Hybrid solar and wind street light
Transcript of Hybrid solar and wind street light
Hybrid Solar & Wind Street Led Light
A hybrid solar & wind street light system included : solar panel, wind turbins,LED Light source,
battery, controller, pole, frame, battery box, etc.
1
Street Led Light 2*28W
A. LED light source luminous flux: Our LED chip is American Bridgelux 140LM/W, but usually it’s only 80~90lumens in the market. For example, our 60W light, totally 7200LM (60W*120LM/W=7200LM ), can get same brightness as 90W from other supplier. ( 90W*80LM/W=7200LM ) That is to say, if same brightness, our light power is at least 30% lower than other manufactures, so for solar light, it will directly lower the configuration of whole system, and finally to save more money for clients!
B. Spec. in details:
Rated
Power Led Chip
Led
Quantity
Color
Temperature Input Frequency
Power
Factor
Total
Harmonic
Distance
Lamp’s
Efficiency IP Grade
56W Brightlux
1W/pc 28 5000-5500K DC 24V 50-60Hz >0.97 < 15% >92% IP65
Life Time Environment Material Pole Height Central
Illumination
Pole to
Pole
Lamp
Base Size(mm)
Net
Weight Gross
>50000Hrs -30 ~ 65 Alloy 8m 30lux(8m) 35m E40 1450*60*45 10kgs 11.5kgs
C. More Pic for reference:
2
LED street light controller with RS232 connector
Features:
1. Independent Boost Circuit: Solved the
charging efficiency of the low-power vertical
wind generator.
2. MPPT charging way, make sure power max.
input to battery and high charging efficiency
obtained
3. 12V/24V System Automatic Recognition function.
4. Data communication with computer, we would offer software as your demands,
5. Install Remote Meter (purchased separately ) and data-communication wire if required.
Refer to the instructions provided for detailed installation procedures.
3
Wind Turbine Generator 600W
4
12V 200Ah Battery ( Spec.) 1. The positive grid is made of special multi[grid alloy,which
can effectively prevent the loss of early battery capacity,standby use the recycling with longer life.
2. To use the high purity of raw and supplementary materials,
special manufacturing process, which make product self-discharge rate very low, with stable performance, good resistance to deep discharge.
3. Formula of special active substance and copper circular terminal structure, the battery can be applied to the operating requirement of high-current discharge.
4. Formula of unique high and low temperature lead paste which make good charge acceptance.
5. By controlling the process of raw material and special craft, the batteries have same good
performance, stable performance, which can be used in the voltage of 48V,220V,220V,380W or any voltages.
� Specification type and Outside dimension
Type Rated voltage
Rated Capacity Outside dimension(mm)
Weight (kg)
L W H Hmax C20 hr C10 hr
6-FM-200 12V 214 200 522 240 218 224 64.10
� Each performance parameter
Temperature
Discharging Temperature -35~55℃
Charging Temperature 0~40℃
Storage Temperature -20~40℃
Working Condition -10~40℃ � Charging Mode
Applied Range
Charging Mode Charging Voltage (25℃)
Factor of temperature
compensation
Max.Charging Current
Charging Time (25℃)
Standby Use
Constant voltage
13.5-13.8V -18mV/℃ 60A 100%
charging 50%
charging
Cycle Use
Constant-current limited voltage
charge 14.4-14.7V -30mV/℃ 60A
24h 12h
16h 8h
5
Mono Solar Panel 180W *2
� Electrical Characteristics
Module Type JMSP NES72-180M
Max.poweratt(Peak) Pm(W) 180
Power tolerance (%) 0~3%
Max.system voltage (VDC) 1000
Max.power voltage Vmp (V) 36.10
Max.power current Imp(A) 4.99
Open circuit voltage Voc(V) 45.10
Short circuit current Isc(A) 5.35
� Mechanical Characteristics
Number,type,and
arrangement of cells 72pcs. Monocrystalline silicon (6×12)
Cell Size mm 125×125
Dimensions:
Length*Width*Height mm 1580×808×45
Weight Kg 15.5
Cable type, Diameter and
Length
Copper core cable, 4mm2,TUV
certified,900mm
Frame(type, material) Aluminum Alloy
Front glass High Transmission, Low Iron, Tempered
Glass,3.2mm
6
� Absolute Ratings
Dielectric Insulation Voltage VDC 3000 max
Operating Temperature ℃ -45~+85
Storage Temperature ℃ -45~+85