How To Setup KAS S1 Gateway

STEP 1 - Download LockKeeper App:

Android – Scan QR code

iOS – Scan QR code

STEP 2 - Setup and Configure Gateway:

Scan QR to view latest online guides There are two ways to setup the S1 Gateway. Please follow the instructions relevant to your wiring requirements. Note: You only need to follow one method.

PoE Option: (LAN + Power Over Ethernet) WIFI Option: (DC Plug + WIFI) Step 1: Power up Plug the LAN cable into the base of the gateway as pictured.

Step 1: Power up Plug the PC Plug into the base of the gateway as pictured.

Step 2: Activate with App You will see a solid RED LED to notify you that the gateway is powered and in config mode.

• Login to LockKeeper and go to the Setup Tab. • Click the Gateway factory number to activate it. • For example GWS00163

Step 2: Activate with App You will see a solid RED LED to notify you that the gateway is powered and in config mode. Login to LockKeeper and go to the Setup Tab. Click the Gateway factory number to activate it. For example GWS00163

Step 3: No action necessary The gateway will automatically assign a dynamic IP address and connect to the network. Note: The LAN network must be DHCP enabled.

Step 3: Configure WIFI network Enter your WIFI network SSID parameters and click config.

Step 4: Done Flashing Green LED will notify you that gateway is connected to the network. Red LED will remain solid.

Step 4: Done Flashing Green LED will notify you that gateway is connected to the network.

Legend

Red Solid LED: Config mode

Red Flashing LED: Connecting to the internet

Green Flashing LED: Connected

How To Reset KAS S1 Gateway

To config the gateway (WIFI option only)

• Short press (1 second) and the gateway will drop the current WIFI parameters. • Return to the app and click ‘config’ to enter new WIFI parameters.

To reset the gateway (WIFI or PoE options)

• Long press the button (>3 seconds) on the side of the gateway. • Upon factory reset the red LED will pulse once. • This will reset the gateway to factory defaults

Important Remarks:

• The gateway will automatically scan and discover for nearby activated locks. You do not have to connect the gateway directly to any lock.

• If you move a gateway position far away from an activated lock, it will automatically drop that connection and start new ones with other nearby locks.