not operate the CLS Cas 3 if the ambient temperature exceeds 40º C.
Protection from injury due to falls• Verify that all covers and mounting hardware are securely fastened.• Block the access below the work area whenever installing or removing the unit.
CAbLE INSTALLATION
Cable slackAllow at least 400 mm of free cable in the installation, so that the fixture is clear for service without disconnecting cables.
NOTE!For protection from potentially lethal electric shock:
• The CLS Cas 3 must be grounded.• The AC-power supply must be fitted with a fuse or circuit breaker, ground-fault protection, and a means to isolate the fixture from power during service or when not in use.• Cables and fixtures must be isolated from power, and steps taken to prevent reconnection, before carrying out any work on them.• Do not connect the CLS Cas 3 to an electrical dimmer system: doing so can damage the electronics.
Connecting to AC-powerConnect the power cable only on the right positions! See diagram for the colours of all electric cables:
Wire (EU) Function MarkingBrown Live LBlue Neutral NYellow/green Earth
Obstruction by rootsThe further the fixture is located from vegetation such as trees, hedges or bushes, the less chance there is that the roots will obstruct the fixture or even cause damage to its cables. If the fixture is located close to vegetation, consult a landscape architect about the solutions for the root obstruction.
-
CLS Manuals
CLS Atmosphere LED-panel
www.cls-led.com- 5 - - 6 -
CLS Cas 3 Luxeon III / K2
25 mmø 28,5 mm
ø 104 mm
138 mm118,5 mm
19,5 mm
ø 70 mm
ø 150 mm
MEASUREMENTS
Cas 3
Cas 3 sleeve
Install example
Disassemble the stainless steel ring from the CLS Cas 3 by loosening the 4 screws.
Assemble the stainless steel ring back on the Cas 3 unit. The Cas 3 is ready to be installed.
To install the Cas 3 into the sleeve, tread the wire trough one of the holes on the side. Slide the Cas 3 unit inside and secure it in the screw holes.
Install the Cas 3 into the ground. Finish the surface around the fixture with gravel. Ensure that the foundation will withstand pressure on the fixture.
-
CLS Manuals
CLS Atmosphere LED-panel
www.cls-led.com- 7 - - 8 -
CLS Cas 3 Luxeon III / K2
TEChNICAL SPECIFICATIONSLED: 3 x Luxeon® III or K2Available colours: Luxeon III: royal blue, cold white, amber, green, red Luxeon K2: extra warm white, 3150K (WW3)Lenses: Spot (15°) or Flood (45°)Power supply: 110 ~ 240 VACPower consumption: max. 9 VAWeight: 1,5 Kg IP value: IP65Cable length: 3 metersMeasurements: ø Top: 142 mm - ø inground: 98 mmAmbient temperature: -20º till +40º CMax. pressure: 15 kg/cm2
Multiple connectionPossiblities on a fixture
Installation depthIn centimeters
SwivelFixture is horizontally rotatable, indicated in degrees
SwivelFixture is vertically rotatable,indicated in degrees
Mounting holeIn centimeters
Application areaIndoor or outdoor
Application areaFloor, wall or ceiling
Protection classOne, two or three
350º
350°
Cable lengthMaximum cable attachedon the fixture in centimeters
LifespanOf the light source in hours
DriverInclusive or exclusive
PressureMaximum pressure on the fixture per kg/cm2
WeightIn gram/kilogram
CurveMinimal bending curvein centimeters
Driver
Incl.
10.000 h
Driver
Excl.
200 cm
6 cm
LED pitchPitch between the LEDs in millimeters
20 mm
15kg/cm2
4x4 cm4 cm
4 cm4 cm
4 cm
List of symbols
2007 CLS-LED BV. All rights reserved. Information subject to change without notice, CLS-LED BV and all affiliated companies disclaim liability for injury, damage direct or indirect loss, consequential or economic loss or any other loss occasioned by the use of, inability to use or reliance on the information contained in this manual. No part of this manual may be reproduced, in any form or by any means, without permission in writing from CLS-LED BV. Other legal information can be found in our General conditions to be found on the back of your CLS-LED BV invoice or on our website www.cls-led.com/Conditions.pdf