HL_1600Ev1

1
SPARE PARTS SPECIFICATIONS Bulb: 6V-2.4W Halogen Bulb Battery: Ni-Cd / Ni-MH Charger: CAT EYE Battery Charger CHR-105 / 145 Operation time: Ni-Cd: ........... 2.5 hours Ni-MH: ......... 4 hours Alkaline: ........ 4 hours Charging time: 8 - 10 hours Temperature Range: Charging: ...... 0˚C ~ 40˚C Operating: .... –15˚C ~ 45˚C Recharge/Discharge Number of Times: More than 500 times (until rated capacity drops to 50%) *The specifications and design are subject to change without notice. LIMITED WARRANTY 1- Year Warranty: Only Lamp Unit And Battery Charger (Excluding bulb and battery) If trouble or damage occurs during normal use, the product will be repaired or replaced free of charge. Type your name, address, date of purchase and the situation of trouble clearly, and send it back to the appropriate service center together with the product. Insurance, handling and transportation charges shall be borne by the customer. After being repaired or replaced, the product will be shipped back to the customer. Address for the service: 2-8-25 Kuwazu, Higashi sumiyoshi-ku, Osaka 546-0041 JAPAN Attention: CAT EYE CO., LTD. Customer Service Section Phone: 81-6-6719-7781 Fax: 81-6-6719-2362 Service & Research Center 1705 14th St. #115 Boulder, CO 80302 Phone: 303-443-4595 Toll Free: 800-5CATEYE(800-522-8393) Fax: 303-473-0006 e-mail: [email protected] Web site: http://www.cateye.com Design Pat. Pending Copyright© 1999 CATEYE Co.,Ltd. Printed in Japan HLM16K-990507 0688361 2web FOR SAFE OPERATIONS (IMPORTANT) The lamp body becomes extremely hot when turned on. Never touch the lamp body or lens until thoroughly cooled. Injury may result. • This lamp kit is not intended for use by young children or infirm persons without supervision; young children should be supervised to ensure that they do not play with this appliance. Never short-circuit the plug of the battery charger. It may cause the battery to overheat, resulting in fire or damage of the components. • Use only the included battery charger for charging. • Safely dispose of the old battery when it comes to the end of its useful life. Never mix different types of batteries or old / new batteries together. • Although dry batteries can be used, never recharge them. • Overcharge may cause the battery trouble. • Avoid leaving the battery under direct sunlight. It may cause the battery leak. • A long period of non-use will lower the voltage of the battery due to natural self discharge. Always charge the battery before using. • If the cord of the battery charger or other parts are damaged, it must only be replaced by the shop where this lamp kit was pur- chased, because special purpose tools are required. • The charger may become hot during recharging. • The charging time may vary depending on the use environment. If the battery does not serve the proper run time even after it is fully charged, it may be at the end of it's useful life. Replace it with a new one. HOW TO CHARGE If the batteries are not inserted, please see "How To Replace The Battery".) When the indicator of the lamp body turns red, it means the battery voltage is lowered; recharge the battery. The factory-loaded battery is not charged. Open the jack cover on the bottom of the lamp body and connect it with the plug of the charger. Plug the charger with the home power outlet. Use only the provided battery charger. Never recharge dry batteries. Make sure to close the jack cover after charging. Using CHR-105 Charger This charger is only for Ni-Cd batteries. It takes 8-10 hours to be full- charged. Unplug the charger after charging. Using CHR-145 Charger This charger is for Ni-Cd and Ni-MH batteries. The indicator is on during charg- ing. When the battery is full-charged, it will start flashing.(It takes 8-10 hours.) HOW TO REPLACE THE BATTERY AND THE BULB Loosen the screw on the bottom of the lamp body and remove the upper body. A Battery Insert the batteries as the picture shows. Make sure of the correct polarity. Never mix different types of batteries or old / new batteries together. B Bulb Take out the lens component. Remove the bulb holder and replace the bulb with a new one. Insert the bulb aligning the gap of the clasp with the projection of the lens component. Do not touch the bulb and the reflective mirror with bare fingers. Use only the CAT EYE halogen bulb. Rechargeable Headlamp HL-1600KIT INSTRUCTION MANUAL CHR-105 Charger (Only for Ni-Cd batteries) CHR-145 Charger (Both for Ni-Cd and Ni-MH batteries) Indicator Flashing of the indicator means full-charged. HOW TO ATTACH THE BRACKET AND THE LAMP BODY T O MOUNT : Adjust the bracket using the rubber pad and fix it with the screw. T O REMOVE: Pull off the lamp body while pushing the lever as the arrow shows. Pull Screw Bottom of the lamp body + + + + + Bulb Bulb Holder Bracket Rubber Pad Slide Lever Gap CAUTION WARNING!! To power outlet Jack Cover 8 to 10 hours Slide NiMH Battery #533-8477 Ni-Cd Battery #533-8478 CHR-145 Battery Charger #533-8496 CHR-105 Battery Charger #533-8491 6V-2.4A Halogen Bulb #533-8060 H-24 Bracket #533-8597 H-24 Bracket & Spacer #533-8598 CO.,LTD. NEVER OVERCHARGE

Transcript of HL_1600Ev1

SPARE PARTS

SPECIFICATIONSBulb: 6V-2.4W Halogen BulbBattery: Ni-Cd / Ni-MHCharger: CAT EYE Battery Charger CHR-105 / 145Operation time: Ni-Cd: ........... 2.5 hours

Ni-MH: ......... 4 hoursAlkaline: ........ 4 hours

Charging time: 8 - 10 hoursTemperature Range: Charging: ...... 0˚C ~ 40˚C

Operating: .... –15˚C ~ 45˚CRecharge/Discharge Number of Times:

More than 500 times (until rated capacity drops to 50%)*The specifications and design are subject to change without notice.

