Filtration. Learning objectives Explain the basic types and mechanisms of filtration Exploit the...
-
Upload
jade-wells -
Category
Documents
-
view
219 -
download
0
Transcript of Filtration. Learning objectives Explain the basic types and mechanisms of filtration Exploit the...
Learning Learning objectivesobjectives
• Explain the basic types and mechanisms of filtration
• Exploit the Darcy’s Law equation in order to solve problems for conventional and constant pressure cake filtration
• Select filtration media and equipment to meet bioproduct processing requirement
IntroductionIntroduction• Filtration is a solid-liquid separation where the
liquid passes through a porous medium to remove fine suspended solids.
• The main objective of filtration is to produce high-quality drinking water (surface water) or high-quality effluent (wastewater) and also for biopharmaceutical products
Figure 1 Schematic diagrams for dead-end or conventional filtration. For dead-end filtration the thickness of the solids buildup increases and the permeate flux decreases with time, ultimately reaching zero.
FiltrationFiltrationFilters use a filter cloth or some porous material along with applied pressure to push smaller particles through the filter, thus separating elements of the solution based on size. Filtration for biological materials is generally completed using batch filtration, rotary drum filtration, or ultrafiltration methods.
Batch Filtration• Usually performed under constant pressure with a pump that moves
the broth or liquor through the filter• Filter cake will build-up as filtration proceeds and resistance to broth
flow will increase• The filter press is the typical industrial version of a batch vacuum
filter, using a plate and frame arrangement• Can be used to remove cells, but does not work particularly well for
animal cell debris or plant seed debris
FiltrationFiltrationRotary Drum Filtration
• Solution is vacuumed upward where it crosses a filter septum removed by a positive displacement pump
• Filter cake is removed after each rotation to give a fresh surface for filtration
• Rotary vacuum filters can be used to efficiently remove mycelia, cells, proteins, and enzymes, though a filter aid or precoat of the septum may be necessary
Ultrafiltration
• Utilizes a membrane to separate particles that are much larger than the solvent used
• Successful removal occurs in the partical size range of 10 solvent molecular diameters to 0.5 μ
Filtration PrinciplesFiltration Principles• When a slurry containing suspended solids flow
against a filter medium by the application of a pressure gradient across the medium, solids begin to build up on the filter medium
• The buildup of solids on the filter medium is called a cake
• This type of filtration is sometimes referred to as “dead-end” filtration”
• Darcy’s law describes the flow of liquid through a porous bed of solids and can be written as follows:
(1)V: volume of filtrate, t: time, A: cross-sectional area of exposed lilter medium, Δp: the pressure drop through the bed of solids (medium plus cake), µ0: the viscosity of the filtrate, R: resistance of the porous bed.
Filtration PrinciplesFiltration Principles• In this case, R is a combination of the resistance Rm of
the filter medium and the resistance Rc of the cake solids:
• It is convenient to write the cake resistance Rc in terms of specific cake resistance α as follows:
• Thus, the resistance increases with the volume filtered• Combining Eq. (1), (2) and (3), we obtain
(2)
(3)
(4)
ρc: mass of dry cake solids per volume of filtrate.
• For the case of zero filtrate at time zero, integration of this equation yields:
• The pressure drop is influence by α, the specific cake resistance
• α can be increased if the cake is compressed• Cakes are typically compressible when cells and other
biological materials are being filtered• The specific resistance of the cake is directly affected
by Δpc, the pressure drops across the cake
Filtration PrinciplesFiltration Principles
(5)
Filtration PrinciplesFiltration Principles
• Studies have shown that the relationship between specific resistance and pressure drop commonly takes the form:
• where α’ and s are empirical constants.• The power s has been called the “cake
compressibility factor” and has been found to range from zero for incompressible cakes such as sand and diatomite to near unity for highly compressible cakes
(6)
Filtration PrinciplesFiltration Principles
Figure 2 Filtration data for Streptomyces griseus broth with Δp = 2.0 bar. The filter medium was of cotton cloth, and diatomaceous earth filter aid was added to the broth. (Data from S. Shirato and S. Esumi, “Filtration of a culture broth of Streptomyces griseus” J. Ferment, Technol. (Japan), vol. 41, p. 87, 1963.);1]
Example 1Example 1Batch Filtration A Buchner funnel 8 cm in diameter is available for testing the filtration of a cell culture suspension, which has a viscosity of 3.0 cp. The data in Table E1 were obtained with a vacuum pressure of 600 mm Hg applied to the Buchner funnel. The cell solids on the filter at the end of filtration were dried and found to weigh14.0 g. Determine the specific cake resistance α and the medium
Resistance Rm. Then estimate how long it would take to obtain 10,000 liters of filtrate from this cell broth on a filter with a surface area of 10 m2 and vacuum pressure of 500 mm Hg.
