VMT CSCL Workshop June 2004. VMT CSCL workshop Evaluation & analysis.
Foundations org vmt
-
Upload
vishal-m-tembhare -
Category
Engineering
-
view
14 -
download
0
Transcript of Foundations org vmt
![Page 1: Foundations org vmt](https://reader036.fdocuments.net/reader036/viewer/2022062522/589f12951a28ab226b8b6703/html5/thumbnails/1.jpg)
P.BY: 1) Vishal Tembhare 4) Sarojini
Hatwar 2) Shiva kawale 5) Dipali Rane 3) Madhuri Katre 6) Pramod
Harinkhede
SHRI, L. M. COLLEGE OF POLYTECHNIC, AMGOAN
Seminar On :- Foundation
Civil Engineering(3rd sem.)
HOD(C.E.), Guided By, Mr.P.R. Rawte Mr.R.Daseriya
![Page 2: Foundations org vmt](https://reader036.fdocuments.net/reader036/viewer/2022062522/589f12951a28ab226b8b6703/html5/thumbnails/2.jpg)
INTRODUCTION
Foundation is the part of structure which receives load of the building and transfers it safely in the lower soil strata without any excessive settlements .
Foundation is the lowest part of structure below the ground level which provides the base for structure or building.
![Page 3: Foundations org vmt](https://reader036.fdocuments.net/reader036/viewer/2022062522/589f12951a28ab226b8b6703/html5/thumbnails/3.jpg)
Functions of foundation : 1) To distribute the total load over the larger area.2) To support the structures.3) To increase stability of the structures against various disturbance.4) To prepare a level surface for concreting and masonry work.
![Page 4: Foundations org vmt](https://reader036.fdocuments.net/reader036/viewer/2022062522/589f12951a28ab226b8b6703/html5/thumbnails/4.jpg)
TYPES OF FOUNDATIONS
Shallow foundation
Deep foundation
![Page 5: Foundations org vmt](https://reader036.fdocuments.net/reader036/viewer/2022062522/589f12951a28ab226b8b6703/html5/thumbnails/5.jpg)
SHALLOW FOUNDATION :- A foundation which have depth is equal to its width or less than width are called as shallow foundation.
1) Wall footing 2) Isolated footings 3) Combined footings 4) Inverted arch footings 5) Cantilever footings 6) Grillage footings 7) Raft or Mat foundations
TYPES OF SHALLOW FOUNDATION
![Page 6: Foundations org vmt](https://reader036.fdocuments.net/reader036/viewer/2022062522/589f12951a28ab226b8b6703/html5/thumbnails/6.jpg)
1) Wall footings:- The wall footings are of two varieties i.e. Simple & Stepped. The Simple footing is used under compound wall and light weight structures whereas the stepped footing is used under load bearing structure.
2) Isolated Footings :-
These footings are used to support individual columns. This is most commonly practiced footing.
![Page 7: Foundations org vmt](https://reader036.fdocuments.net/reader036/viewer/2022062522/589f12951a28ab226b8b6703/html5/thumbnails/7.jpg)
3) Combined footings:- a) Rectangular footings :- These footings are provided under two columns where the loads on the columns are equal.
b) Trapezoidal footings :- Trapezoidal footings are provided when two columns unequally loaded.
Rectangular footings
![Page 8: Foundations org vmt](https://reader036.fdocuments.net/reader036/viewer/2022062522/589f12951a28ab226b8b6703/html5/thumbnails/8.jpg)
4) Inverted arch footings:- It is suitable to be used for the construction of bridges , tanks ,underground sewers, and reservoirs. Such type of footings used where the loads is concentrated over the columns and where it is desired to distribute the load over a large area.
5) Cantilever footings:- This type of footing, is used when a column is near the plot boundary and column footing is not permitted to extend beyond plot boundary.
![Page 9: Foundations org vmt](https://reader036.fdocuments.net/reader036/viewer/2022062522/589f12951a28ab226b8b6703/html5/thumbnails/9.jpg)
6) Grillage foundation:- Grillage foundation is used to transmit heavy loads from steel columns to the soil having low bearing capacity. Such foundations are lighter and are found to be economical because it avoids deeper excavations.
7) Raft or Mat foundation:- It is suitable where the ground is soft , clay is marshy having low bearing capacity of soil and subsoil water condition are uncertain.
![Page 10: Foundations org vmt](https://reader036.fdocuments.net/reader036/viewer/2022062522/589f12951a28ab226b8b6703/html5/thumbnails/10.jpg)
DEEP FOUNDATION :- A foundation which have depth is greater than its width is known as deep foundation.