LIMITED WARRANTY1- Year Warranty:Only Lamp Unit And Battery Charger (Excluding bulb and battery)If trouble or damage occurs during normal use, the product will be repaired or replacedfree of charge. Type your name, address, date of purchase and the situation of troubleclearly, and send it back to the appropriate service center together with the product.Insurance, handling and transportation charges shall be borne by the customer. Afterbeing repaired or replaced, the product will be shipped back to the customer.

Address for the service:

2-8-25 Kuwazu, Higashi sumiyoshi-ku, Osaka 546-0041 JAPANAttention: CAT EYE CO., LTD. Customer Service SectionPhone: 81-6-6719-7781 Fax: 81-6-6719-2362Service & Research Center1705 14th St. #115 Boulder, CO 80302Phone: 303-443-4595 Toll Free: 800-5CATEYE(800-522-8393)Fax: 303-473-0006 e-mail: [email protected] site: http://www.cateye.com

Design Pat. PendingCopyright© 1999 CATEYE Co.,Ltd.Printed in Japan HLM16K-990507 0688361 2web

FOR SAFE OPERATIONS (IMPORTANT)• The lamp body becomes extremely hot when turned on. Never touch

the lamp body or lens until thoroughly cooled. Injury may result.

• This lamp kit is not intended for use by young children or infirm

persons without supervision; young children should be supervised

to ensure that they do not play with this appliance.

• Never short-circuit the plug of the battery charger. It may cause the

battery to overheat, resulting in fire or damage of the components.

• Use only the included battery charger for charging.

• Safely dispose of the old battery when it comes to the end of its

useful life.

• Never mix different types of batteries or old / new batteries together.

• Although dry batteries can be used, never recharge them.

• Overcharge may cause the battery trouble.

• Avoid leaving the battery under direct sunlight. It may cause the

battery leak.

• A long period of non-use will lower the voltage of the battery due to

natural self discharge. Always charge the battery before using.

• If the cord of the battery charger or other parts are damaged, it

must only be replaced by the shop where this lamp kit was pur-

chased, because special purpose tools are required.

• The charger may become hot during recharging.

• The charging time may vary depending on the use environment.

• If the battery does not serve the proper run time even after it is fully

charged, it may be at the end of it's useful life. Replace it with a new one.

HOW TO CHARGEIf the batteries are not inserted, please see "How ToReplace The Battery".)When the indicator of the lamp body turnsred, it means the battery voltage is lowered;recharge the battery.The factory-loaded battery is not charged.

Open the jack cover on the bottom of the lamp body and connect it with

the plug of the charger. Plug the charger with the home power outlet.

Use only the provided battery charger.Never recharge dry batteries.Make sure to close the jack cover after charging.

Using CHR-105 ChargerThis charger is only for Ni-Cd batteries. It takes 8-10 hours to be full-

charged. Unplug the charger after charging.

Using CHR-145 ChargerThis charger is for Ni-Cd and Ni-MH batteries. The indicator is on during charg-

ing. When the battery is full-charged, it will start flashing.(It takes 8-10 hours.)

HOW TO REPLACE THE BATTERY AND THE BULBLoosen the screw on the bottom of the lamp body and remove the upper body.

A BatteryInsert the batteries as the picture shows.

Make sure of the correctpolarity.Never mix different types ofbatteries or old / newbatteries together.

B BulbTake out the lens component. Remove the bulbholder and replace the bulb with a new one.Insert the bulb aligning the gap of the claspwith the projection of the lens component.

Do not touch the bulb and thereflective mirror with barefingers.Use only the CAT EYEhalogen bulb.

Rechargeable HeadlampHL-1600KIT

INSTRUCTION MANUAL

CHR-105 Charger

(Only for Ni-Cd batteries)

CHR-145 Charger(Both for Ni-Cdand Ni-MH batteries)

Indicator

Flashing of the indicator meansfull-charged.

HOW TO ATTACH THE BRACKET AND THE LAMP BODY

TO MOUNT: Adjust the bracket using the rubber pad and fix it with the screw.

TO REMOVE: Pull off the lamp body while pushing the lever as the arrow shows.

Pull

Screw

Bottom of the lamp body

+

+–

+ –

+ –

+–

Bulb

Bulb Holder

Bracket

Rubber Pad

Slide Lever

Gap

CA

UTIO

NW

AR

NIN

G!!

To power outletJack Cover

8 to 10 hours

Slide

NiMH Battery #533-8477Ni-Cd Battery #533-8478CHR-145Battery Charger #533-8496CHR-105Battery Charger #533-8491

6V-2.4AHalogen Bulb #533-8060

H-24 Bracket #533-8597

H-24 Bracket & Spacer #533-8598

CO.,LTD.

NEVEROVERCHARGE