DSL 305 Series ADSL Modem. Types of DSL305 series DSL305E ADSL Modem PPP Half-Bridge (Default) ...
-
Upload
rodney-payne -
Category
Documents
-
view
246 -
download
4
Transcript of DSL 305 Series ADSL Modem. Types of DSL305 series DSL305E ADSL Modem PPP Half-Bridge (Default) ...
Types of DSL305 series
DSL305E ADSL Modem
PPP Half-Bridge (Default) Transparent Bridge
DSL305EU ADSL Router/Modem
DSL305 Series
Conexant Chipsets (CX82310) Web interface managementSmartURL commands for DSL305E (DSL305EU later)Firmware upgradeableUSB and Ethernet Interface
DSL305E/EU physical appearance
Eth/Act – Ethernet connection status. ‘On’ – Ethernet connection good ‘Off’ – Ethernet connection bad
‘Blinking’ – DSL Activity
DSL – DSL connection status ‘On’ – Connected to ATM ‘Blinking’- Training with ATM
Power – Power status ‘On’ – Power good ‘Off’ – No power, power off
USB – USB connection status. For DSL305EU ‘On’ – USB connection good ‘Off’ – USB connection bad
DSL305E/EU physical appearance
Line – DSL live line connect here (RJ11)
Reset – Hard reset button
Ethernet – Ethernet cable connect here (RJ45)
DC IN - Power connect here (12 Vdc)
USB – USB connector connect here
Firmware Code Guide:Ex: aa.bb.ccaa – product type. 20 for DSL305E, 21 for DSL305EUbb – customer code. 20 for PacNet, 6 for SingNetcc – firmware revision
DSL305E Screen Shots
Generic Firmware:Current V20.2.2
Customize Firmware:SingNet Current V20.6.4PacNet Current V20.20.3
DSL305E Screen Shots
Connection Status•PPP connection status to ISP•Information on packets status
ADSL / WAN Status•ADSL Line connection status•WAN IP address•Subnet Address•Mac Address•PVC values•Protocol and Encapsulation Mode
DSL305E Screen Shots
Diagnostics Test (for SingNet and PacNet)•PC to Modem Interface Test•Modem Test•Modem to telephone Line Connection Test•Connection to Service Provider Network Test
Firmware upgrade•Firmware version•Upload firmware
SmartURL commands (DSL305E)
startmodem / login – To go to the ‘Quick Start’ page.Logout – To log out of ISPppp – To go to ‘Connection Status’ page.diagnostics – To go to ‘Diagnostic Test’ page.syslog – To go to ‘System Log’ page.connectrouter – To set the modem to transparent bridge mode. Once
in this mode, you will not able to log in to the modem. Hard reset the modem to set it back to default factory mode.
IP address of Modem : 10.0.0.2
Multi-user Mode for DSL305E
Use ‘connectrouter’ SmartURL command to set modem to transparent bridge mode.Theoretically, we can connect DSL305E (in transparent bridge mode) to a broadband router.
Note: User need to hard rest the modem to get back to single user mode
Pros and Cons of DSL305ECONS
Slow to connect to ISP. Take about 50sec to 60sec to get connected. The cause is due to the half-bridge mode of this modem. The modem will take some time to transfer the WAN IP address to the PC.
Need external power source.Pros
No driver is needed. Ethernet interface.
Differences between SingNet and PacNet firmware.
SingNet (Stock Code : 812-D64101-A41 ) User ID and Password will be saved in memory when
logout. SingNet DSL Test : Connection to Service Provider Network
Test will pass even user is not connected to ISP.
PacNet (Stock Code : 812-D64011-A41) User ID and Password will not be saved in memory when
logout. PacNet DSL Test : Connection to Service Provider Network
Test will not pass when user is not connected to ISP.
Q&A for DSL305EQ: Can’t used SmartURL command.A: SmartURL uses DNS methodology. Check if there are
two network cards. Check the DNS server. See below figure.
Must be *.Hasbani.com to work
Q&A for DSL305EQ: Cannot Surf the Internet even connected to ISP.A: Check proxy is turn off. Make sure proxy is off.
Q: Ethernet light is on but I can’t log in to the modemA: Check if the NIC is assign to Obtain an IP automatically.
Q: Ethernet light is not on even cable is plug in.A: Check the type of cable used. Should be straight if
connect to PC. Check driver of the NIC is properly installed.
DSL305EU Screen Shots
LoginAdministrator mode:User Name: adminPassword: epicrouter
User mode:User Name: userPassword: password
Key in 10.0.0.2 in the web browser address field to login to DSL305EU
Configure DSL305EU
Enter Username and password under PPP section
Click Submit to save data to memory.
You need to click Save configuration and reboot the router for changes to take effect.
DSL305EU Characteristic Multiple PVCProtocol / Encapsulation selectionDHCP ServerNAT / NAPTVirtual Server / Bridge FilteringDNS ConfigurationWAN side HTTP serverFTP/TFTP ServerDMZIGMPPPP Half BridgePPP reconnect on WAN access Disconnect TimeoutAutomatic Reconnection selectionSimultaneous USB and Ethernet operation.
Know Issues for DSL305EU
Microsoft Messenger and mIRC could not sent files to other parties in Router Mode. The cause is due to the NAT. Most router reviewed in the Internet has also this problem.Not all VPNs supported. (have to check with Conexant)Log in name can only be admin and user.To send or received files for ICQ, need to turn on the firewall option in the ICQ client.
Q&A for DSL305EUThe common Q&As are the same as DSL305E please refer to the section “Q&A for DSL305E”If you have any enquiry or question, please drop a mail or call Chee Soon. [email protected] or ext 556