Sub Title

EXHAUSTO Inc in North America

In Atlanta since 1990 25,000 sq.ft. office and

warehouse 86 authorized sales

and service offices in USA and Canada.

Sub Title

The First Fan - 1957

The first chimney fan - a first worldwide and the foundation of EXHAUSTOs existence

Sub Title

A 50-year Old Company

Founded in 1957 300,000+ sq.ft. of

manufacturing and administration

High-tech ISO 9001 certified manufacturing facilities

Sub Title

Certifications

Sub Title

Mechanical Draft Systems

Sub Title

Products RSV Fan

3/16 Cast aluminum housingHinged for easy service and cleaningDirect driveClass H insulated motorMaintenance free482 F Continuous Duty575 F Intermittent DutyUL 378 Draft Equipment

Capacity:

6,000 MBH on CAT I Appliances

10,000 MBH on CAT IV Appliances

Sub Title

Products RSV Fan

The RSV fan can vent all appliance categories with or without barometric dampers

Up to 6,000 - 10,000 MBH High temperature motor

eliminates the need for secondary fan cooling

Simple design with few components reduces the risk of failure and simplifies service

Sub Title

CASI Chimney Automation System

Sub Title

RSIB Power Venter

SS316 constructionRemovable access doorDirect driveClass A insulated motor - eliminates the need for secondary fan coolingMaintenance freeUp to 575 F DutyThe RSIB fan can vent category I, II, III & IV appliancesSimple design with few components reduces the risk of failure and simplifies serviceRSIB is of Type B, Spark Resistant ConstructionUL 378 Draft Equipment

Capacity:

8,000 MBH on CAT I Appliances

15,000 MBH on CAT IV Appliances

Sub Title

RSIF Power Venter

Rated to 400F non-condensing applicationsForward inclined impeller. Statically and dynamicallybalanced.Insulated housing in galvanized steelHinged fan housing easily opens to provide easy access to duct and impellerDirect drive, variable speed, TEFC motor located outside housing for easy access.

Capacity:

1,800 MBH on CAT I Appliances

Sub Title

Modulating Overdraft Damper System

Sub Title

Controls

EBC30 Modulating Pressure Control

Sub Title

Controls EBC30

Features

100% microprocessor based controlPlug-and-Play initialization processIntegrated PDS function with adjustable time delay Intermittent or continuous operation for all fansField-adjustable PID loopPriority Operation functionBearing Cycle functionRotation Check for three-phase fans

Sub Title

Controls

Differential pressure transducerEnsures proper draft before and during appliance operationProbe includedRange: 0.04 to 0.60 W.C.

PDS Proven Draft Switch

Sub Title

Controls

VFD Variable Frequency Drive

Pre-programmed from the factory1 5 HP in 200 Volt Class input1 7.All wiring is done externally conduits and wires are pre-installedQuick-menu for field adjustable ParametersNEMA 1 rating

Sub Title

Products Accessories

SCA Steel Chimney Adapter

Steel chimney adapterUsed as transition between a round stack and the fanMade of 304 stainless steel

Sub Title

Products Accessories

BBF Balancing Baffle

Balancing baffle with flange connectionsFor positive pressure stacksFor balancing pressure drops on systems with multiple appliances

Sub Title

CASV Applications Stack Downsizing

Hazen High School Renton, WA

Soldier Field - Chicago, IL

Sub Title

CASV Applications - Aesthetics

Getty Center Los AngelesRigel San Francisco

MCASMechanical Combustion Air Supply Systems

Sub Title

MCAS Modulating Combustion Air Supply System

Sub Title

MCAS Components SFTA Fan

Fan can be mounted indoors Impeller cast aluminum.Housing in steelDirect drive, variable speed, TEFC motor located outside housing for easy access.Variable Frequency Drive is used on three phase models (VFD should be located inside the building).

Seven Models1,500 30,000 cfm

Sub Title

MCAS Components BESF/BESB Fan

Fan can be mounted indoors or outdoors.Impeller - statically and dynamically balanced.Insulated housing in galvanized steelHinged fan housing easily opens to provide easy access to duct and impellerDirect drive, variable speed, TEFC motor located outside housing for easy access.Variable Frequency Drive is used on three phase models In-door or out-door installations(VFD should be located inside the building).

