Installation of heating cables, a light and an outlet with a thermostat and two pole circuit...
-
Upload
amice-mcbride -
Category
Documents
-
view
215 -
download
0
Transcript of Installation of heating cables, a light and an outlet with a thermostat and two pole circuit...
English
By Bjørnar, Øystein and Thomas
Installation of heating cables, a light and an outlet with a thermostat and two pole circuit breaker
The Fuse box The fuse box wiring starts with three
phases. They pass trough the main fuse and the
kW/h measurer. There is no earth switch in this box since
every circuit has its own fuse with a built in earth switch.
The fuses job is to protect the cable from getting fried during over charge and short circuit.
On the top we have the earthtrack
Wall box
These red boxes are used as a mount point for switches, thermostat, dimmers and timers.
If you look on the box on the right the one with the thermostat there is two yellow and green wires. There is a red cap on them it is called a Torex and it twists two or more wires togetter to create a good connection.
Heating cables
These are heating cables. They are installed under the floor. After installation a mass of some
substance is put on top before the floor is covered.
You need to be carful so you don’t break the cable.
We need Mario
In this picture we found an error. The pipe is not properly attached
to the box. If this happened in real life then
we are screwed, then we can not pull the wire through the pipe.
The Light
In these red boxes we can also attach light sockets. Usually we use the white boxes with a bit wider radius and a bit shorter width.