Bidet life Let’s LEBI Non-electric bidet LEBI Introduction VISION-GROUP Co., Ltd.
GLORIA SINGLE LEVER BIDET FAUCET W/ 1¼ POP-UP WASTE...
1
SPECIFICATIONS OPERATING CONDITIONS MAINTENANCE Always wipe chrome plated area with dry soft cloth, and sometimes wipe it with cloth soaked in mild soap. TROUBLESHOOTING INSTALLATION 1. AERATOR 3. BOLT "GLORIA" SINGLE LEVER BIDET FAUCET W/ 1¼" POP-UP WASTE TX301BG S06616S 2. CONNECTING NUT CHECK POINT Flow rate unsatisfactory 1 Remove and clean Water leaks around the handle 2 Tighten Handle is loose 3 Tighten Plug cannot open and close 4 Tighten PROBLEM SOLUTION 4.BOLT TX301BGC "GLORIA" Ceramic Single Lever Bidet Faucet w/ 1¼" Pop-Up Waste TX301BG "GLORIA" Single Lever Bidet Faucet w/ 1¼" Pop-Up Waste 160 max.30 421 82 40° 129 160 max.30 421 82 40° 129 Setting Bolt Washer Setting Nut Packing Faucet Lift Rod 1. Water supply pressure : 0.05 ~ 0.75MPa Ensure that water supply is clean ( No Sand, Dirt, Etc.). 1. 2. ATTENTION Use of abrasive cleaning material such as; detergents containing hydrochloric acids, thinner, polishing powder, and nylon brush is not recommended R3 C H To Cold Water Supply To Hot Water Supply 2. 3. Plug Siphon Packing Triangle Packing Nut Pivot Rod Packing Bolt Kick Box Bolt Pop-Up Clip Washer Ø35 Hole
Transcript of GLORIA SINGLE LEVER BIDET FAUCET W/ 1¼ POP-UP WASTE...
SPECIFICATIONS
OPERATING CONDITIONS
MAINTENANCEAlways wipe chrome plated area with dry soft cloth, and sometimes wipe it with cloth soaked in mild soap.
TROUBLESHOOTINGINSTALLATION
1. AERATOR
3. BOLT
"GLORIA" SINGLE LEVER BIDET FAUCET W/ 1¼" POP-UP WASTE TX301BG
S06616S
2. CONNECTING NUT
CHECKPOINT
Flow rate unsatisfactory 1 Remove and cleanWater leaks around the handle 2 TightenHandle is loose 3 TightenPlug cannot open and close 4 Tighten
PROBLEM SOLUTION
4.BOLTTX301BGC
"GLORIA" Ceramic Single Lever Bidet Faucet w/ 1¼" Pop-Up Waste
TX301BG"GLORIA" Single Lever Bidet Faucet w/ 1¼" Pop-Up Waste
160
max
.30
421
82
40°
129
160
max
.30
421
82
40°
129
Setting BoltWasher
Setting Nut
Packing
Faucet
Lift Rod1.
Water supply pressure : 0.05 ~ 0.75MPaEnsure that water supply is clean ( No Sand, Dirt, Etc.).
1.2. ATTENTION
Use of abrasive cleaning material such as; detergents containing hydrochloric acids, thinner, polishing powder, and nylon brush is not recommended
R3
C
H
To Cold Water Supply
To HotWater Supply
2.
3.
Plug
Siphon
PackingTriangle Packing
Nut
Pivot RodPacking
Bolt
Kick Box
Bolt
Pop-Up Clip
Washer
Ø35 Hole
