Horizon Hobby - Blackjack 24 RTR Radio Tray …...Contact Horizon Hobby Product Support if you have...

1
Blackjack 24 RTR Radio Tray Addendum Inspect Radio Tray: November 18, 2014 Products: PRB Blackjack 24 (PRB08007) Issue: Some boats may have loose radio trays. What to Do: Inspected radio trays are marked with a green dot as shown in this photo and are correct. If there is no inspection mark, check to make sure the radio tray is firmly attached to the hull. Contact Horizon Hobby Product Support if you have any questions. 1. Pulling on the battery straps may loosen the radio tray from the hull. 2. If the radio tray becomes loose, apply CA (cyanoacrylate adhesive) between the tray and the hull as shown in these photos. IMPORTANT: The motor is connected to the shaft, holding the tray in the hull. Carefully lift the tray while applying adhesive. NO action necessary Carefully lift the radio tray up and apply CA between the tray and Hull Battery straps Green Dot ©2014 Horizon Hobby, LLC. Pro Boat, the Pro Boat logo, Blackjack, and the Horizon Hobby logo are trademarks or registered trademarks of Horizon Hobby, LLC. Created: 11/2014 47593 Correct Glue radio tray to hull in these spots

Transcript of Horizon Hobby - Blackjack 24 RTR Radio Tray …...Contact Horizon Hobby Product Support if you have...

Page 1: Horizon Hobby - Blackjack 24 RTR Radio Tray …...Contact Horizon Hobby Product Support if you have any questions. 1. Pulling on the battery straps may loosen the radio tray from the

Blackjack 24 RTR Radio Tray Addendum

Inspect Radio Tray:

November 18, 2014

Products: PRB Blackjack 24™ (PRB08007)

Issue: Some boats may have loose radio trays.

What to Do: Inspected radio trays are marked with a green dot as shown in this photo and are correct. If there is no inspection mark, check to make sure the radio tray is firmly attached to the hull.

Contact Horizon Hobby Product Support if you have any questions.

1. Pulling on the battery straps may loosen the radio tray from the hull.

2. If the radio tray becomes loose, apply CA (cyanoacrylate adhesive) between the tray and the hull as shown in these photos.

IMPORTANT: The motor is connected to the shaft, holding the tray in the hull. Carefully lift the tray while applying adhesive.

NO action necessary

Carefully lift the radio tray up and apply CA between the tray and Hull

Battery straps

Green Dot

©2014 Horizon Hobby, LLC. Pro Boat, the Pro Boat logo, Blackjack, and the Horizon Hobby logo are trademarks or registered trademarks of Horizon Hobby, LLC.

Created: 11/2014 47593

Correct

Glue radio tray to hull in these spots