1) Pile foundation:- Piles are classified based on:- (i) Material of construction (ii) Supporting Action (iii) Shape 2) Well foundation:- (a) Caissons:- (i) Open caissons (ii) Box caissons (iii) Pneumatic Caissons
TYPES OF DEEP FOUNDATION
![Page 11: Foundations org vmt](https://reader036.fdocuments.net/reader036/viewer/2022062522/589f12951a28ab226b8b6703/html5/thumbnails/11.jpg)
1) Material of construction :-1. Timber piles:- This pile is made up
of timber. The head of pile is covered by steel cap to avoid shattering of timber in case of hammering.
2. Concrete piles:- Concrete piles are used for deep foundations. These piles are either pre-cast or cast-in- situ piles.
3. Steel piles:- Steel piles are either of rolled steel section or fabricated shape or it may be sheet pile.
PILE FOUNDATION:-
![Page 12: Foundations org vmt](https://reader036.fdocuments.net/reader036/viewer/2022062522/589f12951a28ab226b8b6703/html5/thumbnails/12.jpg)
Steel (H) Piles
![Page 13: Foundations org vmt](https://reader036.fdocuments.net/reader036/viewer/2022062522/589f12951a28ab226b8b6703/html5/thumbnails/13.jpg)
2) Supporting action:-
1. Bearing piles:- When piles transfer load of the building through a soft soil strata to a suitable bearing stratum at greater depths then it is called a bearing pile, in which the pile rests on hard strata at greater depths.
2. Friction piles :- When piles transfer the loads only by means of skin resistance without any end bearing then the piles are called friction piles. No hard strata at end of piles.
![Page 14: Foundations org vmt](https://reader036.fdocuments.net/reader036/viewer/2022062522/589f12951a28ab226b8b6703/html5/thumbnails/14.jpg)
3) Shape:-1.Under-reamed piles:- Under-reamed piles are commonly used in black cotton soils which swell and shrink to a greater extent when in contact with water. This is a bored-in-situ pile provided with one or more spreads or bulbs along its length known as under-reamed piles.
2.Tapered piles :-
These piles are used only to increase the density of sub-soil by driving these piles in the loose soils.
![Page 15: Foundations org vmt](https://reader036.fdocuments.net/reader036/viewer/2022062522/589f12951a28ab226b8b6703/html5/thumbnails/15.jpg)
Advantages of pile foundations :
The cost of excavation is considerably low.
Dewatering is not required.
Length of pile can be easily adjusted as per
requirements
No temporary supports required, as required in
shallow foundations where open excavations
are done.
![Page 16: Foundations org vmt](https://reader036.fdocuments.net/reader036/viewer/2022062522/589f12951a28ab226b8b6703/html5/thumbnails/16.jpg)
2) Well foundation:-
Caissons:-
Caissons is a water tight structure preferably made of wood , steel, R.C.C. , constructed in connection with excavation for the foundation of bridges , piers, in rivers.
Types of caissons:-1. Open Caisson
2. Box caisson
3. Pneumatic caisson
Caisson is a type of well foundation.
![Page 17: Foundations org vmt](https://reader036.fdocuments.net/reader036/viewer/2022062522/589f12951a28ab226b8b6703/html5/thumbnails/17.jpg)
1. Open Caisson :- It is a box type structure which is open at the top and at the bottom. Open caisson are normally used on sandy soil or soft bearing stratum In open caisson , walls are constructed in rein forced cement concrete.
2. Box caisson :-
Box caisson is similar to open caisson, only difference is that it is closed at bottom. The middle portion is filled with sand or gravel and lower portion is filled with concrete.
![Page 18: Foundations org vmt](https://reader036.fdocuments.net/reader036/viewer/2022062522/589f12951a28ab226b8b6703/html5/thumbnails/18.jpg)
3. Pneumatic caisson:-
1) This type of caissons is open at the bottom and close at the top.
2) Pneumatic caisson is specially used at the place where it is not possible to construct the well.
3) It is suitable for the depth of water more than 12 m.
![Page 19: Foundations org vmt](https://reader036.fdocuments.net/reader036/viewer/2022062522/589f12951a28ab226b8b6703/html5/thumbnails/19.jpg)
Conclusion :-
Foundation is the most important part of building structure. Hence it should have good durability , good strength and maintain of quality.
![Page 20: Foundations org vmt](https://reader036.fdocuments.net/reader036/viewer/2022062522/589f12951a28ab226b8b6703/html5/thumbnails/20.jpg)
REFERENCES:-
Mrs. Pooja Pawar (building construction book)
![Page 21: Foundations org vmt](https://reader036.fdocuments.net/reader036/viewer/2022062522/589f12951a28ab226b8b6703/html5/thumbnails/21.jpg)
THANK YOU !