Heating Control - Whale · Heating Control Quick Guide. For. Your Swift Basecamp is fitted . with...
6
Heating Control Quick Guide For Your Swift Basecamp is fitted with Whale’s Space Saving Gas and Electric Space and Water Heating The system is easy to control using either the Whale Duo Control Panel or Swift Command app.
Transcript of Heating Control - Whale · Heating Control Quick Guide. For. Your Swift Basecamp is fitted . with...
Heating ControlQuick Guide
For
Your Swift Basecamp is fitted with Whale’s Space SavingGas and Electric Space and
Water Heating
The system is easy to control using either the Whale Duo Control Panel or Swift Command app.
Whale Water Heater
Power Settings available are:
Water Heater will be off
Water Heater will operate at 750W
Water Heater will operate at 1500W
Water Heater will operate on gas
Water Heater will operate on gas & 750W
Water Heater will operate on gas & 1500W
Space Heater
For fast heat up, select:
For night time setting, select:
User Tips
Ref
: cm
cc_p
s_18
1.31
1_v1
_061
6
Space Heater
For low current draw, select or
Water Heater
For fast heat up, select:
For low current draw, select or
Your Whale Heating System is fitted with an electronic diagnostic system which will detect fault conditions ranging from poor gas or d.c. supply to internal heater
malfunctions. In the unlikely event of a failure, the diagnostic LED ‘!’ will light red.
To identify the fault - Press and hold for Space Heater, - Press and hold for Water Heater. The number of bars that light on the temperature gauge indicates
the fault code. (For more information please see your Vehicle Handbook). To clear the fault code turn the d.c. power ‘Off’ and then ‘On’ again at the Master Switch in the vehicle. If this is unsuccessful you must press the red reset button
located on the Space or Water Heater, as shown in your Vehicle Handbook.Wait for the fan to stop before cycling the power to prevent an overheat lockout.
Trouble Shooting
© Whale 2016, all rights reserved. Reproduction in whole or in part is prohibited without permission.WHALE® is a registered trademark of Munster Simms Engineering Ltd, trading as Whale®. Whale’s policy is one of continuous improvement and we reserve the right to change specifications without prior notice. Images are for guidance purposes only.
For help or advice on your Whale Heating System
Please contact us.
Tel: +44 (0)845 217 2933E-mail: [email protected]
WhaleRV
Whale Support
Using Swift Command
To use Swift Command ensure that the Duo Control water and air heat settings are BOTH in the ‘OFF’ position. Then follow instructions on Swift Command.
Phoneline available 7 days a
week
Whale Duo Control Panel
Operating Your Whale Space Heater
To Set the Temperature:
Use or to select desired temperature.
The temperature is shown on the Space Heater temperature gauge by a yellow indicator.
Your Heating System
Space Heating• 2kW Gas and Electric Underfloor Space Heater
• More Internal Living Space - mounted under the vehicle
Whale DuoControl Panel
2kW Space Heater 8 Litre Water Heater
Water Heating• 8 Litre Rapid Heat Water Heater
• Robust Insulation - efficiently retains heat.
• Range of Settings - choose fast heat up or low current draw
Control Panel• Space and water heating controls integrated on one
Control Panel
• Choose from a range of settings:-
- Super efficient - low current draw to conserve your battery power
- High speed - fast heat up
Gas On Space Heater
Function KeySpace HeaterTemperature
Up/Down
Water Heater Function Key
Diagnostics
Space Heater Temperature
Gauge
Space Heater Power Settings
Water Heater Power Settings
Temperature Gauge
MoreSpace
RapidHeat
Easy to
Use
Note: The temperature gauge must be set to a temperature higher than the actual air temperature for the Space Heater to turn on.
To Select Power Settings
Press to select your desired power setting.
Power Settings available are:
Space Heater will be off
Space Heater will operate at 500W
Space Heater will operate at 1000W
Space Heater will operate at 2000W
Space Heater will operate on gas
Frost Protection The Space Heater is fitted with Frost Protection to warm the vehicle and prevent damage to the heating and water systems that may be caused by cold temperatures.
To activate Frost Protection, press until the yellow indicator on the temperature gauge is above the frost protection icon.
