Installation Instructions

Supplemental instructionsFor Tubbies & Clamps

Manufactured after May 2014

2

1.

3.4.

Unlatch nut (1) and clamp (2) locking tabs. Then unscrew wingnut (3) completely. Remove E-Clip (4) with a pair of pliers by pulling straight out of the grove.

Pull both halves of saddle clamp apart. Place clamp around the neck of the tubbie with the tapered side up and the flat side toward the tubbie as shown. Once both halves are around the neck of the tubbie, release the clamp halvesmaking sure the thread bolt and retaining studs slide easily into their respective holes.

3.

4

Line up E-Clip (4) with the retaining stud grovepush firmly into place until clip is seating in thegrove. Thread wingnut half way onto threaded stud.See opposite side of instructions for clamp mountingprocedure.

Installation Instructions

Unlatch nut (1) and clamp (2) locking tabs. Then unscrew wingnut (3).

Line tubbie up with the PCB mount on the top of the tubbie clamp. Then push down firmly until clamp snaps in place.

2

1.

3.

2.

3.

1.

Clamp locking tab (2) *MUST* be latched before tightening wingnut (3)

Supplemental instructionsFor Tubbies & Clamps

Manufactured after May 2014

Tighten clamp wingnut (3). Then close nut locking tab (1).

The tubbie mounting system clamps were improved so the saddle clamp would never have to be taken off the tubbie. This makes the tubbie much easier to install. You need to snap the tubbie into place and tighten. To rotate the tubbie you only need to undo locking tab (1) and loosen the wingnut (3).Models affected by this change are:MT8100B, MT8100W, MT8265B, MT8265W, MT81LKB, MT81LKW, MT-CL3-S, MT-CL2-S, MT-CL2-B