Hard Disk القرص الصلب
-
Upload
kieran-shaffer -
Category
Documents
-
view
30 -
download
0
description
Transcript of Hard Disk القرص الصلب
1
Hard Disk الصلب القرص
2
Construction of the Hard Disk
3
Tracks and Sectors
4
The Difference Between Tracks and Cylinders
5
Platter SizeA platter from a 5.25" hard disk, with a platterfrom a 3.5" hard disk placed on top of it forcomparison. The quarter is included for scale (andstrangely, fits right in the spindle hole for bothplatters... isn't that a strange coincidence ?
6
Hard Disk Operational Overview
7
Platter Diameter
Typical Form FactorApplication
5.125.25"Oldest PCs, used in servers through the mid-1990s and some retail drives in the mid-to-late 1990s;
now obsolete
3.743.5"Standard platter size for the most common hard disk
drives used in PCs
3.03.5"High-end 10,000 RPM drives
2.52.5 ,"3.5"Laptop drives (2.5" form factor); 15,000 RPM drives
(3.5" form factor)
1.8PC Card (PCMCIA)PC Card (PCMCIA) drives for laptops
1.3PC Card (PCMCIA)Originally used on hand-held PCs (no longer made)
1.0CompactFlashDigital cameras, hand-held PCs and other consumer
electronic devices
8
Read/Write Heads A pair of mated head sliders with their platter removed.You can see that the tension of the head arms has causedthem to press against
each other .
9
Hard Disk Read/Write Head Technologies
10
القرص سطح
This illustration gives you some idea of just how small the flyingheight of a modern hard disk is (and today's hard disks have
flying heights significantly lower than 3-7 millionths of an inch !
11
Hard Disk Head Sliders, Arms and Actuator
12
Hard Disk Connectors and Jumpers
Some of the connectors and jumper pins on a3.5", 36 GB, 10,000 RPM SCSI Cheetah
drive .
13
Connectors Types
•IDE Connectors
•SCSI Connectors
•SATA Connectors
14
IDE Connectors
15
SATA Connectors
16
SCSI Connectors
17
Data Interface Connector
A standard hard disk IDE/ATA data interface connector.If you look closely you can see markings for pins #1, #2, #39 and #40.A 50-pin SCSI interface connector looks identical except that ithas 25 columns of pins instead of 20 (they look so much alike thatgetting the two mixed up is common). A 68-pin SCSI interface
connector is pictured on the parent page of this page
18
IDE/ATA Configuration Jumpers
Jumper block for an IDE hard disk.The jumpers are labeled "MA" (master),"SL" (slave) and "CS" (cable select). OtherIDE drives will have slightly differentjumper configuration or
placement .
19
Jumpers
20
Hard Disk Logic Board
22
Cache SizeThe cache chip from a Seagate Barracuda hard disklogic board. This chip is the entire cache: it's a 4 Mib chip,which is 512 kiB, the size of the cache on this drive. Somecaches use more than one chip, especially the larger
ones .
23
Removable Hard Disk Trays