SolutionAccording to Equation (5), we can plot t/(V/A) versus V/A and
obtain α from the slope and Rm from the intercept. We see that the
data are reasonably close to a straight line.
Example 1Example 1
Figure E1 Plot of batch filtration data for the determination of α and Rm.
Example 1Example 1
A linear regression of the data in this plot gives the
following results (Figure E1):
From these values, we can calculate α and Rm:
This is a typical value of Rm for a large-pore (micrometer-sized) filter.
Example 1Example 1
To determine the time required to obtain 10,000 liters of filtrate using a filter with an area of 10 m2, we must make the assumption that α does not change at the new pressure drop of 500 mm Hg. We use Equation (5) and solve for time:
We calculate the two components of this equation as follows:
and finally
Example 1Example 1
Example 1Example 1Thus, this filter is probably undersized for the
volume to be filtered. In addition, from this
calculation we see that at the end of the filtration,
Therefore, the filter medium is contributing very
little of the resistance to filtration, a typical
situation in a lengthy dead-end filtration.
• For products that are recovered in the filtrate, it is often necessary to wash the filter cake with water or a salt solution to maximize the removal of dissolved product from the cake.
• Frequently, the wash must be done with more than the volume of the liquid in the cake
• This is because some of the product is in stagnant zones of the cake, and transfer into the wash liquid from these zones occurs by diffusion, which takes place at a slower rate than the convective flow of wash through the cake
• Data for the washing of the filter cakes has been correlated by Choudhary and Dahlstrom using the following equation:
Filtration PrinciplesFiltration Principles
(7)
R’: weight fraction of solute remaining in the cake after washing (on the basis that R’ = 1.0 prior to washing), E: percentage wash efficiency, and N: volume of wash liquid per volume of liquid in the unwashed cake.
Filtration PrinciplesFiltration Principles• Assuming that the liquid viscosity and the pressure
drop through the bed solids are the same during the filtration of the solids, the washing rate per cross-sectional area can be found from the filtrate flow rate per unit area given in Equation (4) at the end of the filtration
• Thus, for negligible filter medium resistance for filtrate volume Vf at the end of time tf to form the cake, this
yields (8)
• If Vw is the volume of wash liquid applied in time tw, then
• Using the definition of (dv/dt)V=Vf from Eq. (8), we obtain
• At the end of filtration, the integrated form of the filtration equation (Eq. 5), with Rm neglected, can be written
• Substituting this expression for Vf/A in Eq. (10) and simplifying gives
Filtration PrinciplesFiltration Principles
(9)
(10)
(11)
(12)
• From Eq. (11) and (12), the ration of tw to tf is
• It is helpful to write tw/tf in terms of n, the ration of the volume Vw of wash liquid to the volume Vr of residual liquid in the cake:
• where f is the ratio of Vr to the volume Vf of filtrate at the end of filtration.
• The ratio f can be determined by a material balance
• Thus, for a given cake formation time tf, a plot of wash time tw versus wash ratio n will be a straight line
Filtration PrinciplesFiltration Principles
(13)
(14)
Example 2Example 2Rotary Vacuum Filtration It is desired to filter a cell broth at a rate of 2000 liters/h
on a rotary vacuum filter at a vacuum pressure of 70
kPa. The cycle time for the drum will be 60 s, and the
cake formation time (filtering time) will be 15 s. The broth
to be filtered has a viscosity of 2.0 cp and a cake solids
(dry basis) per volume of filtrate of 10 g/liter. From
laboratory tests,the specific cake resistance has been
determined to be 9 x 10 cm/g. Determine the area
of the filter that is required. The resistance of the filter
medium can be neglected.
Example 2Example 2SolutionWe can use the integrated form of the filtration equation, Equation
(5), with Rm = 0:
We solve for A2 to obtain
In applying this equation, it is helpful to focus on the area of the drum that is submerged, which is where the cake is being formed and where filtrate is being obtained. Thus, A is the area of that part of the drum that is submerged. We can calculate the volume of filtrate that needs to be collected during the cake formation time of 15 s:
We use this volume of filtrate with t = 15 s in the equation for A2 to
obtain
The area A’ of the entire rotary vacuum filter can be calculated
from the cake formation time and the total cycle time as
This is a medium-sized rotary vacuum filter, with possible
dimensions of 1.0 m diameter by 1.0 m long.
