Where is the nearest fire alarm pull station?

Where is the nearest fire extinguisher? Where are the Emergency exits? Where is the sand bucket? Where are Assembly Point Where is the emergency Plan

procedures/manual? What is your specific role in case of FIRE, In

case of Chemical Spillage, In case of Gas Leakage and emergency equipment shut-off?

Electrical Malfunctions Friction Open Flames Sparks Hot Surfaces Welding work… Compressed Gases (SiH4, O2) Flammable Chemicals/toxic material releases Others Combustible Materials. Work at Height.

2

Types of EmergenciesTypes of Emergencies

Your Manufacturing building may be required to evacuate Your Manufacturing building may be required to evacuate for:for:

FireFire

Hazardous Material(Chemicals & Gases) Hazardous Material(Chemicals & Gases) Spill or Leakage.Spill or Leakage.

Facility or Utility FailureFacility or Utility Failure

3

Notification SystemNotification System

This Instruments or systems to notify the employees and others of a fire & others.

1)Alarm Pull system.

2)Public Address System (PA)

3)Voice:-

Call out Fire,

Shout Fire!!!,

Shout Chemical spillage/leakage!!!, Shout Gas Leakage!!! etc.

A continuous and unobstructed way of exit route.

Egress must be unobstructed and unlocked.

4

Emergency ExitsEmergency Exits• All exits must be clearly visible.

• All exits must be clearly

illuminated

EMERGENCY EXIT

R Remove All Persons In Danger!

A Always Pull The Alarm and Call ERT/POLICE/FIRE STATION and OTHERS EMERGENCY SERVICES.

C Contain The Fire By Closing the Windows and Doors.

E Extinguish the Fire Only if You Are Trained and Confident.

5

Situation Command AuthoritySituation Command Authority

Supervising & overseeing emergency procedures Notifying & coordinating outside emergency services Directing the shutdown of utilities or plant operations, if

necessary.

All employees should have read the Emergency Evacuation and Exit Plan and fully understand it.

The ASSEMBLY POINT should be away from danger. Emergency Evacuation and Exit plan should be review on

periodically by EH&S Deptt. Know the location of your Emergency exits Know the location of the nearest fire alarm pull station and fire

extinguisher and others Emergency Services.

Know the location of the Assembly Point

6

The Occupational Safety and Health Administration (OSHA) requires emergency evacuation plans under 29 CFR 1910.38

IN THE EVENT OF a Fire, Chemical Spillage, Toxic material release, Gas leakage, etc….

Proceed to nearest exit in an orderly fashion, closing doors behind you.

Assemble at the designated Assembly Point. Provide ERT representatives with information about people

still in the building & other information. Never re-enter a building until instructed to by the fire

deptt, or EH&S deptt. DO NOT USE ELEVATORS. Use Stairway. All doors should be checked for People. Procedures for employees who remain after the alarm to perform

critical duties A system for accounting for people after evacuation; Procedures for assisting people with disabilities.

7

8

Practice Drill for Emergency EvacuationPractice Drill for Emergency Evacuation

Practice the Drills as often as necessary to keep employees prepared. After each drill, gather management and employees to Evaluate the effectiveness of the drill.Identify the strengths and weaknesses of your plan & work to improve it.Include outside resources such as Fire & Ambulance when possible.

Stay low if there is smoke in the area. Feel doors before opening - if hot to the touch, find another

avenue. Close doors behind you upon leaving. If trapped in an area, close the door, use available material to pack

under the threshold openings, and call or signal for help.