Electric scooter rear wheel removal

Don’t attempt to remove cables from rear wheel you have to remove side covers 5 or 6 10mm hex bolts this gives you access to the rear axel, cut 2 or 3 cable ties from swinging arm, then search under left hand side and find rubber boot/cover, cut cable tie and pull bundle inside down, disconnect black multi pin plug, maybe two but only one connector, find 3 thick insulated cables pull back protected covers and with 2 8mm spanners undo brass nuts and bolts connection wire now undone, may have to cut further cable tie holding parcel to frame, pull back to metal cable ties on swinging arm and release cable to motor , use 27mm socket undo larger axel nuts, can be removed or left on note spring washers, slacken off and remove bottom calliper bolt 12mm socket pivot calliper up undo 2 10mm hex bolts holding axel locators and wheel should drop down may have to lift back end up to get back out, remove wheel with electric wire attached to get tyre replaced.Reassemble…do above in reverse will need ¾ new cable ties copper slip bolts torque caliper bolts to 15 torque axel locators 15 torque rear Axel nuts to 50 hand tightenm10mm hexagons on plastics.