Tablets for Textbooks in Schools

Tablet computerIs a mobile computer with display, circuitry and battery in a

single unit.Are often equipped with sensors, including cameras,

microphone, accelerometer and touchscreen, with finger or stylus gestures replacing computer mouse and keyboard.

May include physical buttons, e.g., to control basic features such as speaker volume and power and ports for network communications and to charge the battery.

An on-screen, popup virtual keyboard is usually used for typing. Tablets are typically larger than smart phones or personal digital assistants at 7 inches (18 cm) or larger, measured diagonally.

Are typically larger than smart phones or personal digital assistants at 7 inches (18 cm) or larger, measured diagonally.

Tablets for SchoolsThe use of tablets for schools may be difficult considering certain factors.

a) Cost of one tablet for one student is not within budget capability or is beyond the capability of the government. Case in fact one book per one student has not yet been fully met.

b) Books have more durability compared with electronic gadgets due to handling, energy charging, heat and moist.

c) Technical expertise for the learning software is not widely available.

How to Remove Shortcuts in Thumb Drives/Flash Disk

1. Open command prompt by typing on the search bar “cmd” and hit enter.

2. A pop up window will appear.3. Identify what is the drive letter of your flash disk.4. Type the command H: (The H stands for the drive

letter as seen in My Computer)5. Type the command attrib *. -h -s /s /d and press enter.6. Wait for the process to stop and then open the flash

disk by going to the windows folder.7. Delete everything except the unamed folder as this

contains all your files.

How to format using the command prompt

1. Open command prompt by typing on the search bar “cmd” and hit enter.

2. A pop up window will appear3. Identify what is the drive letter of your flash

disk.4. Type in the command format H: (The H

stands for the drive letter as seen in My Computer)

5. Wait for the whole process to finish

How to recover files in flash disks1. Download the software RECUVA.2. Install RECUVA into your PC or laptop3. After installing run RECUVA and follow the

instructions provided on screen.4. The process normally takes 10 minutes and

the destination folder is provided by the user. This is where all the recovered files are sent.

Disclaimer: This has a 50/50 chances