Example 2Example 2
Example 3Example 3Washing of a Rotary Vacuum Filter Cake For the filtration in Example 2, it is desired to wash a product antibiotic out of the cake so that only 5% of the antibiotic in the cake is left after washing. We expect the washing efficiency to be 50%. Estimate the washing time per cycle that would be required.
Example 3Example 3SolutionFrom Equation (7) for the washing efficiency of a filter cake
where R’ is the weight fraction of solute remaining in the cake after washing (on the basis of R’ = 1.0 before washing), E is the percentage wash efficiency, and n is the volume of wash liquid per volume of liquid in the unwashed cake. Substituting R’ = 0.05 and E = 50% into this equation gives
From Equation (14), the relationship between the washing time tw, and the cake formation time tf is given by
where f is the ratio of volume Vr of residual liquid in the cake to the volume of filtrate Vf after time tf.
Thus, we need to estimate the volume of residual liquid in the filter
cake to determine tw. At the end of the 15 s cake formation time,
Assuming the cake is 70 wt% water, which is typical for filter
cakes, we find
Thus,
From this result, the estimated washing time is 20% of the cake
formation time.
Example 3Example 3
Filter Media and Filter AidsFilter Media and Filter Aids1. Filter media• The filter media must remove the solids to be filtered
from the slurry and give a clear filtrate• The pores should not become plugged so that the rate
of filtration becomes too slow• The filter medium must allow the filter cake to be
removed easily and cleanly• Some widely used filter media are woven fabrics (e.g.
woven heavy cloth, glass cloth, etc, no leaching of components are allowed, size of particle trapped: 10 μm), metal fabrics or screens (e.g. nickel,copper, etc, good resistance to leachingand corrosion required, size of particle trapped: 5 μm), and rigid porous media (e.g. sintered stainless steel, silica, pocelain, etc)
• For sterile filtration, commonly used are asymmetric membrane filter (cellulose esters or other polymers, pore size: 0.22-0.45 μm)
Filter Media and Filter AidsFilter Media and Filter Aids
• 2.Filter aids• Certain filters aids may be used to aid filtration• Can be either added directly to the feed or applied to the
filtration equipment• These are often diatomaceous earth or kieselguhr and
perlite which is composed primarily of silica. • Also used are wood cellulose and other inert porous solids• Can be use as a precoat before the slurry is filtered to
prevent gelatinous-type solids from plugging the filter medium and also give clearer filtration
• Can also be added to the cake during filtration to increases the porosity of the cake and reduces resistance of the cake during filtration
Types of Filtration EquipmentTypes of Filtration Equipment1. Plate-and-frame filter presses• Consist of plates and frames assembled alternately with a
filter cloth over each side of the plates• The plates have channels cut in them so that clear filtrate
liquid can drain down along each plate• The feed slurry is pumped into the press and flows through
the duct into each of the open frames so that slurry fills the frames
• The filtrate flows through the filter cloth and the solids build up as a cake on the frame side of the cloth
2. Leaf filters• Developed for larger volumes of slurry and more efficient
washing• Each leaf is a hollow wire framework covered by a sack of filter
cloth• The slurry enters the tank and is forced under pressure through
the filter cloth, where the cake deposits on the outside of the leaf
• The wash liquid follows the same path as the slurry. Hence, the washing is more efficient than the through wishing in plate-and-frame filter presses
Types of Filtration EquipmentTypes of Filtration Equipment
3. Continuous rotary filters(a) continuous rotary vacuum-dryer filter• Filters, washes and discharges the cake in continuous,
repeating sequence • covered with a suitable filtering medium• rotates and an automatic valve in the center serves to activate
the filtering, drying, washing, and cake-discharge functions in the cycle
• The filtrate leaves through the axle of the filter(b) continuous rotary disk filter• consist of concentric vertical disks mounted on a horizontal
rotating shaft• operates on the same principle as the vacuum rotary-drum
filter• Each disk is hollow and covered with a filter cloth and is partly
submerged in the slurry• The cake is washed, dried and scraped off when the disk is in
the upper half of its rotation
Types of Filtration EquipmentTypes of Filtration Equipment
Types of Filtration EquipmentTypes of Filtration Equipment(c) continuous rotary horizontal filter• This type is a vacuum filter with the rotating
annular filtering surface divided into sectors• As the horizontal filter rotates, it successively
receives slurry, is washed, is dried and the cake is scraped off