Seven Models450 5500 cfm

Sub Title

EBC30 Modulating Control

Chimney Automation

System

Modulating Combustion Air Supply

System

Sub Title

SBC Center San Antonio, TX

Two 16 inch ducted combustion air inletsInstead of

Two 10 foot high by 15 foot long Louvers

Sub Title

Lifetime Fitness Savage, MN

Sub Title

Marriott Waterfront Annapolis, MD

One 24 inch ducted combustion air inletInstead of

One 90 ft. louver

MDVSMechanical Dryer Venting Systems

Sub Title

MDVS Mechanical Dryer Venting System

Sub Title

MDVS Components - BESB Fan

ETL Listed to UL705 :"The product (BESB/MDVS)covered by this report is a modulating air exhaust system. The product consists of a box ventilator and a modulating control for permanent installation. Its intended use is exhausting of lint-laden air from single or multiple type I and type II residential and commercial clothes dryers whether electric or gas-fired, exhausting commercial hoods, or for providing make-up air for laundries or mechanical rooms. The box ventilator can be installed indoors or outdoors."

Four Models1200 5500 cfm

Sub Title

MEC 18 Control

Monitor draft in multi-story building exhaust applicationsControls RSV, EFH, BESF and BESBEBC12 functionsUL 508 and CSA C22.2 Standard for Industrial Control Equipment

Sub Title

Kitchen and Dryer Exhaust

Madigral Lofts, MD

Applications

Hotels

Hospitals Fitness Facilities

Sports Arenas

Apartments / Condominiums

Schools

Sub Title

Appliance Categorization

IV

III

II

I

Atmospheric

Fan Assisted(high

efficiency)

Forced Draft

Condensing

Draft Hood

Fan AssistedDraft Diverter

Scotch Marine

NegativePositive

Sub Title

Z223.1-54 (Venting of equipment)

12.1 Minimum Safe Performance

A venting system shall be designed and constructed so as to develop a positive flow adequate to remove flue or vent gases to the outside atmosphere.

12.4.1 Equipment Draft Requirement

A venting system shall satisfy the draft requirement of the equipment in accordance with the manufacturers instructions.

Sub Title

Common Code Violations

(NFPA 54) Z223.1-2006 12.11.9.2 (Venting of Equipment)

(NFPA 54) Z223.1-2006 13.2 (Sizing of Venting Systems)

Sub Title

Common Code Violations

(NFPA 54) Z223 Sizing Tables(NFPA 54) Z223.1-2006 13.2.18 (Sizing of Venting Systems)

3" 4" 5" 6" 7" 8" 9" 10" 12" 14" 16"7" 10" 12" 14" 18" 22" 22" 26" 30" 36" 42"

Sub Title

Mechanical Draft Systems Defined

12.4.3.1 Mechanical draft systems shall be listed and shall be installed in accordance with the terms of their listing and both the appliance and the mechanical draft system manufacturers instructions.

12.4.3.2 Appliances requiring venting shall be permitted to be vented by means of mechanical draft systems of either forced or induced draft design.Exception: Incinerators

12.4.3.5 Where a mechanical draft system is employed, provision shall be made to prevent flow of gas to the main burners when the draft system is not performing so as to satisfy the operating requirements of the equipment for safe performance

Z223.1-2006 Standard for Venting of Equipment

Sub Title

Commercial Laundry Radisson, Orlando, FL

Responsibility

EnvironmentallyfriendlyReduce Emissions

Low Energy

Recyclable Materials

Demand-Controlled

And Still Going Strong...

Reliable2001

2 RSV replaced

Disney Allstar ResortsOrlando, Florida60 RSV installed

1990

The White HouseWashington D.C12 RSV installed

1992

Sample 3

xx RSV installed

2007

Seismological Safe

Eliminates Potential Risks

Eliminates Potential Risks

Seismological Safe

Case:CBS Studio, Hollywood, CABoiler replacement. Must meet air quality requirements and eliminate need for substantial stack work.

Solution:Four condensing boilers installed in a modular system using a single common stack and a CASV system for venting.

Benefits:Simple and Aesthetically pleasingLimited stack work using existing chase

EXHAUSTO Inc in North AmericaThe First Fan - 1957A 50-year Old CompanyCertificationsMechanical Draft SystemsSlide Number 6Slide Number 7CASI Chimney Automation SystemRSIB Power Venter RSIF Power VenterModulating Overdraft Damper SystemControlsControls EBC30ControlsSlide Number 15Slide Number 16Slide Number 17CASV Applications Stack DownsizingCASV Applications - AestheticsMCAS Mechanical Combustion Air Supply SystemsMCAS Modulating Combustion Air Supply SystemMCAS Components SFTA FanMCAS Components BESF/BESB FanE