G-LBPI1047EN.009 hybrid selfCheck™ 1000
Transcript of G-LBPI1047EN.009 hybrid selfCheck™ 1000
G-LBPI1047EN.009
hybrid selfCheck™ 1000 pre-installation guide
www.bibliotheca.com | 2
Copyrights & Trademarks
Copyright © bibliotheca 1999-2017, all rights reserved. The bibliotheca name and device is a
registered trademark of bibliotheca.
bibliotheca provides this document to customers and prospective customers only. The content
of this document is strictly confidential and may not to be reproduced in any form or
transferred by any means, in whole or in part, to any third party without the explicit and prior
written consent of bibliotheca.
All product names presented with the TM symbol within this document are trademarks of
bibliotheca and may not be used without the express written permission. Windows is a
registered trademark of the Microsoft Corporation in the United States and other countries.
Terms & Conventions
Text boxes containing an orange circle and white “i” contain important
information pertaining to the use or configuration of the product. These may also
contain tips or recommendations from Bibliotheca or Bibliotheca customers.
Text boxes containing a red triangle and exclamation point contain either
information critical to the successful use or configuration of the product, or a
warning. It is important to read and consider the information presented in the
hazard text boxes carefully.
Text boxes containing a blue square and question mark contain a definition or
explanation of a specific term or concept that may not be immediately
apparent or common knowledge to all users. The information in these text boxes
should assist the reader’s understanding of this document’s content.
Clickable/Writeable Fields – Bold Text denotes a button, tab, text field, or menu that a user can
select or otherwise interact with.
Location/Reference – Italic text denotes the location of a file or folder on a computer, or a
specific section within the document or reference to a separate document
www.bibliotheca.com | 3
Table of Contents
1 Introducing hybrid selfCheck™ 1000 ....................................................................................................................... 4
1.1 Key attributes ........................................................................................................................................................ 4
1.2 Controls and connections .................................................................................................................................. 5
1.1 Operating system ................................................................................................................................................. 6
1.2 Software welcome screen ................................................................................................................................. 6
2 Site requirements ......................................................................................................................................................... 7
2.1 Dimensions and weights ..................................................................................................................................... 7
hybrid selfCheck™ 1000 standalone .................................................................................................... 7
hybrid selfCheck™ 1000 height adjustable.......................................................................................... 8
hybrid selfCheck™ 1000 desktop .......................................................................................................... 9
2.2 Electrical requirements ....................................................................................................................................... 9
2.3 Network requirements ....................................................................................................................................... 10
2.4 Environmental requirements ............................................................................................................................ 10
2.5 Location ............................................................................................................................................................... 11
Location requirements – Standalone and Height adjustable versions ............................................ 11
Location requirements – Desktop version .......................................................................................... 12
Required Clearances – Metal and RFID equipment ......................................................................... 15
2.6 Item capacity and dimensions ....................................................................................................................... 15
2.7 Smartcard requirements ................................................................................................................................... 16
Supported smartcard types ................................................................................................................. 17
2.8 Payment .............................................................................................................................................................. 18
Note and Coin payments .................................................................................................................... 18
Card payments ..................................................................................................................................... 18
2.9 Supported bibliotheca software ..................................................................................................................... 18
Contact Bibliotheca Support .......................................................................................................................................... 19
www.bibliotheca.com | 4
1 Introducing hybrid selfCheck™ 1000
1.1 Key attributes
The hybrid selfCheck™ 1000 (standalone and desktop versions) enable library patrons to
easily check out and check in library items. Key features include:
• Ability to process items with both EM and RFID technology,
• Simple and intuitive patron facing software (quickConnect™ selfCheck),
• Modular design allows libraries to pick and choose from a range of additional
options (payment options, item unlocker, shelf and return bin etc.),
• Innovative open V shaped aperture that helps to position items properly for
successful check in and check out transactions,
• Extended barcode scanner placement to better read barcodes on patron cards
and items,
• Clear thermal printed patron receipts,
• Trouble shooting and statistics access from virtually any location (with internet
access),
• Optional cash and card payment devices, including contactless payment.
hybrid selfCheck™ 1000 (Standalone) hybrid selfCheck™ 1000 (Desktop)
www.bibliotheca.com | 5
1.2 Controls and connections
1. Monitor
2. Status LEDs
3. Barcode scanner
4. EM / RFID aperture
5. Contactless payment device
6. Card payment device
7. Thermal receipt printer
8. Note acceptor
9. Coin acceptor
10. Change return slot
www.bibliotheca.com | 6
1.1 Operating system
The hybrid selfCheck™ 1000 kiosk is delivered with the Universal Image and required pre-
requisites preloaded on to the PC. The engineer will need to install the latest version of
quickConnect™ selfcheck software available, and add a licence to enable features.