Note: Frost protection setting requires a power source to be connected. It will run on electric if mains power is connected, or on gas if mains power is not connected.
To Select Power Settings
Press to select your desired power setting (see overleaf).
Whale Space Heater
Operating Your Whale Water Heater
HEATING
Whale Duo Control Panel
Operating Your Whale Space Heater
To Set the Temperature:
Use or to select desired temperature.
The temperature is shown on the Space Heater temperature gauge by a yellow indicator.
Your Heating System
Space Heating• 2kW Gas and Electric Underfloor Space Heater
• More Internal Living Space - mounted under the vehicle
Whale DuoControl Panel
2kW Space Heater 8 Litre Water Heater
Water Heating• 8 Litre Rapid Heat Water Heater
• Robust Insulation - efficiently retains heat.
• Range of Settings - choose fast heat up or low current draw
Control Panel• Space and water heating controls integrated on one
Control Panel
• Choose from a range of settings:-
- Super efficient - low current draw to conserve your battery power
- High speed - fast heat up
Gas On Space Heater
Function KeySpace HeaterTemperature
Up/Down
Water Heater Function Key
Diagnostics
Space Heater Temperature
Gauge
Space Heater Power Settings
Water Heater Power Settings
Temperature Gauge
MoreSpace
RapidHeat
Easy to
Use
Note: The temperature gauge must be set to a temperature higher than the actual air temperature for the Space Heater to turn on.
To Select Power Settings
Press to select your desired power setting.
Power Settings available are:
Space Heater will be off
Space Heater will operate at 500W
Space Heater will operate at 1000W
Space Heater will operate at 2000W
Space Heater will operate on gas
Frost Protection The Space Heater is fitted with Frost Protection to warm the vehicle and prevent damage to the heating and water systems that may be caused by cold temperatures.
To activate Frost Protection, press until the yellow indicator on the temperature gauge is above the frost protection icon.
Note: Frost protection setting requires a power source to be connected. It will run on electric if mains power is connected, or on gas if mains power is not connected.
To Select Power Settings
Press to select your desired power setting (see overleaf).
Whale Space Heater
Operating Your Whale Water Heater
HEATING
Whale Duo Control Panel
Operating Your Whale Space Heater
To Set the Temperature:
Use or to select desired temperature.
The temperature is shown on the Space Heater temperature gauge by a yellow indicator.
Your Heating System
Space Heating• 2kW Gas and Electric Underfloor Space Heater
• More Internal Living Space - mounted under the vehicle
Whale DuoControl Panel
2kW Space Heater 8 Litre Water Heater
Water Heating• 8 Litre Rapid Heat Water Heater
• Robust Insulation - efficiently retains heat.
• Range of Settings - choose fast heat up or low current draw
Control Panel• Space and water heating controls integrated on one
Control Panel
• Choose from a range of settings:-
- Super efficient - low current draw to conserve your battery power
- High speed - fast heat up
Gas On Space Heater
Function KeySpace HeaterTemperature
Up/Down
Water Heater Function Key
Diagnostics
Space Heater Temperature
Gauge
Space Heater Power Settings
Water Heater Power Settings
Temperature Gauge
MoreSpace
RapidHeat
Easy to
Use
Note: The temperature gauge must be set to a temperature higher than the actual air temperature for the Space Heater to turn on.
To Select Power Settings
Press to select your desired power setting.
Power Settings available are:
Space Heater will be off
Space Heater will operate at 500W
Space Heater will operate at 1000W
Space Heater will operate at 2000W
Space Heater will operate on gas
Frost Protection The Space Heater is fitted with Frost Protection to warm the vehicle and prevent damage to the heating and water systems that may be caused by cold temperatures.
To activate Frost Protection, press until the yellow indicator on the temperature gauge is above the frost protection icon.
Note: Frost protection setting requires a power source to be connected. It will run on electric if mains power is connected, or on gas if mains power is not connected.
To Select Power Settings
Press to select your desired power setting (see overleaf).
