To knob

To box

25mm

19mm

Installing a lever and knob

1

2

Clamp

Use Cap (1) and Rubber strips (2) for protecting table

Mounting plate

(1) Remove clamp (Use free screws in Pos. 3,4)(2) Install mounting plate

1

2

Pos. 1

Pos. 2

Pos. 3

Pos. 4

40,00 мм

24,0

0 м

м

115,0

0 м

м

63,70 мм

Ø 5-5,5

M5 Screw length inside the box: 14-20mm

Scale 1:1Top view

1

Handbrake

(1) Press small black button on back side to switch Analog (Axis) and “ON-OFF” mode.

Calibration Analog mode.Stay in Analog mode. Hold button (1), wait 2 sec, LED start blinking, keep going hold button into position, push handle on 100% of the way and then release button. Calibration is done.

Calibration “ON-OFF” mode.Stay in “ON-OFF” mode. Hold button (1), wait 2 sec, LED start blinking,keep going hold button into position, move handle in position where you want the handbrake to start working, and release button. Done.