1.2 Software welcome screen
www.bibliotheca.com | 7
2 Site requirements
2.1 Dimensions and weights
hybrid selfCheck™ 1000 standalone
Height Width Depth Weight
1476mm / 58.1” 745mm / 29.3” 680mm / 26.7” 153.5kg / 338.4 lbs
www.bibliotheca.com | 8
hybrid selfCheck™ 1000 height adjustable
Height Width Depth Weight
1476mm/ 58.1” (min)
1771mm/ 69.7” (max)
745mm / 29.3” 680mm / 26.7” 165.5kg / 364.9 lbs
www.bibliotheca.com | 9
hybrid selfCheck™ 1000 desktop
Height Width Depth Weight
880mm / 34.6” 745mm / 29.3” 680mm / 26.7” 88.5kg / 195.1 lbs
2.2 Electrical requirements
The kiosk requires:
• A mains power outlet,
• Input C13 connector, 110 - 240 VAC input, 130 watts, 50Hz, 240 VAC for European
installs; 110 VAC for North American installs, 5 AMP fuse
www.bibliotheca.com | 10
2.3 Network requirements
The kiosk requires:
• A wired Ethernet outlet,
• Ethernet 10/100 MB/sec,
• A static IP address.
2.4 Environmental requirements
Place the system in a location that meets the following environmental requirements:
• Humidity: 0% to 85% RH, non-condensing
• Operating temperature: 32° F to 104° F (0° C to 40° C)
• Storage temperature: -4° F to 140° F (-20° C to 60° C)
These kiosks should not be used outdoors or in wet or damp environments. IP rating: IP20
www.bibliotheca.com | 11
2.5 Location
Location requirements – Standalone and Height adjustable
versions
The system must be located:
• Within reach of an electrical outlet and network connection,
• No closer than 8 inches (20.3 cm) from any vertical surface to allow proper
ventilation,
• Away from direct sunlight,
• In an area that is easily accessible for disabled patrons, wheelchair users, elderly
patrons and mothers with pushchairs. Ideally, this would be on the ground floor of
the library (where an elevator is not present or accessible), on a flat floor surface.
• The standalone kiosk adheres to all ADA and DDA regulations. This means that all
interactive options on the kiosk are located within the required interactive zone -
(Maximum height (Interactive zone): 48” / 1220 mm, Minimum height (Interactive zone):
15” / 380 mm, and Minimum aisle width between the kiosk and another object (other
bookshelf, wall or furniture): 48” / 1220 mm.
• Placing the kiosk on a raised platform or level may place interactive elements out of
the required ADA and DDA interactive zone and is strongly advised against.
bibliotheca recommends that you locate the kiosk:
• Near an exit, in an area visible to patrons and staff (who can monitor use and offer
assistance),
• In an area with sufficient space for carts and other carrying devices,
www.bibliotheca.com | 12
The standalone hybrid selfCheck™ 1000 kiosk can be fixed to the floor surface.
Location requirements – Desktop version
In addition to the requirements stated in Location Requirements - Standalone, the hybrid
selfCheck™ 1000 desktop must be placed on a table, counter or cabinet supplied by the
library. The table must meet the following requirements:
• Be sturdy enough to support the kiosk (see Desktop kiosk dimensions and weight),
• Be designed so that the kiosk cannot slide or be pushed off the surface,
• Meet ADA / DDA height requirements for tables, counters and cabinets,
o Additionally, take in to account the combined height of the table,
counter or cabinet and the kiosk so that it does not exceed the maximum
height – 596mm (see the Maximum heights for furniture section).
www.bibliotheca.com | 13
Maximum heights for furniture
Please note that the maximum height is not intended as a recommended
height, but as a height that should not be exceeded.
Consult your local authorities to see if they have recommended or required
heights for DDA or ADA compliance before ordering or building any furniture.
As a general rule, the maximum height of furniture should be calculated so that the top of
the desktop kiosk, when placed on the furniture, is at the same height as the top of the
standalone, none height adjustable version of the kiosk. This will ensure that all interactive
elements are located at a convenient height for both disabled and able bodied patrons.
