How to configure Linksys WRT-120N wireless Access-Point(AP) router

1. Your AP router config parameters can be found taped on top of your AP router

3. Connect AP’s Ethernet port-1 to your laptop with a Ethernet cable

2. If you press down the reset button for 5 seconds, it will reset to factory defaults, in which case, you will need to go through this slides to configure it again to be functional.

4. This port should connect to the internet

1. Open a browser, type in URL http://192.168.1.1, use the admin pwd to login. If you reset to factory defaults, search the user manual for the default admin pwd.

2. Configure the host name and domain name the same as your AP’s name. e.g. ParkmontCR13

3. Configure the static DNS server IP address. Please leave these area blank.

4. Click “Save Settings”, the AP will reset itself for about 30 seconds

7. Type in the AP’s name as SSID, e.g. ParkmontCR13. The rests are the same as defaults.

6. Click on the “Wireless” tab, choose “Basic Wireless Settings” sub-tab.

8. Click Save Settings

9. Click on the Wireless Security sub-tab

10. Choose “WPA Personal” as Security Mode

11. Enter your AP’s encryption key.It should be taped on the back of your wireless router/AP.

12. Click Save Settings. You’re done.The rests are the same as defaults.