Whale Space Heater
Operating Your Whale Water Heater
HEATING
Heating ControlQuick Guide
For
Your Swift Basecamp is fitted with Whale’s Space SavingGas and Electric Space and
Water Heating
The system is easy to control using either the Whale Duo Control Panel or Swift Command app.
Whale Water Heater
Power Settings available are:
Water Heater will be off
Water Heater will operate at 750W
Water Heater will operate at 1500W
Water Heater will operate on gas
Water Heater will operate on gas & 750W
Water Heater will operate on gas & 1500W
Space Heater
For fast heat up, select:
For night time setting, select:
User Tips
Ref
: cm
cc_p
s_18
1.31
1_v1
_061
6
Space Heater
For low current draw, select or
Water Heater
For fast heat up, select:
For low current draw, select or
Your Whale Heating System is fitted with an electronic diagnostic system which will detect fault conditions ranging from poor gas or d.c. supply to internal heater
malfunctions. In the unlikely event of a failure, the diagnostic LED ‘!’ will light red.
To identify the fault - Press and hold for Space Heater, - Press and hold for Water Heater. The number of bars that light on the temperature gauge indicates
the fault code. (For more information please see your Vehicle Handbook). To clear the fault code turn the d.c. power ‘Off’ and then ‘On’ again at the Master Switch in the vehicle. If this is unsuccessful you must press the red reset button
located on the Space or Water Heater, as shown in your Vehicle Handbook.Wait for the fan to stop before cycling the power to prevent an overheat lockout.
Trouble Shooting
© Whale 2016, all rights reserved. Reproduction in whole or in part is prohibited without permission.WHALE® is a registered trademark of Munster Simms Engineering Ltd, trading as Whale®. Whale’s policy is one of continuous improvement and we reserve the right to change specifications without prior notice. Images are for guidance purposes only.
For help or advice on your Whale Heating System
Please contact us.
Tel: +44 (0)845 217 2933E-mail: [email protected]
WhaleRV
Whale Support
Using Swift Command
To use Swift Command ensure that the Duo Control water and air heat settings are BOTH in the ‘OFF’ position. Then follow instructions on Swift Command.
Phoneline available 7 days a
week
Heating ControlQuick Guide
For
Your Swift Basecamp is fitted with Whale’s Space SavingGas and Electric Space and
Water Heating
The system is easy to control using either the Whale Duo Control Panel or Swift Command app.
Whale Water Heater
Power Settings available are:
Water Heater will be off
Water Heater will operate at 750W
Water Heater will operate at 1500W
Water Heater will operate on gas
Water Heater will operate on gas & 750W
Water Heater will operate on gas & 1500W
Space Heater
For fast heat up, select:
For night time setting, select:
User Tips
Ref
: cm
cc_p
s_18
1.31
1_v1
_061
6
Space Heater
For low current draw, select or
Water Heater
For fast heat up, select:
For low current draw, select or
Your Whale Heating System is fitted with an electronic diagnostic system which will detect fault conditions ranging from poor gas or d.c. supply to internal heater
malfunctions. In the unlikely event of a failure, the diagnostic LED ‘!’ will light red.
To identify the fault - Press and hold for Space Heater, - Press and hold for Water Heater. The number of bars that light on the temperature gauge indicates
the fault code. (For more information please see your Vehicle Handbook). To clear the fault code turn the d.c. power ‘Off’ and then ‘On’ again at the Master Switch in the vehicle. If this is unsuccessful you must press the red reset button
located on the Space or Water Heater, as shown in your Vehicle Handbook.Wait for the fan to stop before cycling the power to prevent an overheat lockout.
Trouble Shooting
© Whale 2016, all rights reserved. Reproduction in whole or in part is prohibited without permission.WHALE® is a registered trademark of Munster Simms Engineering Ltd, trading as Whale®. Whale’s policy is one of continuous improvement and we reserve the right to change specifications without prior notice. Images are for guidance purposes only.
For help or advice on your Whale Heating System
Please contact us.
Tel: +44 (0)845 217 2933E-mail: [email protected]
WhaleRV
Whale Support
Using Swift Command
To use Swift Command ensure that the Duo Control water and air heat settings are BOTH in the ‘OFF’ position. Then follow instructions on Swift Command.
Phoneline available 7 days a
week
