IINSTALLATION MANUAL: NSTALLATION MANUAL: Front Spoiler with integrated DRL for Smart Front Spoiler with integrated DRL for Smart FortwoFortwo W451W451

All work should be performed with the utmostcare to avoid damage.

Please check that the parts listed are completebefore starting work.

For the painting of the front spoiler no specificinstructions have to be followed.

Parts list:1 x Frontspoiler with integrated DRL1 x Stretch grill2 x Metal brackets8 x Screws4 x Rosettes1 x Cable1 x Fuse1 x Terminal1 x Nylon Cable Ties

Fig. 1: Front view Smart W451 withSmart Power Design Frontspoiler

www.smart-power-design.com

2. Remove a fitting portion of the underbodyprotection about of 4 cm. whole by cutting it out (see Fig. 4)

Fig. 43. Fasten the stretch grill on the underbody protectionwith the two long screws and rosettes (see Fig. 5 )

Fig. 5: Fastening the stretch grill

Instructions:1. Remove the original front spoiler:a.) Unfasten the front spoiler with the screws at positions 1 and 2 (see Fig. 2)b.) Unclip the fastening buttons 1 to 6 on the front spoiler (see Fig. 3)c.) Pull the front spoiler away to the outsided.) Remove the plastic cover of the fog lamp.

Fig. 2: Screws 1 and 2

Fig. 3: Fastening buttons 1 to 6

IINSTALLATION MANUAL: NSTALLATION MANUAL: Front Spoiler with integrated DRL for Smart Front Spoiler with integrated DRL for Smart FortwoFortwo W451W451

www.smart-power-design.com

4. Mount the new frontspoiler:a) Insert the front spoiler b) Clip in the fastening buttons 1 to 6 on the front spoiler (see Fig. 3)c) Instructions installing of DRL:• We attach the harness and run the cables individually carefully into the interior of the car, through the rubber seal (see photo 7) by opening a hole.• We unscrew the insurance box (SAM) and we connect the red connector with the gray/green cable (see photo 9).• After that we connect the pink connector with the yellow cable and then connect with the red connector. We screw the insurance box (SAM) again.• We connect the supplied PIN with the white cable and we tuck in the fuse box. Then we tuck the fuse box in positions place 1 to 4 (see photo 8) and then we put the fuse to the fuse box.• We screw the black cable to a screw which is at driver‘s ground floor at the left side, almost under the fuse box.• Finally we close the plug of the daytime running lights.d) Screw the front spoiler with the two metal brackets the six screws and two rosettes supplied at positions 1 and 2 (see Fig. 6)f) Press the plastic cover of the fog lamp backward.

Bild 7Fig.7

Bild 8Fig.8

Bild 9Fig. 9

1-4

IINSTALLATION MANUAL:NSTALLATION MANUAL:Front Spoiler with integrated DRL for Smart Front Spoiler with integrated DRL for Smart FortwoFortwo W451W451

www.smart-power-design.com

Fig. 6: Stabilizing with metal brackets

Make sure that all the parts supplied have beeninstalled .

IINSTALLATION MANUAL:NSTALLATION MANUAL:Front Spoiler with integrated DRL for Smart Front Spoiler with integrated DRL for Smart FortwoFortwo W451W451

www.smart-power-design.com