GoBe2 Instructions BW - Mindtec Store · 2020. 7. 15. · WARNING: HEALBE Products contain small...

6
FCC STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Effective: November «26», 2016 This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These Limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions. may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation lf this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna • lncrease the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. CAUTION DO NOT ATTEMPT TO CHANGE OR REPLACE THE BATTERY Risk of explosion if battery is replaced by an incorrect type Battery: 350mAh. Charging voltage: Sv. Correct Disposal of this product. This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal. recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. Goß Product Guide FCC 2ADSYRF07HB2 © 2017 Healbe Corporation

Transcript of GoBe2 Instructions BW - Mindtec Store · 2020. 7. 15. · WARNING: HEALBE Products contain small...

  • FCC STATEMENT

    This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

    Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

    Effective: November «26», 2016

    This equipment has been tested and found to comply with the limits for a Class

    B digital device, pursuant to Part 15 of the FCC Rules. These Limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions. may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation

    lf this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

    • Reorient or relocate the receiving antenna

    • lncrease the separation between the equipment and receiver.

    • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

    CAUTION

    DO NOT ATTEMPT TO CHANGE OR REPLACE THE BATTERY

    Risk of explosion if battery is replaced by an incorrect type

    Battery: 350mAh.

    Charging voltage: Sv.

    Correct Disposal of this product. This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal. recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased.

    Goß Product Guide

    FCC 2ADSYRF07HB2

    © 2017 Healbe Corporation

  • WARNING: BEFORE USING THIS PRODUCT,

    PLEASE REVIEW THE FOLLOWING IMPORTANT

    SAFETY,

    BATTERY,

    WARRANTY, AND REGULATORY

    IN FORMATION

    Failur e to observ e the following warnings may result in harm either to you or damage to HEALBE GaBe® 2 by Healbe Corporation ('HEALBE') and associated

    pr oducts and mobile applications (collectiv e ly, 'HEALBE Pr oducts") and will void the be low warranty an HEALBE Products. Please note that additional information is provided an www.healbe.com and it is your so le responsibilily to review all important information before using HEALBE Products. Your purchase and use of HEALBE Products implies that y ou have r ead and accep ted the terms and conditions both stated in this document and available online at www. healbe.com.

    GENERAL INSTRUCTIONS

    IMPORTANT: Please see included user manual and www. healbe.com/start for additional information. STEP 1

    . Remove the HEALBE GoB e® 2 ("GoBe") from the box. Remove and dispose

    of the sticker covering the sensor. located on the lback sidel of the device. STEP 2

    . Charge GoBe fully using the enclosed HEALBE charging pad (allow

    approximately one hour for the first time). To do this. inserl GoBe into the charging pad, making sure to line up the metal pins on the charging pad with GoBe's pinhales (located on the backside af the device) and wait for the light to flash red an the back side of the charging pad. When the battery is full , the light on the back side of the charging pad will became blue. STEP 3

    . Push and hold the button an the side af the device for 3 seconds to turn

    an the device. Gose will vibrate and the display will light up with the ward "SVNC"

    and animation.

    This signals that yaur initial device activation is comp lete. In the future, your device will greet you with the word 'HELLO"

    STEP 4. lf you have not already done so , download the HEALBE GoBe mobile application. Once down loaded, open up it to synchronize your device with your smartphone. Fellow the instructions in the app. STEP S

    . Fasten the GoBe band onto your wrist in a tight but comfortable position

    STEP 6.

    You are done ! You can now use your GoBe device l

    For more infor mation and to access the comp lete manual. please visit www. healbe. com/manual.

    Normal use of the HEALBE Products is defined as: use in accordance with the associated GoBe mobi le applications for the purpose of exercising with GoBe. use in non-extreme temperature settings (avoid exposure t o temperatures below minus tw enly (20) degrees Ce lsius (minus four (4) degrees Fah renheit) or above fifty (SO) deg rees Celsius (one hundred twenty-two (122) deg rees Fahrenheit), and ca reful handling (avoid dropping the GoBe device and Umit its exposu re to repeated shock). GoBe is rated waterproof,

    IT 15 RECOMMENDED THAT YOU CLEAN THE DEVICE PROPERLY BEFORE EACH AND EVERY USE. GoBe is intended to be warn for lang. exlended periods of time. Avoid getting dirt and personal care substances such as but not limited to soap, Lotion. and creams trapped between the GoBe band and your body as this may lead to discomfort. Oo not pul GoBe in any washing device such as. but not limited to. a washing machine. dishwasher. or any other machine that will submerge Goße in liquid substances and expose it to high water pressure for extended periods of time.

    DISCLAIMER AND SAFETY NOTICES

    DISCLAIMER: P lease note that while GoBe bracelets are designed to provide you with information of your body's conditian and physical state change trends, GoBe is not designed to be used as a medical device and should not be used ta diagnose, treat, eure, or prevent any disease, or as a substitute for medical expert advice. The accuracy of GoBe's measurements (including incoming and burned calories, steps count and distance walked, energy balance, sleep quality, stress Level and heart-rate) depend on the accuracy of the personal data that you input into your profi le section and on your use of GoBe in accordance with our use guidelines. Healbe recommends that you always seek the advice of a physician or other qualified health expert with any questions you may have regarding a health condition, diet. or physical fitness program.

    WARNING: Always seek the advice of a qualified medical professional before making changes to exe rcise. sleep or nutrition, as making such changes may cause severe harm or death. GoBe IS NOTA MEDICAL DEVICE. HEALBE Products should not be used to diagnose. treat. or prevent any disease, medical condition. or i njuries.

    WARNING: HEALBE Products use TPU and aluminium oxidation with laser engraving on the wrist button (in the band). ABS„ PC-plastic (in the device). Stainless steel with TiN coating (in electrodes). Do not wear HEALBE Products if you are allergic to any of these materials.

    WARNING: For your safety, only use GoBe's included charging pad and cable. Never attempt to charge Goße with another charging device.

    WARNING: HEALBE Products contain small parts which may constitute

    a choking hazard. At all times keep HEALBE Products and any of its parts and/or accessories away from small children. DO NOT pul Go Be and its associated parts in your mouth at any time.

    WARNING: When using HEALBE Products. at all times remain aware of your surroundings and be attenlive to potentially unforeseen obstacles. Oo not become distracted while using HEALBE Producls. Ensure that the volume on the mobile device used with GoBe is not raised to such a Level that it blocks out your surroundings or damages your hearing.

    i