1PERMACON.CA

21 3/4"115 1/2"

30"

A x 2

B x 6

A

B

PERMACON.CA

21 3/4"21 3/4"115 1/2"

30"

A x 2

B x 6

A

B

#MYPERMACONPROJECT INSTALLATION GUIDE

BENCHINSTALLATION GUIDE FOR BENCH WITH SKYLINE WALL BLOCKS

72 SKYLINE WALL BLOCKS

PRESSURE TREATED WOOD BOARDS

8 12-INCH SQUARE SLABS

SUGGESTED TOOLS AND EQUIPMENT

REQ

UIR

ED M

ATER

IALS

ADDITIONAL MATERIALS NEEDED

COLOUR

DORSET GREY

4 x 5 3/4 x 16 in. (102 x 146 x 406 mm) (H x D x L)

– Safety glasses

– Gloves

– Tape measure

– Level

– Rubber mallet

– Shovel

– Wheelbarrow

– Hand tamper (or plate compactor)

– Concrete adhesive

– Crushed stone 0-3/4 in. (0-20 mm)

– Wood deck screws

Visit permacon.ca to view the installation video. 2 x 4 x 18 1/4 in.

4 x 4 x 72 in.

GREY

SUGGESTED COLOUR

12 x 12 in. (300 x 300 mm)

COLUMN ACOLUMN B

CUTTING

REQ UIRED!

22

INSTRUCTIONS

These plans walk you through each step as you prepare, assemble and enjoy the new addition to your yard.

RESPONSABILITIES

It is the responsibility of the owner to ensure compliance with all applicable laws, codes and regulations for any project. Proper safety precautions must be taken prior to and during the construction of each project. Please follow standard safety guidelines and wear necessary protective equipment when building your new outdoor addition.

FOUNDATION

A solid foundation is necessary to prevent the collapse of a project. We recommend preparing a granular foundation that is deep enough and properly compacted. It is important to pay attention to the water management around the structure to ensure proper drainage.

TIPS FOR BUILDING LEVELING PADS

FOUNDATION

Choose the final location of your project: temporarily place a row of Skyline walls. Once marked, remove the Skyline walls and dig a zone of 12 inches minimum (300 mm) deep. Extend the surface line by 6 inches (150 mm) on all sides. NOTE: for clay soil, we recommend to increase the depth to resist seasonal frost.

Spread 10 inches (254 mm) of crushed stone 0-3/4 inch (0-20 mm) then level and compact. Install a first row of Skyline wall. This first row should sit 1 to 2 inches below grade to help prevent shifting.

TIPS FOR SECURING BLOCKS

Before securing the blocks with the concrete adhesive, place temporarily a row of blocks.

Remove small sections at a time to apply beads of concrete adhesive at multiple places under each block

#MYPERMACONPROJECT INSTALLATION GUIDE

33

Apply beads of concrete adhesive where Skyline wall units will be placed. Continue this process through row 7.

The first row of Skyline wall should sit 1 to 2 inches below grade to prevent shifting.

Glue each unit with concrete adhesive. Repeat previous steps through row 7.

6 SKYLINE WALL BLOCKS

6 SKYLINE WALL BLOCKS

6 SKYLINE WALL BLOCKS

6 SKYLINE WALL BLOCKS

ROW 2

ROW 4

ROW 1

ROW 3

#MYPERMACONPROJECT INSTALLATION GUIDE

COLUMN A

44

4 SKYLINE WALL BLOCKS

4 SKYLINE WALL BLOCKS

4 SKYLINE WALL BLOCKS

4 12 x 12-inch SLABS

ROW 6

ROW 8

ROW 5

ROW 7

#MYPERMACONPROJECT INSTALLATION GUIDE

5

60 1/2"

5

60 1/2"

#MYPERMACONPROJECT INSTALLATION GUIDE

COLUMN A

COLUMN B

To verify that the columns are parallel, measure the distance between the two columns at several places.The distances should be equal.

66

6 SKYLINE WALL BLOCKS

6 SKYLINE WALL BLOCKS

6 SKYLINE WALL BLOCKS

6 SKYLINE WALL BLOCKS

ROW 2

ROW 4

ROW 1

ROW 3

#MYPERMACONPROJECT INSTALLATION GUIDE

COLUMN B

77

4 SKYLINE WALL BLOCKS

4 SKYLINE WALL BLOCKS

4 SKYLINE WALL BLOCKS

4 12 x 12-inch SLABS

ROW 6

ROW 8

ROW 5

ROW 7

#MYPERMACONPROJECT INSTALLATION GUIDE

8

60 1/2"

8

60 1/2"

#MYPERMACONPROJECT INSTALLATION GUIDE

COLUMN A

COLUMN B

9

B

72"

6 X A

5,75"

1,5"

2 X

9

B

72"

6 X A

5,75"5,75"

1,5"1,5"1,5"

2 X

STEP 2

STEP 4

STEP 1

STEP 3

#MYPERMACONPROJECT INSTALLATION GUIDE

24 X WOOD DECK SCREWS

Apply concrete adhesive at each end of the bench.

BENCH INSTALLATION

1010

COMPLETED PROJECTSTEP 5

#MYPERMACONPROJECT INSTALLATION GUIDE

Install the bench. Enjoy your new bench.