Duvet Cover Instructions...FOR DUVET TOP (based on 42” width fabric) Twin 5.5 yards Full 5.5 yards...
Transcript of Duvet Cover Instructions...FOR DUVET TOP (based on 42” width fabric) Twin 5.5 yards Full 5.5 yards...
E A S Y T O M A K E
CUSTOM DUVET COVER
COMMON COMFORTER SIZES
Twin 66 x 90"
Full 76 x 90"
Queen 90 x 94"
King 104 x 94"
COMMON FLAT SHEET SIZE
Twin 66 x 96"
Full 81 x 96"
Queen 90 x 102"
King 108 x 102"
FABRIC ORDER
FOR DUVET TOP
(based on 42” width fabric)
Twin 5.5 yards
Full 5.5 yards
Queen 9 yards
King 9 yards
FOR DUVET TOP PANELFABRIC MEASUREMENTS
WIDTH OF SHEET (after washing)add seam allowance + 4 inchesTOTAL =
MINUS width of fabric — equals = divided by 2 % 2width of side panels =
twin top sheet92”
fold end 1 inch and fold again 1 inch
(2 total) then press
sew top edge of
fold
measure & trim at 92 inches long
trim excess edge from printed fabric then cut 2 panels
93 inches long
93”
printed fabric
width of sheet + 4”
trim one panel into two thin strips so that all
three measure width of sheet plus 4 inches
sew side panels onto center panel using
1/2 inch seam
press seams open
fold edge half inch twice for a roll hem and sew
around three edges leaving bottom open
fold bottom edge one inch twice and press
cut 1.5 inch stips of thin elastic, tuck
ends between fold and pin into place
sew edge of fold
securing loops
pin sheet and printed fabric panels together on three sides, right sides facing in
with fabric pencil mark 2 and 8 inches down
from top corners
pin 20 inch strips of cotton ribbon
under top corners
66x89
stitch from top left mark, to top corner, across
top and down to right mark.
stitch down from 8 inch mark, to bottom corner, turn and stop
at panel seam. repeat second side
angle trim excess fabric from
corners
turn right side out
and press all seams
on sheet bottom edge, sew on three buttons to match
placement of loops