HP C7000 Configuration Guide

Wedo Information Technology Co.,Ltd

August/2014

Contents

1 HP C7000 Configuration ............................................................................................................ 3

1.1 Set IP of OAs .................................................................................................................. 3

1.2 First time setup wizard .................................................................................................. 4

2 VC Configuration ..................................................................................................................... 10

2.1 Initial VC ...................................................................................................................... 10

2.2 Config VC ..................................................................................................................... 13

1 HP C7000 Configuration

1.1 Set IP of OAs

Use hp c-class blade server OA to set onboard administrator card

1. Choose “enclosure settings”

Set “OA1 IP Address=10.66.22.10, mask=255.255.255.0, gateway=10.66.22.1”, after

that done, accept all. Set OA2 IP by the same way.

1.2 First time setup wizard

Open IE, Login into OA by the IP which configurated before ( username and password

is associate with OA module)

Follow the “first time setup wizard”

Next

Next

Set time and time or NTP server for Rack and Enclosure Settings

Next

Next

Set IP Address for Blade server and Flex Fabric, 3210X and flex10

Next

Use static ip address for each Active Onboard Administrator

We have 2 OAs, they work on A/S mode.

Next

Next

Next

Finish

2 VC Configuration

2.1 Initial VC

Note: if you set ip of VC failed, you can not see “Management Console”

Login VC”https://10.66.22.12/html/index.html”

If VC is never configurated before, then you go through the “virtual connect manger

domain setup wizard”

Input username and password, the click Next

Next

Next

Next

Finish

2.2 Config VC

”shared uplink sets”. At first, we need to set up uplink group for blades. In this case,

we set 4 port into a uplink group from each flex switch(total 4), but we only use 2 of

them.

Set” uplink set name” then add port from each bay to this uplink group

Associate with VLANs (Note: for each uplink group we have to add VLANs to it, so that

VLAN can go through the VC)

Set up other uplink group just like what you have done before

Go to “server profiles”

Click” mutiple networks ’. You split 1 port into 4 NICs, just add many Ethernet

adapter,then apply.

Select VLAN

Move the VLANs from left side to right side for” multiple networks”

Set speed. If you split 1 port to 4 NICs, they we share bandwith. Right here we need to

assign 1G for vlan 166, 6G for vlan 168, and 3G for Multiple networks( which are vlan

170 and vlan 172)

Set up other server profiles just like what you have done before. When you done all of

those, power on blade server.