The maximum height of furniture, when using a hybrid selfCheck™ 1000D, is:
• Height of the Standalone version = 1476mm
• Height of the Desktop version = 880mm
• Difference (and maximum furniture height) = 596mm
www.bibliotheca.com | 14
Additional considerations for desktop kiosks
• Where multiple desktop kiosks are being used on the same work surface, ensure that
there is enough space between each kiosk to allow a wheelchair user to easily
manoeuvre.
• To meet ADA side approach requirements, the touchscreen should be located no
further than 15 inches from the front of the counter. This means that the touchscreen
(and any other interactive element) is easily in arms reach to all patrons, including
wheelchair users.
• Consider using height adjustable desks that will allow patrons to quickly change the
height level of the furniture surface. Additionally, there is usually has a level of
clearance under the desk that will allow wheelchair users to get closer to the kiosk.
The hybrid selfCheck™ 1000D kiosk is not designed to be fixed to the table
surface.
www.bibliotheca.com | 15
Required Clearances – Metal and RFID equipment
The RFID antenna used in the hybrid selfCheck™ 1000 kiosk is fully shielded, and, as such, is
designed not to detect RFID items placed underneath or to the side of the aperture read
area.
To ensure optimal performance, the hybrid selfCheck™ 1000 unit should be installed
observing the following clearances from other objects in the library:
• Distance from security pedestals: 8’3” (2.5 metres).
• Metal should not be placed within the aperture of the hybrid selfCheck™ 1000 kiosk
or placed on the glass shelf attached to the device.
• The detection field of the antenna is minimal enough that it will not affect other
kiosks or RFID products within the near vicinity (excluding security pedestals). As there
should be clear working space for patrons on each side of the kiosk, kiosk detection
fields will never overlap or interfere with each other.
2.6 Item capacity and dimensions
• Item capacity – 15 RFID at any one time (if set to RFID only)
If the kiosk is in hybrid mode (RFID and EM), only one item should be processed
at a time.
www.bibliotheca.com | 16
2.7 Smartcard requirements
The information we need to know from the customer in order to configure the smartcard
reader is as follows:
• Smartcard type (Mifare Classic or Mifare DESFire)
For Mifare Classic cards:
• Read key for the sector where the barcode is stored
• Location on the smartcard memory where the barcode is stored
• Format that the barcode is stored in (e.g. ASCII)
For Mifare DESFire cards:
• Type of encryption used (e.g. AES)
• Decryption key for the location where the barcode is stored
• Application ID of the location where the barcode is stored (e.g. 01 01 01)
• File number within the application (e.g 1)
• Offset within the file (e.g. 0)
• Format that the barcode is stored in (e.g. ASCII)
www.bibliotheca.com | 17
Supported smartcard types
Mifare classic SLE55R
Mifare UltraLight Jewel
Mifare DESFire EV1 SLE66CL
Mifare PLUS ST19XR34
Mifare UltraLight C SRI4K
My-d move SRIX4K
My-d proximity SRI512
SLE44R35s SR176
NFC Type 2 and Type 4
www.bibliotheca.com | 18
2.8 Payment
Note and Coin payments
The hybrid selfCheck™ 1000 incorporates the following Note and Coin payment devices:
• Innovative Note Acceptor
• Innovative Note Stacker
• Innovative Note Recycler
• Innovative Coin Hopper
• Comestero Coin Acceptor
Card payments
The card payment section supports a number of devices depending on the entity it’s being
deployed to and whether we already have card payment support available.
The card payment section supports a number of devices depending on the entity it’s being
deployed to and whether we already have card payment support available.
Please contact the Portfolio Manager for more information regarding the card payment
options in your entity.
2.9 Supported bibliotheca software
hybrid selfCheck™ 1000 supports quickConnect™ selfCheck v1.6 and above and
libraryConnect™ client v3.1 or above. For software prerequisites, please refer to the relevant
pre-installation guide and installation guides for the specific software.
www.bibliotheca.com | 19
Contact Bibliotheca Support
Please be ready with your library’s customer number, case number, any applicable error
messages or conditions, and the product version or serial number.
The Americas
+1 877 207 3127 (option 2)
+1 877 207 3127 (option 2)
+55 19 2515 7930
UK and Europe
+32 (0)38 087 148
+45 7027 1008
+33 (0)1 56 24 11 76
+49 7121 9264 115
+39 800 011 060
+31 (0)85 7600 840
+41 41 726 9950
+44 (0)161 498 1150
Asia and Pacific
+61 3 8555 3388
+86 21 51078671
+85 2 3719 8122
+81 3 6273 0159
+82 02 6310 6565
+65 6 9044 270