FORD FOCUS ST - MOTOR MOUNTS - Boomba Racing FOCUS ST - MOTOR... · FORD FOCUS ST MOTOR MOUNTS...

2
FORD FOCUS ST MOTOR MOUNTS INSTALLATION MANUAL MATERIALS REQUIRED None 1 Remove plastic vacuum hose from rubber adaptor on the top of valve cover (leave rubber adaptor in place). 1 When lifting the car always use stands to secure the car. 2 Remove the splash pan bottom lip. 3 Remove the splash pan. 4 Remove the exhaust support bracket screws. 5 Remove the exhaust support bracket rear nut. 6 Remove the exhaust support bracket. 7 Remove the motor mount bolts. 8 Remove the wishbone mount bolts. 9 Remove the wishbone rear bolt. 10 Remove the factory torque arm. 11 Install the Boomba motor mount. TOOLS REQUIRED Set of car stands M15 socket wrench M15 box wrench T30 Torx bit M13 socket wrench M13 box wrench 12 Install the Boomba wishbone mount. Hand tighten mounting bolts.

Transcript of FORD FOCUS ST - MOTOR MOUNTS - Boomba Racing FOCUS ST - MOTOR... · FORD FOCUS ST MOTOR MOUNTS...

Page 1: FORD FOCUS ST - MOTOR MOUNTS - Boomba Racing FOCUS ST - MOTOR... · FORD FOCUS ST MOTOR MOUNTS INSTALLATION MANUAL MATERIALS REQUIRED None 1 Remove plastic vacuum hose from rubber

FORD FOCUS ST MOTOR MOUNTS

INSTALLATION MANUAL

MATERIALS REQUIRED

None

1

Remove plastic vacuum hose from rubberadaptor on the top of valve cover (leaverubber adaptor in place).1

When lifting the caralways use stands tosecure the car.

2Remove the splash pan bottom lip.

3

Remove the splash pan.

4

Remove the exhaust support bracketscrews.

5

Remove the exhaust support bracket rearnut.

6

Remove the exhaust support bracket.

7

Remove the motor mount bolts.

8

Remove the wishbone mount bolts.

9

Remove the wishbone rear bolt.

10

Remove the factory torque arm.

11

Install the Boomba motor mount.

TOOLS REQUIRED

Set of car standsM15 socket wrenchM15 box wrench

T30 Torx bitM13 socket wrenchM13 box wrench

12

Install the Boomba wishbone mount.Hand tighten mounting bolts.

Page 2: FORD FOCUS ST - MOTOR MOUNTS - Boomba Racing FOCUS ST - MOTOR... · FORD FOCUS ST MOTOR MOUNTS INSTALLATION MANUAL MATERIALS REQUIRED None 1 Remove plastic vacuum hose from rubber

1Remove plastic vacuum hose from rubberadaptor on the top of valve cover (leaverubber adaptor in place).13Install and tighten the wishbone rear bolt.Tighten the remaining wishbone bolts.

14

Tighten the motor mount bolts.

15

Install the exhaust support bracket.

16

Install the splash pan.

17

Install the splash pan bottom lip.